Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 249
Search took 0.33 seconds.
Search: Keyword(s): ; Posts Made By: 99GoldenSahara
Forum: TJ Tech Forum 07-09-2014, 02:08 PM
Replies: 12
Views: 226
Posted By 99GoldenSahara
Thanks everyone. Great advice. Again!

Thanks everyone. Great advice. Again!
Forum: TJ Tech Forum 07-09-2014, 12:03 PM
Replies: 12
Views: 226
Posted By 99GoldenSahara
So when the engine is cold the fan should be free...

So when the engine is cold the fan should be free enough to spin a few revolutions when spun by hand. My fan won't spin when cold but it can be rotated easily by hand. I'll check it when warmed up...
Forum: TJ Tech Forum 07-09-2014, 11:57 AM
Replies: 8
Views: 223
Posted By 99GoldenSahara
OK Thanks again for your help.

OK Thanks again for your help.
Forum: TJ Tech Forum 07-09-2014, 11:51 AM
Replies: 12
Views: 226
Posted By 99GoldenSahara
I've decided to keep going with the stock fan. I...

I've decided to keep going with the stock fan. I checked the fan clutch and here's what I found. There's no play front to back. The fan turns easily by hand with engine off, but I can't "spin" it. ...
Forum: TJ Tech Forum 07-09-2014, 11:41 AM
Replies: 8
Views: 223
Posted By 99GoldenSahara
Thanks, Jerry. Should I use the whole can,...

Thanks, Jerry. Should I use the whole can, partial can, or does that factor in at all?
Forum: TJ Tech Forum 07-09-2014, 09:33 AM
Replies: 8
Views: 223
Posted By 99GoldenSahara
Ok. Thanks everyone. I may just end up taking it...

Ok. Thanks everyone. I may just end up taking it off to get it good and clean. I'm assuming a new gasket would be in order as well.
Forum: TJ Tech Forum 07-08-2014, 02:54 PM
Replies: 8
Views: 223
Posted By 99GoldenSahara
Cleaning Throttle Body

Cleaned it out this morning with some sensor safe spray cleaner. The inside was pretty clean although I could see a little carbon build up around the edge of the "butterfly" as I'll call it. My...
Forum: TJ Tech Forum 07-06-2014, 06:23 PM
Replies: 12
Views: 226
Posted By 99GoldenSahara
Thanks so much to you all. Great advice from...

Thanks so much to you all. Great advice from everyone. Since I'm no expert at jeepin (although not a novice at wheeling), folks offer advice with good intentions. This forum is great for running...
Forum: TJ Tech Forum 07-06-2014, 04:44 PM
Replies: 12
Views: 226
Posted By 99GoldenSahara
Electric Fan

My kids and I are planning a trip to Moab in September 2015. In a conversation I had with a fellow jeeper I ran into yesterday at Cabela's he asked if I had installed an electric fan. I told him...
Forum: TJ Tech Forum 07-06-2014, 12:08 AM
Replies: 21
Views: 486
Posted By 99GoldenSahara
It looks pretty terminal to me. I'm not sure...

It looks pretty terminal to me. I'm not sure there's a surgeon who can heal this cancer. IMHO.
Forum: TJ Tech Forum 07-06-2014, 12:02 AM
Replies: 55
Views: 1,111
Posted By 99GoldenSahara
I have a Sahara with 3.73's front and back. Dana...

I have a Sahara with 3.73's front and back. Dana 35 rear, Dana 30 front. 4.0, 5 spd. I can go anywhere you go, whether it's hauling a moose, elk, or deer. Yeah, we got all those animals here too,...
Forum: TJ Tech Forum 07-05-2014, 11:07 AM
Replies: 55
Views: 1,111
Posted By 99GoldenSahara
I believe Jerry drives an hour or so and back to...

I believe Jerry drives an hour or so and back to get to and from where he often wheels. So that point is pure b.s. Plus, get a job or something. Quit wasting people's time since you haven't cleaned...
Forum: TJ Tech Forum 07-03-2014, 11:08 PM
Replies: 27
Views: 618
Posted By 99GoldenSahara
I've done some welding but not enough to consider...

I've done some welding but not enough to consider myself a welder. There always are 2 schools of thought for every project. Some of the traditional approaches were born from a desire for safety,...
Forum: TJ Tech Forum 07-03-2014, 10:40 PM
Replies: 55
Views: 1,111
Posted By 99GoldenSahara
Ahhh. But of course. But will they learn?? ...

Ahhh. But of course. But will they learn?? Most of us who are humble enough to listen to the voice of experience are grateful enough to apply the lessons learned. But...there are always those who...
Forum: TJ Tech Forum 07-01-2014, 11:07 PM
Replies: 8
Views: 245
Posted By 99GoldenSahara
I guess so. Come on already. Sure hope no one...

I guess so. Come on already. Sure hope no one gets hurt during this experiment. It's like continuing to drive on bad breaks until "you have to replace them." Listen to the voice of reason AND...
Forum: TJ General Discussion Forum 06-28-2014, 01:30 PM
Replies: 8
Views: 364
Posted By 99GoldenSahara
I used Penetrol on my hardtop. Same color as...

I used Penetrol on my hardtop. Same color as yours. Had the same results. Mine took 2 coats. Lasted all fall & winter. Will put on a new coat when I put it back on in the fall. The can of Penetrol...
Forum: TJ Tech Forum 06-26-2014, 10:22 PM
Replies: 15
Views: 409
Posted By 99GoldenSahara
If I would somehow decide to run the Antirock on...

If I would somehow decide to run the Antirock on the rear as well, what do you see as the pluses or minuses, beyond the expense ? Thanks. I always appreciate your input on this and I know you...
Forum: TJ Tech Forum 06-26-2014, 02:01 PM
Replies: 15
Views: 409
Posted By 99GoldenSahara
Just curious to know if beyond the stock rear...

Just curious to know if beyond the stock rear sway bar there is anything other option than the Antirock for the rear. I know a couple of guys that run the Antirock on the rear as well as the front....
Forum: TJ Tech Forum 06-26-2014, 12:59 PM
Replies: 15
Views: 409
Posted By 99GoldenSahara
Thanks. Don't know of any aftermarket rear sway...

Thanks. Don't know of any aftermarket rear sway bars so will put the stock one back on.
Forum: TJ Tech Forum 06-26-2014, 11:22 AM
Replies: 15
Views: 409
Posted By 99GoldenSahara
During the install of my lift, steering upgrade,...

During the install of my lift, steering upgrade, and Antirock front sway bar, the rear stock sway bar was removed and not replaced. The consensus at that time was that it didn't offer much in terms...
Forum: TJ Tech Forum 06-20-2014, 11:39 PM
Replies: 24
Views: 579
Posted By 99GoldenSahara
Actually I discovered by calling the dealer that...

Actually I discovered by calling the dealer that the opposite is true...aluminum OEM is what they're selling.
Forum: TJ Tech Forum 06-20-2014, 11:36 PM
Replies: 6
Views: 222
Posted By 99GoldenSahara
X3. I'm actually happy these days when I buy a...

X3. I'm actually happy these days when I buy a shirt that's made in India or Vietman. And I grew up in the 60's. It's been proven time and again that we turn a blind eye to Chinese manufacturing...
Forum: TJ Tech Forum 06-20-2014, 02:12 PM
Replies: 5
Views: 138
Posted By 99GoldenSahara
Yes, I've tried NAPA, Autozone, O'Reilly's, and a...

Yes, I've tried NAPA, Autozone, O'Reilly's, and a local shop called Motion Auto Parts. Called the Chrysler dealer, check online at We R Mopar.com (same part # as dealership). That's about all the...
Forum: TJ Tech Forum 06-20-2014, 01:49 PM
Replies: 24
Views: 579
Posted By 99GoldenSahara
I've tried O'Reilly's and every auto parts store...

I've tried O'Reilly's and every auto parts store in this area and also the dealership parts department. All aluminum.
Forum: TJ Tech Forum 06-20-2014, 01:48 PM
Replies: 24
Views: 579
Posted By 99GoldenSahara
Where did you get that Accel distributor and...

Where did you get that Accel distributor and rotor with brass contacts?
Showing results 1 to 25 of 249

 
Forum Jump

All times are GMT -5. The time now is 03:45 PM.



Jeep, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC