Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 250
Search took 1.15 seconds.
Search: Keyword(s): ; Posts Made By: Defcon 1
Forum: YJ Tech Forum 03-24-2015, 10:06 PM
Replies: 14
Views: 251
Posted By Defcon 1
Need more details about what you did. Did you...

Need more details about what you did. Did you drain the system out completely when you replaced the hoses/radiator/t-stat? Did you drain it at the engine block as well? Air in the system will cause...
Forum: YJ Tech Forum 03-22-2015, 09:07 PM
Replies: 4
Views: 172
Posted By Defcon 1
It should only do it once, (for about a 2 second...

It should only do it once, (for about a 2 second burst). Once it builds up adequate fuel PSI at the fuel rail, (aprox 35), it should maintain that until engine start. If it doesn't, it could be...
Forum: YJ Tech Forum 03-21-2015, 03:30 PM
Replies: 21
Views: 421
Posted By Defcon 1
Did you check the fuses under the dash?

Did you check the fuses under the dash?
Forum: YJ Tech Forum 03-21-2015, 07:41 AM
Replies: 9
Views: 520
Posted By Defcon 1
I have a pair or Corbeau Baja RS seats and they...

I have a pair or Corbeau Baja RS seats and they are super comfy. The have bolsters so it's a nice "snug" fit when you sit in them, plus they recline, and are adaptable if you ever want to upgrade to...
Forum: YJ Tech Forum 03-16-2015, 02:06 AM
Replies: 4
Views: 196
Posted By Defcon 1
Yes definitely. Get a good amount of pix from...

Yes definitely. Get a good amount of pix from underneath, including the T-Case and Driveshafts. Also take pix of both front and rear axles, as well as general all-around pictures. The more the better...
Forum: YJ Tech Forum 03-15-2015, 10:11 PM
Replies: 4
Views: 196
Posted By Defcon 1
Hmm that all depends on what system was modified...

Hmm that all depends on what system was modified to get the 2-4 inches of lift. It could be as simple as removing a 2" Body Lift, or as complicated as swapping back to original-stock leaf-springs,...
Forum: YJ Tech Forum 03-12-2015, 10:50 PM
Replies: 10
Views: 289
Posted By Defcon 1
Yes I have heard of this several times, can't...

Yes I have heard of this several times, can't confirm if this is an actual diagnosis for a faulty ECM. Can you get the ECM to perform a code read-out? [ (Key-On / Key-Off) Three times consecutively ]
Forum: YJ Tech Forum 03-10-2015, 10:16 PM
Replies: 11
Views: 179
Posted By Defcon 1
I didn't use any when I put mine in, been...

I didn't use any when I put mine in, been leak-free for 6+ years. Does it say to use a thread sealer for the install? I can't remember lol.
Forum: YJ Tech Forum 02-27-2015, 09:34 AM
Replies: 6
Views: 205
Posted By Defcon 1
It's probably not "working in the opposite...

It's probably not "working in the opposite direction" but more likely "failing and returning to neutral". It can only be the tach, the electrical/mechanical linkage to the tach, or the...
Forum: YJ Tech Forum 02-26-2015, 06:11 AM
Replies: 11
Views: 345
Posted By Defcon 1
I just changed my slow-leak heater core last...

I just changed my slow-leak heater core last month it was easy. A 3 on a 1-10 scale lol. I didn't have to remove the glovebox because I can sneak my hands up and disconnect the defrost duct from...
Forum: YJ Tech Forum 02-25-2015, 05:59 AM
Replies: 10
Views: 415
Posted By Defcon 1
I have a Duralast Gold and it's been going strong...

I have a Duralast Gold and it's been going strong for 5 years now. Proving you can cheap out and get away with it sometimes lol.
Forum: JK General Discussion Forum 02-23-2015, 05:30 AM
Replies: 209
Views: 23,900
Posted By Defcon 1
I seriously clicked on this thread because I...

I seriously clicked on this thread because I thought it would be guys posting pictures of real badges of honor, you know, like carnage/dents/scrapes/dings/holes you get on the trail? Totally...
Forum: YJ Tech Forum 02-21-2015, 03:07 PM
Replies: 11
Views: 595
Posted By Defcon 1
Fuel pressure regulator vacuum line. It needs to...

Fuel pressure regulator vacuum line. It needs to gets hooked up to whatever vacuum it was connected to. Looks like a hack job not supposed to have that type of connection on that line.
Forum: YJ Tech Forum 02-19-2015, 01:50 PM
Replies: 9
Views: 366
Posted By Defcon 1
I have that same exact part installed in my Jeep...

I have that same exact part installed in my Jeep due to the same problem on my passenger side seatbelt. I didn't weld mine though I used specialized aircraft titanium rivets and riveted the plate in....
Forum: YJ Tech Forum 02-16-2015, 10:23 PM
Replies: 6
Views: 266
Posted By Defcon 1
Negative this is for a TJ, I don't see any type...

Negative this is for a TJ, I don't see any type listed for a YJ on the site. Anyone have any thoughts?
Forum: YJ Tech Forum 02-16-2015, 05:32 AM
Replies: 6
Views: 266
Posted By Defcon 1
Door Striker Pin:

Quick question, is the driver/passenger door striker pin the same as the tailgate striker pin? I don't have either of them to compare. Trying to replace my "misplaced" tailgate striker pin. About to...
Forum: YJ Tech Forum 02-15-2015, 10:19 PM
Replies: 9
Views: 367
Posted By Defcon 1
I don't know about a softer rubber, maybe you can...

I don't know about a softer rubber, maybe you can take it off and give it a good stretchin' to wear in a bit more. It is possible to warm up the transmission by putting the t-case in neutral and then...
Forum: YJ Tech Forum 02-15-2015, 09:00 PM
Replies: 6
Views: 275
Posted By Defcon 1
It's kind of tricky with one hydraulic jack...

It's kind of tricky with one hydraulic jack because you either have to choose supporting the engine, or lowering the skid-plate with it. It can be done though, you just gotta have some strategy.
...
Forum: YJ Tech Forum 02-15-2015, 08:49 PM
Replies: 6
Views: 275
Posted By Defcon 1
Easy to fix, necessary. The insulator stud...

Easy to fix, necessary. The insulator stud assists with the torque-movement of the transmission, get it fixed along with new tranny mounts too while you have the skid down. The worst part is dropping...
Forum: YJ Tech Forum 02-12-2015, 08:53 PM
Replies: 6
Views: 316
Posted By Defcon 1
Yes this tool is necessary. With a magnet you can...

Yes this tool is necessary. With a magnet you can easily drop and scuff the new lifters, no good. Also you'll magnetize the lifters, so engine metal particles will collect in/around them, defeating...
Forum: YJ Tech Forum 02-12-2015, 03:48 PM
Replies: 6
Views: 316
Posted By Defcon 1
Seafoam treatment in the crankcase. Then if that...

Seafoam treatment in the crankcase. Then if that doesn't work, lifter change. It's easy to change lifters in the 2.5 you don't need to take off the head, just the valve cover.
Forum: YJ Tech Forum 02-09-2015, 03:12 AM
Replies: 3
Views: 228
Posted By Defcon 1
I believe they are 1/4" Fine-Thread, aprox 1.0"...

I believe they are 1/4" Fine-Thread, aprox 1.0" in length. Maybe someone with a FSM can jump in on this.
Forum: Wanted 02-08-2015, 08:49 PM
Replies: 2
Views: 234
Posted By Defcon 1
When you say brackets you mean the fender braces?...

When you say brackets you mean the fender braces? I have a complete set for a YJ if you need them, shoot me a PM.
Forum: YJ Tech Forum 02-08-2015, 12:39 PM
Replies: 3
Views: 175
Posted By Defcon 1
The YJ heat system is very primitive, based of...

The YJ heat system is very primitive, based of the CJ. Simply letting it idle usually doesn't work well, not like it does in a modern car. The YJ engine bay has a TON of airflow around it, and the...
Forum: YJ Tech Forum 02-07-2015, 05:53 PM
Replies: 7
Views: 195
Posted By Defcon 1
Yeah I think it's the gauge's wiring, it works...

Yeah I think it's the gauge's wiring, it works sporadically. I already had replaced the temp sensor at the back of the block, but now I think I have an open line in the wiring somewhere. I can get...
Showing results 1 to 25 of 250

 
Forum Jump

All times are GMT -5. The time now is 12:50 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC