Jeep Wrangler Forum - Search Results

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 80
Search took 0.22 seconds.
Search: Keyword(s): ; Posts Made By: zidodcigalah
Forum: YJ Tech Forum 08-29-2015, 11:18 AM
Replies: 5
Views: 163
Posted By zidodcigalah
You should first check if there are any trouble...

You should first check if there are any trouble codes present.. You can do it by turning ignition key on off three times and then count when CEL flashes. Works on '91.+ models
Jeep Horizons ::...
Forum: YJ Tech Forum 08-26-2015, 07:04 PM
Replies: 2
Views: 223
Posted By zidodcigalah
First try this Jeep Horizons :: 1991-1995 Jeep...

First try this Jeep Horizons :: 1991-1995 Jeep Wrangler (YJ) Trouble Codes (http://www.jeephorizons.com/tech/yj_codes.html) . After you get the codes (if there are any) it would be easier to diagnose...
Forum: YJ Tech Forum 08-25-2015, 10:50 AM
Replies: 4
Views: 248
Posted By zidodcigalah
About 3 years, some 15000 miles on them. Was your...

About 3 years, some 15000 miles on them. Was your jeep shaking (like left-right shake) or that was like rumble strips on highway?
Forum: YJ Tech Forum 08-25-2015, 10:31 AM
Replies: 4
Views: 248
Posted By zidodcigalah
Driveline vibrations (rear DS, diffs or transfer case?)

Hi,

These vibrations are bothering me for a year so I finally decided to do something. Here is the situation:

-Vibrations only occur when accelerating on speeds between 35 and 50 mph cca (cant...
Forum: YJ Tech Forum 08-25-2015, 10:07 AM
Replies: 10
Views: 542
Posted By zidodcigalah
#6 connecting rod was bent, that caused loss of...

#6 connecting rod was bent, that caused loss of compression and power. Replaced it and now everything is fine :)
Forum: YJ Tech Forum 06-24-2014, 11:10 AM
Replies: 10
Views: 542
Posted By zidodcigalah
Will do.. I hope that damn connecting rod bent a...

Will do.. I hope that damn connecting rod bent a bit because of hydrolock and that there was no other damage..
Forum: YJ Tech Forum 06-24-2014, 11:08 AM
Replies: 3
Views: 509
Posted By zidodcigalah
Well, there are a couple of options.. AX15...

Well, there are a couple of options..

AX15 is a manual transmission paired with 4.0 in both wrangler and cherokee. It will install on 4.0 in wrangler with a bit of drilling. Only problem that may...
Forum: YJ Tech Forum 06-21-2014, 09:08 PM
Replies: 10
Views: 542
Posted By zidodcigalah
I hope I haven't damaged crankshaft because I...

I hope I haven't damaged crankshaft because I recently replaced it, 5 months before hydrolock :)
I hope there is no block damage because i dont get any clunking sound while driving.. Will do as...
Forum: YJ Tech Forum 06-21-2014, 11:59 AM
Replies: 10
Views: 542
Posted By zidodcigalah
No i haven't seen any metal particles.. My...

No i haven't seen any metal particles..
My main problem is, will I have to do a rebuild or I can leave components in other cylinders intact? Because I'm pretty much sure that this happened because...
Forum: YJ Tech Forum 06-21-2014, 11:07 AM
Replies: 10
Views: 542
Posted By zidodcigalah
Bad compression #6 cylinder

Hi guys,

Recently my engine got hydrolocked, but it still runs good, although not with the same amount of power like it used to have :) It's 1995. 4.0 with 100k miles on it.

I've noticed that...
Forum: YJ Tech Forum 05-11-2014, 07:48 AM
Replies: 11
Views: 602
Posted By zidodcigalah
I've checked, there is no water in trans, i have...

I've checked, there is no water in trans, i have 32rh auto, luckly the water was not so deep, it couldn't get to trans vent.. Thanks :)
Forum: YJ Tech Forum 05-09-2014, 10:05 AM
Replies: 11
Views: 602
Posted By zidodcigalah
Changed oil and IAC. It's very hot day here and...

Changed oil and IAC. It's very hot day here and on hot idle after couple of miles of hard driving i get around 25-30 psi oil pressure on idle. When driving it goes to about 40-45 psi. I guess that...
Forum: YJ Tech Forum 05-08-2014, 07:35 AM
Replies: 12
Views: 522
Posted By zidodcigalah
+1 for StanF.. But if it is auto.. don't expect...

+1 for StanF.. But if it is auto.. don't expect too much :) there are only 3 speeds available :D
Forum: YJ Tech Forum 05-08-2014, 07:04 AM
Replies: 16
Views: 1,517
Posted By zidodcigalah
Did you check IAC ? Mine got stuck in a single...

Did you check IAC ? Mine got stuck in a single position, crappy idling, bad throttle response and horrible rich condition at idle, gasoline comes out from exhaust. Also i cant start it without...
Forum: YJ Tech Forum 05-08-2014, 07:00 AM
Replies: 2
Views: 405
Posted By zidodcigalah
Will check today. Thanks

Will check today. Thanks
Forum: YJ Tech Forum 05-08-2014, 06:40 AM
Replies: 12
Views: 522
Posted By zidodcigalah
Is it auto or manual? Check gearing(tag on rear...

Is it auto or manual? Check gearing(tag on rear differential)

There could be lot of factors that cause bad gas mileage.. Mostly those are bad O2 sensor, bad cat.converter, vacuum leak, bad spark.....
Forum: YJ Tech Forum 05-07-2014, 01:39 PM
Replies: 14
Views: 952
Posted By zidodcigalah
Get a used one from a junkyard.. Those things do...

Get a used one from a junkyard.. Those things do not die so often, most problems come from dirt in TB..
Forum: YJ Tech Forum 05-07-2014, 01:37 PM
Replies: 1
Views: 259
Posted By zidodcigalah
I guess that this transmission is not a good...

I guess that this transmission is not a good thing then. It has only 3 speeds, and I'm not even sure that it have lockup clutch. But that Jeep should have 3.55 or 3.73 gears instead of 3.07 which...
Forum: YJ Tech Forum 05-07-2014, 01:31 PM
Replies: 2
Views: 405
Posted By zidodcigalah
Clunking sound when shifting and manipulating throttle

Hi everyone,

I have this annoying sound allmost every time when car is rolling , i press throttle pedal a bit , something clunks, when i release it, another clunk. Same thing happens when...
Forum: YJ Tech Forum 05-07-2014, 07:06 AM
Replies: 11
Views: 602
Posted By zidodcigalah
Will do today. I hope I haven't damaged anything...

Will do today. I hope I haven't damaged anything up till now, i drove it only 60 miles with this oil.. Even thought it doesn't seem that there is water in the oil when I look at it.. But i guess that...
Forum: YJ Tech Forum 05-07-2014, 06:59 AM
Replies: 9
Views: 466
Posted By zidodcigalah
But do you feel slippage then, or it just revs...

But do you feel slippage then, or it just revs too much? If it only revs too much its probably some sticky valve... I had exactly the same problem, but in my case, when it shifts, second time it will...
Forum: YJ Tech Forum 05-07-2014, 06:55 AM
Replies: 14
Views: 952
Posted By zidodcigalah
Try another IAC, there are not expensive anyway.....

Try another IAC, there are not expensive anyway.. I have the same symtpoms, and now my IAC is completely stuck..
Forum: YJ Tech Forum 05-06-2014, 11:30 AM
Replies: 12
Views: 3,174
Posted By zidodcigalah
Mine used to stuck but i found a cigarete lighter...

Mine used to stuck but i found a cigarete lighter blocking linkage :)
Forum: YJ Tech Forum 05-06-2014, 08:23 AM
Replies: 9
Views: 466
Posted By zidodcigalah
If you feel slippage ( high revs but jeep doesn't...

If you feel slippage ( high revs but jeep doesn't accelerate, something like when you put manual transmission into neutral while car is moving and press throttle pedal) , check bands (both front and...
Forum: YJ Tech Forum 05-06-2014, 08:16 AM
Replies: 4
Views: 308
Posted By zidodcigalah
Seem like transfer case lever hit in your car...

Seem like transfer case lever hit in your car body or the lever might be loose.. I've heard that lifting would cause that. Next time it happens, stop , disconnect lever from transfer case (or you...
Showing results 1 to 25 of 80

 
Forum Jump

All times are GMT -5. The time now is 11:28 AM.


User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2015 DragonByte Technologies Ltd.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC