Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 81
Search took 0.33 seconds.
Search: Keyword(s): ; Posts Made By: luv2bmx22
Forum: YJ Tech Forum 05-26-2014, 06:17 PM
Replies: 10
Views: 371
Posted By luv2bmx22
First check your clutch fluid. If that's full...

First check your clutch fluid. If that's full then its the synchros
Forum: YJ Tech Forum 05-26-2014, 06:14 PM
Replies: 3
Views: 174
Posted By luv2bmx22
sounds like a brake issue. Mine pulls a little to...

sounds like a brake issue. Mine pulls a little to the left while driving and a little to the right when braking. nothing dangerous just annoying. check your brake calipers see if everything is...
Forum: YJ Tech Forum 05-26-2014, 06:07 PM
Replies: 9
Views: 394
Posted By luv2bmx22
your sway bar is probably not connected if you...

your sway bar is probably not connected if you have one at all. I've never experienced a death wobble with the sway bar hooked up. but once I disconnect it wobbles on every bump it hits. I kind of...
Forum: YJ Tech Forum 04-03-2014, 11:46 AM
Replies: 6
Views: 252
Posted By luv2bmx22
It's a good thing that it's heavy. Don't worry if...

It's a good thing that it's heavy. Don't worry if its harder than your previous one; means you have plenty of pressure which is a good thing. The problems come when you have little pressure; you...
Forum: YJ Tech Forum 03-26-2014, 06:00 PM
Replies: 7
Views: 262
Posted By luv2bmx22
Probably the vacuum lines. Does the 4wd light...

Probably the vacuum lines. Does the 4wd light come on at all?
Forum: YJ Tech Forum 03-26-2014, 05:28 PM
Replies: 7
Views: 379
Posted By luv2bmx22
here is something that may help. it may not be...

here is something that may help. it may not be completely accurate... I'm going based off my memory from a JP magazine.

light green means you wont have any problems.
light blue means you may have...
Forum: YJ General Discussion Forum 03-26-2014, 05:15 PM
Replies: 11
Views: 382
Posted By luv2bmx22
I removed both rear and front track bars and I...

I removed both rear and front track bars and I notice no difference in highway driving.

Some of the things I have noticed after removing them is increased articulation - both front and rear axles....
Forum: YJ Tech Forum 03-11-2014, 11:42 AM
Replies: 13
Views: 769
Posted By luv2bmx22
Sometimes the bushing in the front of the starter...

Sometimes the bushing in the front of the starter falls out. I guess they didn't do a good job of rebuilding it. Check to see if the copper bushing is there. This happened to me a while ago.
Forum: YJ Tech Forum 03-11-2014, 11:38 AM
Replies: 7
Views: 256
Posted By luv2bmx22
It has to be a vacuum leak somewhere. Most likely...

It has to be a vacuum leak somewhere. Most likely it's the throttle body. Maybe a completely missing vacuum hose?
Forum: YJ Tech Forum 03-11-2014, 11:31 AM
Replies: 10
Views: 216
Posted By luv2bmx22
What exactly did you check?

What exactly did you check?
Forum: YJ General Discussion Forum 03-10-2014, 11:47 AM
Replies: 2
Views: 284
Posted By luv2bmx22
I knew it wouldn't be easy getting them off....

I knew it wouldn't be easy getting them off. Thank you for the input.
Forum: YJ General Discussion Forum 03-09-2014, 11:55 PM
Replies: 385
Views: 27,845
Posted By luv2bmx22
haha sorry to say, but it's the truth

haha sorry to say, but it's the truth
Forum: YJ General Discussion Forum 03-09-2014, 11:12 PM
Replies: 2
Views: 284
Posted By luv2bmx22
Quick Disconnect Questions

I'm planning on buying quick disconnects for my 93 YJ. I've been looking around the internet and was wondering which brand to go with.

I'm also wondering if I can use disconnects that were...
Forum: YJ Tech Forum 02-27-2014, 06:54 PM
Replies: 12
Views: 546
Posted By luv2bmx22
I have a 93 YJ and the driver side looks exactly...

I have a 93 YJ and the driver side looks exactly the same. The passenger is a little different though. Seems like you have a gap on the floor where the center council sits. Mine doesnt have that.
Forum: YJ General Discussion Forum 02-27-2014, 06:47 PM
Replies: 15
Views: 568
Posted By luv2bmx22
I heard of people spraying rusted spots with a...

I heard of people spraying rusted spots with a solution that turned the rust into a hard, paintable surface. I never used it myself and I'm not even sure what it's called. I would look it up if I...
Forum: YJ General Discussion Forum 02-27-2014, 06:43 PM
Replies: 4
Views: 175
Posted By luv2bmx22
Just a bad part. They usually rebuild them from...

Just a bad part. They usually rebuild them from old ones, so I'm guessing they didn't do it right.
Forum: YJ General Discussion Forum 02-19-2014, 08:17 AM
Replies: 7
Views: 314
Posted By luv2bmx22
Just as mocoyj said it says to use atf, but I...

Just as mocoyj said it says to use atf, but I don't think using RP will damage it. If you decide to go with the RP, don't worry about the cost for putting it in the transfer case; it takes a very...
Forum: YJ General Discussion Forum 02-19-2014, 06:58 AM
Replies: 385
Views: 27,845
Posted By luv2bmx22
You know you drive a YJ when it has more...

You know you drive a YJ when it has more aerodynamics going backwards than forward!
Forum: YJ Tech Forum 02-13-2014, 11:15 AM
Replies: 13
Views: 364
Posted By luv2bmx22
If you are in neutral when it is idling low, the...

If you are in neutral when it is idling low, the clutch is not it. I took my cat out and what I noticed is faster rpm drops (because there is less back pressure). So you might actually have a hole in...
Forum: YJ General Discussion Forum 02-12-2014, 01:05 PM
Replies: 10
Views: 439
Posted By luv2bmx22
The parts alone on that rid are worth 6k. Get it...

The parts alone on that rid are worth 6k. Get it before it's gone!
Forum: YJ Tech Forum 02-11-2014, 11:55 AM
Replies: 14
Views: 403
Posted By luv2bmx22
Sometimes it will not engage until you drive a...

Sometimes it will not engage until you drive a few feet. After that if it's still not engaging you have a problem. Another thing you can do is go on a slick surface and pop the clutch as you look out...
Forum: YJ Tech Forum 01-26-2014, 08:15 PM
Replies: 17
Views: 657
Posted By luv2bmx22
First of all, DO NOT REMOVE THE SKID PLATE...

First of all, DO NOT REMOVE THE SKID PLATE WITHOUT A JACK UNDER THE TRANSMISSION!

Unless of course you want to be picking up the transmission off the floor and reconnecting your drive shaft to it....
Forum: YJ Tech Forum 01-26-2014, 08:09 PM
Replies: 5
Views: 343
Posted By luv2bmx22
Get anything other than the stock mounts you...

Get anything other than the stock mounts you would find at autozone. Last time I replaced mine I got the stock ones and they just looked and felt so cheap. Surprised they haven't broke yet.
Also the...
Forum: YJ Tech Forum 01-26-2014, 08:04 PM
Replies: 8
Views: 282
Posted By luv2bmx22
You can loosen the bolts to put the door back in...

You can loosen the bolts to put the door back in place, but I will tell you right now it will be a pain getting them off.

First of all, they are sealed. Loosening them will not be easy.
Second,...
Forum: YJ Tech Forum 01-11-2014, 06:34 PM
Replies: 4
Views: 291
Posted By luv2bmx22
The only place I have a pin is on the master...

The only place I have a pin is on the master cylinder. I looked allover the place for any pins on the slave but couldn't find anything.

Luckily I solved the problem by burning the hose off and...
Showing results 1 to 25 of 81

 
Forum Jump

All times are GMT -5. The time now is 07:09 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC