Jeep Wrangler Forum - Search Results

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 243
Search took 0.25 seconds.
Search: Keyword(s): ; Posts Made By: LucaBrasi
Forum: TJ Tech Forum 07-25-2015, 10:50 AM
Replies: 13
Views: 426
Posted By LucaBrasi
More good and bad news! The good: all bolts...

More good and bad news!

The good: all bolts are off, new bumper is on. I still have to drill 2 holes and add 2 more bolts but I'm not too worried about that right now.

The bad: 1 of the bolts...
Forum: TJ Tech Forum 07-24-2015, 09:22 PM
Replies: 13
Views: 426
Posted By LucaBrasi
Been hitting it with pb blaster for 2 weeks. ...

Been hitting it with pb blaster for 2 weeks.

I can get a box end on the pass side, barely, but it won't budge. I think it's hitting the top of the frame and won't turn because of that.

The...
Forum: TJ Tech Forum 07-24-2015, 08:11 PM
Replies: 13
Views: 426
Posted By LucaBrasi
Not enough clearance to turn the wrench. I'll...

Not enough clearance to turn the wrench. I'll remove the body mount if I have too, it's never been touched and I'm not sure it's going to move easy.
Forum: TJ Tech Forum 07-24-2015, 07:00 PM
Replies: 13
Views: 426
Posted By LucaBrasi
So, progress! I got that one out. Actually, I...

So, progress! I got that one out. Actually, I have 4 of the 6 out. New problem though; I can't get a socket or wrench on the top 2 nuts. There are round rubber/metal body mounts (?) in the way. I...
Forum: TJ Tech Forum 07-22-2015, 06:32 PM
Replies: 13
Views: 426
Posted By LucaBrasi
It's welded to the hanger that's welded to the...

It's welded to the hanger that's welded to the frame.
Forum: TJ Tech Forum 07-22-2015, 05:24 PM
Replies: 13
Views: 426
Posted By LucaBrasi
Removing rear bunper, exhaust in way. Help!

See pics. 2001 SE. The pass side bolt into the frame is longer than the space between the frame and exhaust tip.

I'm not against cutting the tip off. So far, I haven't been able to get the bolt...
Forum: TJ Tech Forum 05-28-2015, 05:55 PM
Replies: 13
Views: 352
Posted By LucaBrasi
Update! It's not the battery, it's the positive...

Update! It's not the battery, it's the positive terminal. I cleaned it and it started up. Next question: should I replace this (it's not original) and if so any suggestions for a part? Otherwise, any...
Forum: TJ Tech Forum 05-27-2015, 05:25 PM
Replies: 13
Views: 352
Posted By LucaBrasi
But if it were the cables, would it still jump...

But if it were the cables, would it still jump (and run) fine?
Forum: TJ Tech Forum 05-26-2015, 07:49 PM
Replies: 13
Views: 352
Posted By LucaBrasi
Thanks all. The terminals are clean from...

Thanks all. The terminals are clean from corrosion but I will take them off and brush them. One terminal is not original, it's a clamp on type. Any suggestion on a better replacement without a whole...
Forum: TJ Tech Forum 05-26-2015, 07:35 PM
Replies: 13
Views: 352
Posted By LucaBrasi
Dead battery? Something else?

This morning it (2001 SE) started fine. 3 mile drive to work. After work, dead. When I turned the key it beeped and gauges went crazy. No turnover and no lights. Jumped it, but had to keep my foot on...
Forum: TJ Tech Forum 04-18-2015, 10:48 AM
Replies: 5
Views: 360
Posted By LucaBrasi
I had this recently, my negative battery cable...

I had this recently, my negative battery cable wasn't tightened enough (which I found out next time I went to start). I'm guessing I hit a bump, temporarily sent the battery gauge to 0, and the light...
Forum: For Sale 04-18-2015, 09:19 AM
Replies: 0
Views: 133
Posted By LucaBrasi
Blower motor from a 2001

I replaced my blower motor recently, but turns out it was the switch. I have the old original motor from my 2001, and I am assuming it works.

I'll give it away for (the $ for) a cheap 6-pack and...
Forum: TJ Tech Forum 04-18-2015, 09:16 AM
Replies: 1
Views: 349
Posted By LucaBrasi
Evap line rubber elbows, p1494

I have p1494 check engine light on, 2001 SE 2.5

I found 2 evap line hoses that run from the drivers side fender towards the engine block (I am guessing the throttle body). One was disconnected and...
Forum: TJ Tech Forum 02-26-2015, 08:02 AM
Replies: 7
Views: 403
Posted By LucaBrasi
I will check the fuse for sure. Since the...

I will check the fuse for sure.

Since the switch was in the on position already, I am guessing the switch is fine? (or else the motor would be stuck on?)

Any write ups of replacing the motor?...
Forum: TJ Tech Forum 02-25-2015, 10:56 PM
Replies: 7
Views: 403
Posted By LucaBrasi
No heat!

This winter is killing my Jeep, and I only drive 50 miles a week.

2001 SE 2.5. No AC.

I drove to work this morning, I had heat, on full blast. Got in the Jeep after work, the heat was still...
Forum: TJ Tech Forum 01-28-2015, 02:39 PM
Replies: 9
Views: 461
Posted By LucaBrasi
Been there, done all that. the ends of the ujoint...

Been there, done all that. the ends of the ujoint are rotted, no way to pull the pins out before putting them in the press (and I tried using the press anyway, they wont budge)
Forum: TJ Tech Forum 01-28-2015, 11:14 AM
Replies: 9
Views: 461
Posted By LucaBrasi
Thanks. Snapped front axle u-joints would be...

Thanks. Snapped front axle u-joints would be great, I have been trying to change them and they are completely seized on (the pins have rusted/oxidized into 1 solid piece, I need to wait for better...
Forum: TJ Tech Forum 01-28-2015, 10:35 AM
Replies: 9
Views: 461
Posted By LucaBrasi
Stuck in snow, loud "pop"

We got 24" of snow here, and the plow put a big bank in front of my TJ (2001, SE, manual).

I tried to drive right through, but ended up on top of the snow and had to do some shoveling. I rocked it...
Forum: TJ Tech Forum 01-12-2015, 04:41 PM
Replies: 29
Views: 1,075
Posted By LucaBrasi
If anyone knows anything more I should be...

If anyone knows anything more I should be concerned about, please chime in.

But it's 37 degrees now, and no noise. I'll keep an eye on it and will replace the belt sooner than later.
Forum: TJ Tech Forum 01-12-2015, 06:51 AM
Replies: 29
Views: 1,075
Posted By LucaBrasi
Oil level was fine. No puddles underneath. ...

Oil level was fine. No puddles underneath.

I started to think either the belt or a pulley, so water pump or alternator might be it. I'll check water level tonight.
Forum: TJ Tech Forum 01-11-2015, 07:31 PM
Replies: 29
Views: 1,075
Posted By LucaBrasi
Its a stick so no tranny fluid to check, but I...

Its a stick so no tranny fluid to check, but I will check the oil when I head out in the AM
Forum: TJ Tech Forum 01-11-2015, 06:44 PM
Replies: 29
Views: 1,075
Posted By LucaBrasi
Strange noise: whistle/whining sound

2001 SE 2.5L

Started it the other day, it was 0 degrees out, and an odd high pitch whine started. Sounds like a whistle but is not, because it can happen not moving.

It mostly happens when on...
Forum: TJ Tech Forum 12-09-2014, 05:25 PM
Replies: 17
Views: 1,571
Posted By LucaBrasi
Thanks for the price update! I will hit up Napa...

Thanks for the price update! I will hit up Napa this weekend. It's pouring, anyway...
Forum: TJ Tech Forum 12-07-2014, 08:01 PM
Replies: 17
Views: 1,571
Posted By LucaBrasi
Does anyone have the part number? It looks like...

Does anyone have the part number? It looks like this one fits: Amazon.com: NGK 23141 Oxygen Sensor - NGK/NTK Packaging: Automotive...
Forum: TJ Tech Forum 12-06-2014, 09:38 AM
Replies: 17
Views: 1,571
Posted By LucaBrasi
Sorry forgot: 2001 se 2.5 Sounds like it...

Sorry forgot: 2001 se 2.5

Sounds like it would have 4 sensors?
Showing results 1 to 25 of 243

 
Forum Jump

All times are GMT -5. The time now is 10:01 PM.


User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2015 DragonByte Technologies Ltd.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC