Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 228
Search took 0.11 seconds.
Search: Keyword(s): ; Posts Made By: anavrinIV
Forum: JK Pics Forum Yesterday, 09:29 PM
Replies: 2,818
Views: 405,895
Posted By anavrinIV
No point having the tires installed then having...

No point having the tires installed then having to do the TPMS, they'll just have to unseat them to install TPMS then re-seat tires and re-balance.
Forum: TJ Tech Forum Yesterday, 11:04 AM
Replies: 17
Views: 597
Posted By anavrinIV
I replaced my OPDA with a Crown unit but used the...

I replaced my OPDA with a Crown unit but used the OEM CPS after hearing of aftermarket failures. I will keep the Crown as a spare. The swap is pretty easy and straightforward.
Forum: North Carolina Jeep Forum Yesterday, 10:14 AM
Replies: 912
Views: 11,817
Posted By anavrinIV
big creek was a fantastic time yesterday even...

big creek was a fantastic time yesterday even though it was incredibly sloppy. Managed to make it up most obstacles and the only damage was removing all the outside weights from one wheel.

On an...
Forum: North Carolina Jeep Forum 02-27-2015, 01:20 PM
Replies: 912
Views: 11,817
Posted By anavrinIV
I'm riding solo if you want to ride with me, I'm...

I'm riding solo if you want to ride with me, I'm not sure where you are but we could meet up on the way and I can pick you up. I'm new to driving and always looking to learn from those with...
Forum: TJ Tech Forum 02-25-2015, 07:41 PM
Replies: 11
Views: 241
Posted By anavrinIV
I agree spun bearing. Time to start looking for...

I agree spun bearing. Time to start looking for a new engine or plan a rebuild.
Forum: North Carolina Jeep Forum 02-25-2015, 01:51 PM
Replies: 912
Views: 11,817
Posted By anavrinIV
I did just a bit of snow playing yesterday. ...

I did just a bit of snow playing yesterday. Hoping that tonight's dumping is as fantastic as it sounds
Forum: TJ Tech Forum 02-25-2015, 11:31 AM
Replies: 13
Views: 271
Posted By anavrinIV
Drill the holes below to raise the shroud. But...

Drill the holes below to raise the shroud. But your intentions are correct.
Forum: TJ Tech Forum 02-25-2015, 11:31 AM
Replies: 13
Views: 271
Posted By anavrinIV
Raising the motor mount will lower the tail shaft...

Raising the motor mount will lower the tail shaft of the transfer case (trans mount acts as a pivot point) and change the drive shaft angle. This change is often enough to eliminate the need for the...
Forum: General Jeep Discussion 02-24-2015, 10:23 AM
Replies: 36
Views: 2,302
Posted By anavrinIV
My favorite is a yellow TJ with a black hard top...

My favorite is a yellow TJ with a black hard top and black wheels. Outside of that i love the JK Gecko with a black top. I'm not normally a shouty person but I love loud colored jeeps.
Forum: North Carolina Jeep Forum 02-24-2015, 10:18 AM
Replies: 912
Views: 11,817
Posted By anavrinIV
I played in a field. Some bitch called the cops....

I played in a field. Some bitch called the cops. I hate people.
Forum: North Carolina Jeep Forum 02-18-2015, 12:24 PM
Replies: 912
Views: 11,817
Posted By anavrinIV
Ordered a 5th wheel, plugs, fan belt, Trans...

Ordered a 5th wheel, plugs, fan belt, Trans Mount, and fuel filler neck today hopefully to get on before the trip to big creek on the 28th. thinking of getting a Cb setup too but may not get that...
Forum: TJ Tech Forum 02-15-2015, 06:50 PM
Replies: 4
Views: 198
Posted By anavrinIV
I didn't use the supplied loctite. I used blue...

I didn't use the supplied loctite. I used blue on the motor mount bolts and anti-seize on the rear upper shock mount bolts but left the others untouched. I agree with Jerry that if you plan to...
Forum: North Carolina Jeep Forum 02-15-2015, 05:24 PM
Replies: 912
Views: 11,817
Posted By anavrinIV
Finally swapped my opda today. Easy job and...

Finally swapped my opda today. Easy job and everything works but i made it harder on myself than necessary by leaving it in gear and trying to run myself over getting it to tdc.

Next on the list...
Forum: TJ Tech Forum 02-13-2015, 10:43 AM
Replies: 9
Views: 281
Posted By anavrinIV
It can definitely make a small problem worse at...

It can definitely make a small problem worse at the very least
Forum: TJ Tech Forum 02-13-2015, 10:33 AM
Replies: 9
Views: 281
Posted By anavrinIV
Coincidental I'm guessing. You already had some...

Coincidental I'm guessing. You already had some wobble at the same spot, something you hit or did or adjusted while doing the MML made it worse. The MML didn't cause it though
Forum: TJ General Discussion Forum 02-13-2015, 09:13 AM
Replies: 23
Views: 911
Posted By anavrinIV
Mine was the original lunar rover. They just put...

Mine was the original lunar rover. They just put a body on it when it came back. It drove all the way to the moon and back with only one oil change.
Forum: TJ Tech Forum 02-13-2015, 08:47 AM
Replies: 14
Views: 557
Posted By anavrinIV
It took me all of 3 minutes to center mine after...

It took me all of 3 minutes to center mine after doing my lift. I can't stand off center steering.
Forum: TJ Tech Forum 02-13-2015, 08:29 AM
Replies: 14
Views: 557
Posted By anavrinIV
To center the steering wheel you just have to...

To center the steering wheel you just have to turn the turnbuckle on the drag link. Easy peasy.
Forum: TJ General Discussion Forum 02-13-2015, 08:27 AM
Replies: 23
Views: 911
Posted By anavrinIV
Mine better after the lift and wheels than it did...

Mine better after the lift and wheels than it did stock.
Forum: TJ Tech Forum 02-13-2015, 08:15 AM
Replies: 9
Views: 281
Posted By anavrinIV
A MML won't cause DW, that's definitely in the...

A MML won't cause DW, that's definitely in the suspension/steering/wheels and tires. If you have an aftermarket track bar check the holes for ovaling. Also check your control arm bushings for wear
Forum: TJ General Discussion Forum 02-13-2015, 07:49 AM
Replies: 32
Views: 1,036
Posted By anavrinIV
The diameter is what's going to get you with the...

The diameter is what's going to get you with the 3.07s much more than the width. In fact at that low of a gear I doubt you'd notice any difference between 10.5s and 12.5s.

Get the 3.5BS wheels so...
Forum: TJ General Discussion Forum 02-12-2015, 08:14 AM
Replies: 2
Views: 136
Posted By anavrinIV
I'd say it's perfectly on par. I paid 1k for 4...

I'd say it's perfectly on par. I paid 1k for 4 mounted, balanced, road hazard for 33s
Forum: TJ Tech Forum 02-12-2015, 07:33 AM
Replies: 21
Views: 795
Posted By anavrinIV
Not necessarily true. Chains can stretch over...

Not necessarily true. Chains can stretch over time and should be replaced preiodically
Forum: TJ Tech Forum 02-11-2015, 03:03 PM
Replies: 9
Views: 162
Posted By anavrinIV
If timing is off in one cylinder it will be off...

If timing is off in one cylinder it will be off in all of them if you slipped timing. Get a compression tester and see what you're getting in each cylinder then post up.
Forum: TJ Tech Forum 02-11-2015, 02:45 PM
Replies: 9
Views: 162
Posted By anavrinIV
If there was no compression at all and the timing...

If there was no compression at all and the timing was off that much then it seems like you slipped timing. You may not have to pull the head but at this point you need to figure out what's going on...
Showing results 1 to 25 of 228

 
Forum Jump

All times are GMT -5. The time now is 12:52 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC