Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 56
Search took 0.13 seconds.
Search: Keyword(s): ; Posts Made By: greatermn
Forum: JK Tech Forum 02-23-2015, 01:30 PM
Replies: 21
Views: 818
Posted By greatermn
No experience with that specific spring. Some...

No experience with that specific spring. Some folks in my local club have them and they do the job with a bit stiffer ride. Might want to consider a leveling kit or small lift kit. JKs have a bit...
Forum: JK Tech Forum 02-21-2015, 10:06 PM
Replies: 43
Views: 2,204
Posted By greatermn
Ditto... had ACE and the rubi rails on for 2...

Ditto... had ACE and the rubi rails on for 2 years never had an issue and saved me a few times. I'll admit tho... Those rock hard sliders look temping... maybe I'll have to go out and bash up my...
Forum: JK Tech Forum 02-20-2015, 11:28 AM
Replies: 40
Views: 1,381
Posted By greatermn
For what its worth... I run beads AND TPMS...

For what its worth... I run beads AND TPMS sensors and have yet to have any issues. Had the beads for a couple of years now and its the way I'll be setting up my tires going forward.
Forum: JK Tech Forum 02-20-2015, 11:10 AM
Replies: 26
Views: 975
Posted By greatermn
The winch wiring kits from 12volt guy do not come...

The winch wiring kits from 12volt guy do not come with solenoid boxes (to my knowledge)... that comes with your winch. Unless your calling something else the solenoid box? I believe the 12volt kits...
Forum: JK Tech Forum 02-16-2015, 10:42 PM
Replies: 26
Views: 975
Posted By greatermn
This is where I source all my switches and wiring...

This is where I source all my switches and wiring from...
Forum: JK Tech Forum 02-16-2015, 10:07 AM
Replies: 26
Views: 975
Posted By greatermn
Rocker switches typically (haven't looked at your...

Rocker switches typically (haven't looked at your vendor...) have a common positive (you can actually wire these switches up a variety of ways) and a return on each end of the rocker. In my case...
Forum: JK Tech Forum 02-16-2015, 09:58 AM
Replies: 26
Views: 975
Posted By greatermn
Had to fab up the bracket... couldn't find...

Had to fab up the bracket... couldn't find anything that would meet my needs. Here are some pics of the work...
Forum: JK Tech Forum 02-16-2015, 09:44 AM
Replies: 26
Views: 975
Posted By greatermn
Got the isolator off of amazon... Amazon.com...

Got the isolator off of amazon...

Amazon.com : PAC PAC-500 500-Amp Relay Battery Isolator : Automotive Battery Switches : Car Electronics...
Forum: JK Tech Forum 02-15-2015, 11:03 PM
Replies: 26
Views: 975
Posted By greatermn
A pic of the HD relay isolator...

A pic of the HD relay isolator...
Forum: JK Tech Forum 02-15-2015, 11:01 PM
Replies: 26
Views: 975
Posted By greatermn
Activates the HD relay isolator... Heres a...

Activates the HD relay isolator...

Heres a pic of the panel...
Forum: JK Tech Forum 02-13-2015, 10:29 PM
Replies: 26
Views: 975
Posted By greatermn
I was going that route when I bought my winch......

I was going that route when I bought my winch... Even bought the remote. But I decided that I wanted to have that cut off switch to kill all power to the system. No potential power bleeding, no...
Forum: JK Tech Forum 02-13-2015, 10:21 PM
Replies: 26
Views: 975
Posted By greatermn
NP... I know others on the forum have done...

NP... I know others on the forum have done similar set ups. I think i fused my switch leads at 5amps... (I think they only draw 3) but Ill have to double check. You can get inline ATC fuse holders...
Forum: JK Tech Forum 02-13-2015, 04:05 PM
Replies: 30
Views: 1,327
Posted By greatermn
I have a lift and lockers in my JK. While I...

I have a lift and lockers in my JK. While I wheel alot, most of what I do is remote camping/exploring, backwoods driving, etc. Not rock crawling in any case. With that in mind... I've used my...
Forum: JK Tech Forum 02-13-2015, 03:55 PM
Replies: 26
Views: 975
Posted By greatermn
Not sure why folks would have issue with this......

Not sure why folks would have issue with this... but strokes/folks.

Anyways, I relocated my winch control box to above the battery on my JK, I wired the control solenoids to a similar switch set...
Forum: JK General Discussion Forum 10-08-2013, 02:36 PM
Replies: 24
Views: 2,608
Posted By greatermn
I didn't originally get the cover plate, since I...

I didn't originally get the cover plate, since I was going to install the winch. But this summer after I installed... I wanted the extra protection for the winch so I did order the cover plate.
...
Forum: JK General Discussion Forum 10-08-2013, 02:18 PM
Replies: 24
Views: 2,608
Posted By greatermn
Ha, ... sorry... I gave you the "road map",...

Ha, ... sorry... I gave you the "road map", you'll have to run the trail by yourself.
Forum: JK General Discussion Forum 10-07-2013, 12:57 PM
Replies: 24
Views: 2,608
Posted By greatermn
I took a rattle can of self-etching primer and...

I took a rattle can of self-etching primer and flat black paint to the bracket, mounted the winch solenoid, replaced the stock winch cables with my welders cable runs, and attached the "arming"...
Forum: JK General Discussion Forum 10-07-2013, 12:51 PM
Replies: 24
Views: 2,608
Posted By greatermn
So... after attaching the tapered piece to the...

So... after attaching the tapered piece to the main bracket at the angle determined by the pre-fit, scuffing the entire surface, and attaching the rubber isolators you get the following...
Forum: JK General Discussion Forum 10-07-2013, 12:48 PM
Replies: 24
Views: 2,608
Posted By greatermn
In order to support the bracket above the battery...

In order to support the bracket above the battery and provide a mount point for the shock absorber isolators, I fused two short "nubs" from a solid 3/8 inch aluminum rod to the bottom of the bracket....
Forum: JK General Discussion Forum 10-07-2013, 12:42 PM
Replies: 24
Views: 2,608
Posted By greatermn
I also fabricated a smaller tapered piece out of...

I also fabricated a smaller tapered piece out of the left over aluminum plate I had in order to fabricate an attachment point for the whole bracket. The pic below shows the main bracket and the...
Forum: JK General Discussion Forum 10-07-2013, 12:32 PM
Replies: 24
Views: 2,608
Posted By greatermn
Below is a pic of where I was intending to mount...

Below is a pic of where I was intending to mount the solenoid. I put some notes in the picture as to where I was going to attach the bracket to the vehicle ( to secure the mount ), as well as give...
Forum: JK General Discussion Forum 10-07-2013, 12:08 PM
Replies: 24
Views: 2,608
Posted By greatermn
I decided to make a bracket to mount the solenoid...

I decided to make a bracket to mount the solenoid onto and support an additional "arming" solenoid to wire to a switch in the cab. I wanted to have a cut-off switch in the cab to ensure I didn't...
Forum: JK General Discussion Forum 10-07-2013, 11:44 AM
Replies: 24
Views: 2,608
Posted By greatermn
Pulled some pics from my install (meant to post a...

Pulled some pics from my install (meant to post a install thread and haven't yet... guess this will have to do...). There quite a few pics, hopefully this will give you some ideas... (Don't mean to...
Forum: JK General Discussion Forum 10-03-2013, 10:50 AM
Replies: 24
Views: 2,608
Posted By greatermn
I'll post some pics of my solenoid install when I...

I'll post some pics of my solenoid install when I get a chance this weekend.
Forum: JK General Discussion Forum 10-03-2013, 10:45 AM
Replies: 41
Views: 8,218
Posted By greatermn
So I have 35s (actually 34.5"), both the AEV...

So I have 35s (actually 34.5"), both the AEV front/rear bumpers (plus tire carrier) and winch with the AEV 2.5 dual sport lift kit. I also went with the recon version of the rack as I'm putting a...
Showing results 1 to 25 of 56

 
Forum Jump

All times are GMT -5. The time now is 04:42 PM.


User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2015 DragonByte Technologies Ltd.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC