Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 75
Search took 0.13 seconds.
Search: Keyword(s): ; Posts Made By: K7MDL
Forum: JK General Discussion Forum 08-08-2014, 06:22 AM
Replies: 21
Views: 3,192
Posted By K7MDL
I had similar symptoms with 1st to 2nd shift, my...

I had similar symptoms with 1st to 2nd shift, my RPM briefly spiked on the shift and then locked up hard resulting a definite lurch. Got worse over a month from subtle to anticipating it by backing...
Forum: JK General Discussion Forum 01-15-2014, 12:48 PM
Replies: 7
Views: 412
Posted By K7MDL
On my 2013 the factory defaults are warn<=28psi,...

On my 2013 the factory defaults are warn<=28psi, reset=>32psi. I have found it to be very accurate and reliable in the last 21K miles/18 months.

With my 33" BFG A/T 10 ply tires I like to...
Forum: JK General Discussion Forum 12-04-2013, 03:09 PM
Replies: 72
Views: 8,537
Posted By K7MDL
Took mine in this week, now waiting for...

Took mine in this week, now waiting for replacement parts which are allocated (thus ordered) to where needed.

In the same visit I am also due for an automatic transmission swap. My 1st to 2nd gear...
Forum: JK General Discussion Forum 06-21-2013, 05:46 PM
Replies: 27
Views: 2,579
Posted By K7MDL
For around town where service can reach you if...

For around town where service can reach you if needed I can see. For out in the boonies, 2 out of 2 flats were long slices from sharp rocks on forest roads, could not plug them (I tried though). I...
Forum: JK General Discussion Forum 06-21-2013, 01:28 PM
Replies: 15
Views: 664
Posted By K7MDL
After bolting the brackets to the roll bar in the...

After bolting the brackets to the roll bar in the back, getting the door surrounds on, I flip up the top loosely, hook the rear corners and then close the front. It will initially be 1/4" short.
...
Forum: JK General Discussion Forum 06-19-2013, 03:46 PM
Replies: 12
Views: 1,555
Posted By K7MDL
I mounted a 1" RAM diamond ball mount using the...

I mounted a 1" RAM diamond ball mount using the one screw and then using a new short screw for the other side of the mount into the tray bottom (rubber tray piece removed of course). I put a thin...
Forum: JK General Discussion Forum 05-21-2013, 01:22 AM
Replies: 15
Views: 831
Posted By K7MDL
For certain areas like the White Rim...

For certain areas like the White Rim permit/reservations are required and certain equipment is also required. The Canyonlands National Park web site info should clarify. The good news is that in June...
Forum: JK General Discussion Forum 05-20-2013, 02:21 AM
Replies: 24
Views: 1,529
Posted By K7MDL
I have a 2013 so cannot offer an answer, but you...

I have a 2013 so cannot offer an answer, but you might just unbolt the seat from the rail to get full access and then see if you can remove whatever is there, cutting it out if it won't compromise...
Forum: JK General Discussion Forum 05-19-2013, 04:12 PM
Replies: 15
Views: 831
Posted By K7MDL
Be prepared for hot. A hotel or RV with AC rather...

Be prepared for hot. A hotel or RV with AC rather then tenting would be my choice.
The snow will be melted or almost gone in the La Salles so you can scope out some high country roads and enjoy the...
Forum: JK General Discussion Forum 05-11-2013, 06:33 PM
Replies: 8
Views: 436
Posted By K7MDL
32lbs is about right on my BFG A/Ts, which are...

32lbs is about right on my BFG A/Ts, which are load E and stiffer sidewalls. 35+ rides like a brick. 9K miles on them in the last 6 months and you cannot really tell there is any wear, these look...
Forum: JK General Discussion Forum 05-11-2013, 12:50 PM
Replies: 30
Views: 1,144
Posted By K7MDL
Put the first 500 on in 1 week on my 2013 last...

Put the first 500 on in 1 week on my 2013 last August per break in guidelines. Then packed up with one of my daughters and did an impromptu 9 day camping road trip for 3400 miles though Oregon,...
Forum: JK General Discussion Forum 05-11-2013, 12:36 PM
Replies: 105
Views: 15,857
Posted By K7MDL
Other than the compass button that mirror looks...

Other than the compass button that mirror looks the same on the 2009+ Mazda Miata MX-5s, so likely on most any Mazda with HomeLink mirrors as they tend to reuse parts.

On the Miata and our Acura...
Forum: JK General Discussion Forum 05-09-2013, 09:46 PM
Replies: 105
Views: 15,857
Posted By K7MDL
OK, I went out today and got some pictures of the...

OK, I went out today and got some pictures of the behind the dash portion of the install. Not much to see. After carefully measuring and marking and drilling the button, LED, and bezel tab holes, I...
Forum: JK General Discussion Forum 05-09-2013, 03:15 AM
Replies: 105
Views: 15,857
Posted By K7MDL
The (currently) $22 one at...

The (currently) $22 one at http://www.ebay.com/itm/Homelink-Universal-3-Button-Transmitter-Black-Dark-Charcoal-Rolling-Codes-/300901014596...
Forum: JK General Discussion Forum 05-09-2013, 03:08 AM
Replies: 105
Views: 15,857
Posted By K7MDL
Yes. I need to pull the dash end cover off mine...

Yes. I need to pull the dash end cover off mine and verify which wires I tapped for power and ground. I followed the thread here so I think I ended up with the pink and black, but need to verify. ...
Forum: JK General Discussion Forum 05-07-2013, 08:54 PM
Replies: 105
Views: 15,857
Posted By K7MDL
I verified my homelink unit as wired in the...

I verified my homelink unit as wired in the mirror bundle doers work in reverse and any other gear (automatic trans). The key is required to be on as I want it to be (security).
Forum: JK General Discussion Forum 05-07-2013, 02:21 AM
Replies: 105
Views: 15,857
Posted By K7MDL
I think the mirror bundle wires are about 20 or...

I think the mirror bundle wires are about 20 or 22AWG.
Forum: JK General Discussion Forum 05-01-2013, 11:20 PM
Replies: 48
Views: 14,672
Posted By K7MDL
17" MB TKO with BFG LT285/70-R17 A/T KO

17" MB TKO with BFG LT285/70-R17 A/T KO
Forum: JK General Discussion Forum 05-01-2013, 11:10 PM
Replies: 105
Views: 15,857
Posted By K7MDL
Pretty much . HomeLink is probably the broadest...

Pretty much . HomeLink is probably the broadest range of coverage, at least for reasonably modern versions. I have 3 different openers, 2 are rolling. Rolling codes use 2 programming steps. Got to...
Forum: JK General Discussion Forum 05-01-2013, 11:08 PM
Replies: 105
Views: 15,857
Posted By K7MDL
For this location you tap into the mirror bundle...

For this location you tap into the mirror bundle right behind the dash left end panel, it is super easy.

I separated the switches by 12" and the main control is fastened to a metal plate that is...
Forum: JK General Discussion Forum 05-01-2013, 10:20 PM
Replies: 105
Views: 15,857
Posted By K7MDL
Here are pictures of my dash install. Buttons...

Here are pictures of my dash install. Buttons behind the dash, main body under the steering wheel.
Forum: JK General Discussion Forum 05-01-2013, 04:24 AM
Replies: 105
Views: 15,857
Posted By K7MDL
Possible that when in the reverse the autodim is...

Possible that when in the reverse the autodim is disabled for better viewing. I tried mine in reverse after initial installation and it worked. Perhaps stored energy was enough and I was fast...
Forum: JK General Discussion Forum 04-14-2013, 01:02 AM
Replies: 52
Views: 5,873
Posted By K7MDL
Despite the shipping, the total is about the...

Despite the shipping, the total is about the same as the Synergy as I recall except RI-Grip becomes with the textured rubber cover.

They do mount in the right location for use seated as well...
Forum: JK General Discussion Forum 04-13-2013, 01:07 PM
Replies: 52
Views: 5,873
Posted By K7MDL
Work great but warm it up at install

These work great and install easy enough. The textured grip is nice, I prefer it over plain metal. One tip, ensure the rubber grip is warmed up. I installed mine when it was cold in the garage and...
Forum: JK General Discussion Forum 04-08-2013, 02:15 PM
Replies: 100
Views: 8,671
Posted By K7MDL
Make sure the hole is sealed where the wire exits...

Make sure the hole is sealed where the wire exits the firewall on the engine side, water runs down right there.
Showing results 1 to 25 of 75

 
Forum Jump

All times are GMT -5. The time now is 04:29 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC