Jeep Wrangler Forum - Search Results

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 250
Search took 0.23 seconds.
Search: Keyword(s): ; Posts Made By: Abomination93
Forum: YJ Tech Forum 06-24-2015, 10:00 PM
Replies: 6
Views: 236
Posted By Abomination93
I am going to assume you've checked the fuses,...

I am going to assume you've checked the fuses, wiring and pcm for any damage or opens. If not I'd check those areas. I know the ASD relay controls all of the ignition and fuel system.

Wish I...
Forum: Wisconsin Jeep Forum 06-24-2015, 08:03 AM
Replies: 5
Views: 365
Posted By Abomination93
I know its too far for you but I had my frame...

I know its too far for you but I had my frame fixed at a shop in Theresa, WI. Did decent work, had both rear end caps fixed and the nuts for the skid plate replaced. Cost me about 600
Forum: YJ Tech Forum 06-24-2015, 07:41 AM
Replies: 12
Views: 539
Posted By Abomination93
I didn't read the OP but this is in responds to...

I didn't read the OP but this is in responds to the jounce bumper post. A jounce bumper is also called a bump stop. It prevents the axle from coming up too far. I know I didn't have them on my...
Forum: YJ Tech Forum 06-15-2015, 11:02 AM
Replies: 3
Views: 497
Posted By Abomination93
I don't trust eBay LEDs, had bad luck with them...

I don't trust eBay LEDs, had bad luck with them but maybe I got a bad batch. I personally buy from WWW.superbrightleds.com and have always had great success with their products, both in the...
Forum: YJ Tech Forum 03-16-2015, 01:39 PM
Replies: 17
Views: 621
Posted By Abomination93
Well I have had 3 tops by rampage, every last one...

Well I have had 3 tops by rampage, every last one of them has torn in one way or another.

First one was one of their early designs for sound deadening, that material tore out of the stitching.
...
Forum: YJ Tech Forum 10-27-2013, 08:49 AM
Replies: 33
Views: 2,730
Posted By Abomination93
OP props to you for sharing your opinion and your...

OP props to you for sharing your opinion and your engineering thoughts. But as with all things there's facts and there's theory. In engineering sometimes that line gets fudged by either bean counters...
Forum: YJ Tech Forum 05-15-2013, 06:11 AM
Replies: 9
Views: 568
Posted By Abomination93
I know Chrysler has them for $7 a piece...I...

I know Chrysler has them for $7 a piece...I passed on that price.
Forum: YJ Tech Forum 05-13-2013, 05:54 AM
Replies: 5
Views: 429
Posted By Abomination93
Yea those are probably for testing things at the...

Yea those are probably for testing things at the factory
Forum: YJ Tech Forum 05-08-2013, 10:53 PM
Replies: 18
Views: 2,749
Posted By Abomination93
It's not a bad top, I have it for a 93. I...

It's not a bad top, I have it for a 93.

I did tear the tonneau twice, but it was covered under warranty. Some of the stitching is not top quality but It survived a Wisconsin winter so its not...
Forum: YJ Tech Forum 05-08-2013, 05:56 AM
Replies: 4
Views: 610
Posted By Abomination93
Well the sound bar that came on my jeep had blown...

Well the sound bar that came on my jeep had blown speakers, so I installed some pioneers (4") about 7+ years ago and they are just now starting to rattle on heavy bass.

My sound bar is a cheap 2...
Forum: YJ Build Forum 05-06-2013, 08:19 PM
Replies: 5
Views: 454
Posted By Abomination93
Personally I have one from eBay with a lifetime...

Personally I have one from eBay with a lifetime warranty. Seller is radiatorsforless iirc. First one blew the seal on the bottom tank after 1.5years contacted the seller 2 days later I had a brand...
Forum: YJ Tech Forum 05-05-2013, 08:53 PM
Replies: 17
Views: 834
Posted By Abomination93
People wool want to know which engine you have. ...

People wool want to know which engine you have.

I know on the 4.0l you don't have to drop anything. I would venture a guess the 2.5 and 4.2 are in the same boat.
Forum: YJ Build Forum 05-05-2013, 08:50 PM
Replies: 6
Views: 810
Posted By Abomination93
Why not just disconnect the door light switch, a...

Why not just disconnect the door light switch, a lot easier than pulling a fuse that could be powering other things.

Personally I keep my door light switches unplugged year round.
Forum: YJ Tech Forum 04-30-2013, 04:49 PM
Replies: 20
Views: 2,201
Posted By Abomination93
Well water freezes not so good for us northern...

Well water freezes not so good for us northern people. RV antifreeze...I don't know much about it but liquids expand at a different rate than air and may cause air pressures to go too high at highway...
Forum: Classifieds Archive 04-22-2013, 07:42 AM
Replies: 83
Views: 7,701
Posted By Abomination93
How much for the front axle shafts shipped to...

How much for the front axle shafts shipped to 53933?
Forum: YJ Tech Forum 04-10-2013, 06:21 AM
Replies: 6
Views: 529
Posted By Abomination93
Anything below 15.5 volts is fine. Alternator...

Anything below 15.5 volts is fine. Alternator should put out between 13.5-15.5v, if the voltage meter in the dash is pegged id have to guess the gauge is faulty.
Forum: YJ Tech Forum 03-08-2013, 06:00 AM
Replies: 11
Views: 1,713
Posted By Abomination93
Either the master or the slave is leaking past...

Either the master or the slave is leaking past its seal and not holding pressure like it should. Being a 94 replacing both is very easy. The slave is held to the bellhousing by 2 nuts and you have to...
Forum: YJ Tech Forum 03-04-2013, 05:50 AM
Replies: 9
Views: 1,175
Posted By Abomination93
From personal experience leave the bump stops in,...

From personal experience leave the bump stops in, if you remove them and hit a good rut you can say goodbye to your engine. Mine came with no stops and didn't think twice, I went into a large puddle...
Forum: YJ Tech Forum 02-18-2013, 05:44 AM
Replies: 9
Views: 1,884
Posted By Abomination93
No safe way to open a booster, the spring inside...

No safe way to open a booster, the spring inside is pretty tough from what I hear. If you have a lighted boroscope you can pop off the vacuum nipple and peek inside. If not a long swab of some sort...
Forum: YJ Tech Forum 02-17-2013, 08:21 PM
Replies: 9
Views: 1,884
Posted By Abomination93
I agree sounds like a blown master.

I agree sounds like a blown master.
Forum: YJ Tech Forum 12-27-2012, 05:19 PM
Replies: 2
Views: 749
Posted By Abomination93
Yes go for it just leave the fill plug out so you...

Yes go for it just leave the fill plug out so you don't over fill it.
Forum: YJ Tech Forum 12-20-2012, 06:53 AM
Replies: 9
Views: 480
Posted By Abomination93
Wow someone who actually drives their vette, glad...

Wow someone who actually drives their vette, glad to see someone using their vette. Most vettes I work on don't even make it 3000 in a year.
Forum: YJ Tech Forum 12-20-2012, 06:49 AM
Replies: 10
Views: 519
Posted By Abomination93
You can use an easy out but odds are it won't...

You can use an easy out but odds are it won't move, if you have access to a torch I would recommend heating up the rest of the bolt and then use the easy out.

The idea behind using the torch is to...
Forum: YJ General Discussion Forum 12-20-2012, 06:41 AM
Replies: 4
Views: 546
Posted By Abomination93
100% agree with joker, its all normal. I see this...

100% agree with joker, its all normal. I see this all the time working at a stealership especially on older peoples cars. Nothing to be overly concerned about.
Forum: YJ General Discussion Forum 12-19-2012, 11:36 AM
Replies: 7
Views: 679
Posted By Abomination93
Id get it but I have no way of getting it back...

Id get it but I have no way of getting it back home, something like 5-7 hrs away.
Showing results 1 to 25 of 250

 
Forum Jump

All times are GMT -5. The time now is 01:17 AM.


User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2015 DragonByte Technologies Ltd.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC