Jeep Wrangler Forum - Search Results

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 250
Search took 0.18 seconds.
Search: Keyword(s): ; Posts Made By: techflork
Forum: TJ Tech Forum 01-28-2016, 08:43 PM
Replies: 4
Views: 335
Posted By techflork
It just drains water, doubt it's a big deal. Just...

It just drains water, doubt it's a big deal. Just pop it back in
Forum: TJ Tech Forum 01-28-2016, 08:25 PM
Replies: 4
Views: 335
Posted By techflork
x2

x2
Forum: TJ Tech Forum 01-22-2016, 09:51 AM
Replies: 7
Views: 425
Posted By techflork
Nice jeep man! You only have cloaks on the...

Nice jeep man! You only have cloaks on the front. Without a lift you'll definitely need to trim the rear. Also you said you just regeared your current axles. Not trying to be a downer but...
Forum: TJ Tech Forum 01-21-2016, 01:30 PM
Replies: 21
Views: 958
Posted By techflork
Quick question, to cycle your suspension to check...

Quick question, to cycle your suspension to check for DS bind specifically you would do the following:

Remove springs and shocks while keep is on jack stands. Jack up one side of the axle as far...
Forum: California Jeep Forum 01-15-2016, 12:43 PM
Replies: 22
Views: 583
Posted By techflork
:lmao:

:lmao:
Forum: California Jeep Forum 01-15-2016, 12:23 PM
Replies: 22
Views: 583
Posted By techflork
Worth doing it yourself, but no you don't really...

Worth doing it yourself, but no you don't really save money (i would never go to the dealer for oil changes they will charge A LOT). Just add it up yourself

cost of oil
cost of oil filter
...
Forum: TJ Pics Forum 01-12-2016, 01:52 PM
Replies: 3
Views: 321
Posted By techflork
It will most definitely look small, i have 33's...

It will most definitely look small, i have 33's on my 3.5 inch lift with metal cloak arched fenders. different set up but my 33's look pretty small. That said, i like it, and with the right set up...
Forum: TJ Tech Forum 01-07-2016, 10:45 AM
Replies: 7
Views: 251
Posted By techflork
Next time take your drive shaft off and drive...

Next time take your drive shaft off and drive home in 4WD. If that yoke comes off your shaft will rip the underside of your jeep apart! I'm surprised it didn't...replace with a new pinion nut,...
Forum: TJ Tech Forum 01-06-2016, 05:27 PM
Replies: 18
Views: 616
Posted By techflork
I used to start my tj up in the mornings at -15...

I used to start my tj up in the mornings at -15 for a few weeks straight. It was super sluggish, sounded like the oil turned to sludge haha. A few coughs and it would start to run. I never replaced...
Forum: JK General Discussion Forum 12-23-2015, 05:29 PM
Replies: 74
Views: 3,114
Posted By techflork
Forgot to add, I bought the coopers from tread...

Forgot to add, I bought the coopers from tread depot for 175 per tire. They were 33x12.5x15. Best price I was able to find anywhere and they shipped to my door! Good luck man, let us know how they...
Forum: JK General Discussion Forum 12-23-2015, 01:43 PM
Replies: 74
Views: 3,114
Posted By techflork
I have the Cooper STT on my TJ. NOT the STT PRO....

I have the Cooper STT on my TJ. NOT the STT PRO. Idk if there are differences or not. Kick ass mud terrain, rather noisy, and absolutely awful in the rain. I hit my brakes but you wouldn't know...
Forum: TJ Tech Forum 12-14-2015, 07:30 PM
Replies: 14
Views: 377
Posted By techflork
Might be the rear main seal, it'd require require...

Might be the rear main seal, it'd require require you to drop the transmission, and replace the whole seal. It's quite a job, you'll need a jack, and some jack stands along with your hand tools. ...
Forum: TJ Tech Forum 12-11-2015, 10:30 AM
Replies: 6
Views: 457
Posted By techflork
Don't have much advice except stay the hell away...

Don't have much advice except stay the hell away from easy outs. When you break one of those off in there, which you will, drilling out that hardened steel will be hella worse than what you started...
Forum: TJ Tech Forum 11-28-2015, 08:45 PM
Replies: 10
Views: 634
Posted By techflork
PA jeep over here. Mines better than most but...

PA jeep over here. Mines better than most but it's kinda bad under the skid. I need to do this too, but I'm going to get it down to the metal. When that plate goes back on you can bet it'll hold...
Forum: TJ Tech Forum 11-24-2015, 09:13 PM
Replies: 14
Views: 690
Posted By techflork
While that's true, it's easier to find stock,...

While that's true, it's easier to find stock, it's more important to me that the jeep performs well. Furthermore the Tom woods shaft blows stock out of the water, beefy and greasable. It'll last...
Forum: TJ Tech Forum 11-24-2015, 07:31 AM
Replies: 14
Views: 690
Posted By techflork
I've busted two yokes. NOT TOM WOODS but the...

I've busted two yokes. NOT TOM WOODS but the axle yokes. First one a pin fell and I couldn't figure out why it wouldn't seat. Sheared the lip of the ear right off. Then I was struggling with the...
Forum: TJ Tech Forum 11-12-2015, 09:37 AM
Replies: 7
Views: 482
Posted By techflork
Is it a vibration or a shimmy? If it's a...

Is it a vibration or a shimmy?

If it's a vibration It's likely a ujoint in your drive shaft. Front if the vibration is in your feet ish area, rear if it's in your back butt ish area.

If it's a...
Forum: TJ Tech Forum 11-08-2015, 04:19 PM
Replies: 8
Views: 353
Posted By techflork
My muffler rattles like crazy sometimes. Makes...

My muffler rattles like crazy sometimes. Makes it sound like ticking.
Forum: TJ Tech Forum 11-06-2015, 10:34 AM
Replies: 18
Views: 2,641
Posted By techflork
I had the same questions and concerns. I was not...

I had the same questions and concerns. I was not impressed by the bracket. After about 8 months now it hasn't moved. Not worth the trouble, don't worry about it. Besides in the event something...
Forum: TJ Tech Forum 10-28-2015, 01:08 PM
Replies: 6
Views: 587
Posted By techflork
Nvm misread the post...yeah no front drive shaft...

Nvm misread the post...yeah no front drive shaft makes no difference. Your essentially driving without it anyways, it's only used when you engage 4WD
Forum: TJ Tech Forum 10-17-2015, 12:11 AM
Replies: 7
Views: 370
Posted By techflork
Haha I was super frustrated doing it. I tend to...

Haha I was super frustrated doing it. I tend to work alone and never ask for help so I gotta get creative. I position the yoke such that when I put a big pipe wrench on it the arm of the wrench hits...
Forum: TJ Tech Forum 10-16-2015, 04:52 PM
Replies: 7
Views: 370
Posted By techflork
I think I asked the same question a while back. ...

I think I asked the same question a while back. The gap is there to allow oil to flow into the compartment . As for the nut, just make sure it's torqued from 150 to 180 ft lbs and it should be...
Forum: TJ Tech Forum 10-16-2015, 04:39 PM
Replies: 6
Views: 363
Posted By techflork
Your transfer case is seeing 0 resistance. So...

Your transfer case is seeing 0 resistance. So when you release the clutch the yokes are spinning but with no shaft to connect your transfer case to your axle clearly the jeep can't move forward. ...
Forum: TJ Tech Forum 10-16-2015, 10:31 AM
Replies: 2
Views: 287
Posted By techflork
The top plastic piece that covers the top of the...

The top plastic piece that covers the top of the windshield has no screws. Yank on it, it's held in by clips
Forum: JK Build Forum 10-07-2015, 11:10 AM
Replies: 180
Views: 20,912
Posted By techflork
Hey man, really digging this thread. I'm a...

Hey man, really digging this thread. I'm a weekend warrior constantly breaking fixing and learning. How are the fox shocks? Even the bilstiens? Might be my next upgrade, looking for longer shocks...
Showing results 1 to 25 of 250

 
Forum Jump

All times are GMT -5. The time now is 11:25 AM.


User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC