Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 60
Search took 0.35 seconds.
Search: Keyword(s): ; Posts Made By: TipperD
Forum: YJ Tech Forum 04-18-2014, 02:16 PM
Replies: 9
Views: 243
Posted By TipperD
I flushed mine with straight 30w....drove about...

I flushed mine with straight 30w....drove about 15 miles and then drained and filled with Syncromesh. the top one is the fill plug. I used a hand pump for an outboard motor lower unit that fit on the...
Forum: YJ General Discussion Forum 04-09-2014, 06:27 PM
Replies: 3
Views: 178
Posted By TipperD
I had great service from Derran at Rockridge....

I had great service from Derran at Rockridge. Zone lift was an easy install and great quality,
Forum: YJ Tech Forum 03-29-2014, 06:41 AM
Replies: 1
Views: 207
Posted By TipperD
I ordered the Zone 2" lift kit...the Zone...

I ordered the Zone 2" lift kit...the Zone standard boomerang shackle kit, a new steering stabilizer. You will have all the bolts necessary except the 4 that connect the leaf springs to the...
Forum: YJ Tech Forum 03-26-2014, 06:39 AM
Replies: 22
Views: 554
Posted By TipperD
I have the Chilton Wrangler 87-95 on pdf if you...

I have the Chilton Wrangler 87-95 on pdf if you want it....send me a message with your email address!
Forum: YJ Tech Forum 03-23-2014, 07:00 AM
Replies: 22
Views: 554
Posted By TipperD
I have a 1995 Chrysler Jeep service manual in...

I have a 1995 Chrysler Jeep service manual in PDF. It is 83.8 MB. PM me if you want a copy.
I found it online somewhere for free.
also have a JeepPartsList94-96YJ.pdf,,,,,very useful as it has...
Forum: YJ Tech Forum 03-18-2014, 05:50 PM
Replies: 8
Views: 137
Posted By TipperD
The way I would do it is to mount the winch and...

The way I would do it is to mount the winch and solenoid and then measure- a length of old garden hose run along the wire route will do well- and then go to Napa or other parts store and have the...
Forum: YJ Tech Forum 03-15-2014, 07:47 PM
Replies: 9
Views: 509
Posted By TipperD
These are the Zone shackles I used... Zone...

These are the Zone shackles I used...
Zone Offroad Heavy Duty Shackles Jeep CJ5/CJ7 - 1/2" Lift (Rear Only) Jeep YJ - Stock Height (Front or Rear) J5109...
Forum: YJ Tech Forum 03-15-2014, 06:49 AM
Replies: 9
Views: 509
Posted By TipperD
I did the Zone 2" with their standard shackles...

I did the Zone 2" with their standard shackles and got 3" of lift. Quality was good and easy install except for a few bolts I had to cut.
Forum: WF New Member Check In 03-07-2014, 06:06 AM
Replies: 17
Views: 244
Posted By TipperD
Welcome...from the NC coast

Welcome...from the NC coast
Forum: WF New Member Check In 03-07-2014, 06:04 AM
Replies: 7
Views: 125
Posted By TipperD
Welcome.....from the NC coast

Welcome.....from the NC coast
Forum: YJ General Discussion Forum 03-03-2014, 02:29 PM
Replies: 8
Views: 418
Posted By TipperD
I gave up on the glove box removal...the heads of...

I gave up on the glove box removal...the heads of the machine screws had been reamed out and could not get them out. I masked it all off and painted in place.
Forum: YJ General Discussion Forum 03-03-2014, 06:44 AM
Replies: 8
Views: 418
Posted By TipperD
I just painted the lower plastic parts with...

I just painted the lower plastic parts with Rust-tol-lium flat black....and did the LED lights. Not too paint on the top plastic will stick well and most likely not come off later if it has to.

...
Forum: YJ Tech Forum 02-19-2014, 06:13 AM
Replies: 4
Views: 315
Posted By TipperD
It is pretty straight forward, but he vent hose...

It is pretty straight forward, but he vent hose inside the filler hose is very tight and hard to get a good grip on, took a bit with good needle nose vice grips.
here is a link

Wrangler YJ Gas...
Forum: YJ Tech Forum 02-18-2014, 06:43 AM
Replies: 13
Views: 345
Posted By TipperD
When I got my 95 YJ the syncros in 3/4 were going...

When I got my 95 YJ the syncros in 3/4 were going bad...I flushed it with straight 30wt for about 25 miles and then put in Syncromesh in it...the shifting has definitely improved ....if and when it...
Forum: TJ General Discussion Forum 02-17-2014, 06:24 AM
Replies: 7
Views: 261
Posted By TipperD
Welcome....I am in NC on the coast....

Welcome....I am in NC on the coast....
Forum: YJ Tech Forum 01-22-2014, 06:29 PM
Replies: 2
Views: 223
Posted By TipperD
I believe that pre 1994 there is a fusible...

I believe that pre 1994 there is a fusible link....94-95 has a starter relay. clean your relay contacts, ck. your battery cables and sure they are tight on the posts and be sure the solenoid contacts...
Forum: YJ Tech Forum 01-16-2014, 06:44 AM
Replies: 12
Views: 538
Posted By TipperD
Ck out a reman....may be cheaper in the long run....

Ck out a reman....may be cheaper in the long run. I have a shop here that will do the swap and does not mind me bringing them the parts.

AX5 Transmission For Sale...
Forum: YJ General Discussion Forum 01-10-2014, 07:43 AM
Replies: 14
Views: 734
Posted By TipperD
I used Zip Strip paint remover to remove the...

I used Zip Strip paint remover to remove the Rhino liner from my hardtop. use a small brush to apply to bolt, let sit a bit and try cleaning with small metal bristle brush....may take a few...
Forum: YJ Tech Forum 12-24-2013, 07:00 AM
Replies: 3
Views: 295
Posted By TipperD
ck out this site Wiring Review,...

ck out this site

Wiring Review, Installation, and Help Information | etrailer.com (http://www.etrailer.com/info.aspx?productgroup=Wiring)
Forum: YJ Tech Forum 11-27-2013, 06:44 AM
Replies: 4
Views: 244
Posted By TipperD
you most likely have a vacuum leak..... I...

you most likely have a vacuum leak.....

I installed a posi lock...

4x4 Posi-Lok Positive Axle Engagement System for Jeeps (http://www.4x4posi-lok.com/app_jeep.html)
Forum: YJ Tech Forum 11-17-2013, 03:13 PM
Replies: 26
Views: 1,217
Posted By TipperD
Very happy with a 2" Zone lift, got about 2.5"...

Very happy with a 2" Zone lift, got about 2.5" out of it. went with their boomerang shackles no lift, but they have a 1" one as well. They are made by BDS. Call Darren at Rockridge.
Forum: TJ General Discussion Forum 11-05-2013, 06:10 AM
Replies: 33
Views: 3,807
Posted By TipperD
photo to follow I had the brackets milled...

photo to follow

I had the brackets milled from solid stock and welded to the bumper, added a welded tab to bumper to catch the rear bolt so bumper has 3 bolts to frame, incorporated a Smitty bilt...
Forum: YJ Tech Forum 11-04-2013, 06:38 AM
Replies: 13
Views: 985
Posted By TipperD
rebuild source Jeep AX15 Transmission for Sale...

rebuild source
Jeep AX15 Transmission for Sale (http://www.smartpartsauto.com/manual_transmission_ax15_jeep.html)
Forum: YJ Tech Forum 10-31-2013, 01:00 PM
Replies: 2
Views: 238
Posted By TipperD
Posi Loc vacuum question...

Installed a Posi loc...all working ...the instructions want you to cap off a vacuum line but I cannot be sure which one it is...."Before you remove the CAD (Central Axle Disconnect) vacuum actuator,...
Forum: YJ General Discussion Forum 10-06-2013, 06:57 AM
Replies: 42
Views: 1,160
Posted By TipperD
Equal representation.....change it

Equal representation.....change it
Showing results 1 to 25 of 60

 
Forum Jump

All times are GMT -5. The time now is 12:02 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC