Jeep Wrangler Forum - Search Results

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 17 of 17
Search took 0.16 seconds.
Search: Keyword(s): ; Posts Made By: svtotem
Forum: TJ General Discussion Forum 03-24-2013, 10:54 AM
Replies: 8
Views: 1,432
Posted By svtotem
Can you be more specific about the software you...

Can you be more specific about the software you downloaded? What is the S/W you downloaded?Sounds like it could be a good approach. Can it log the data?
Forum: TJ General Discussion Forum 03-20-2013, 12:35 PM
Replies: 27
Views: 1,211
Posted By svtotem
I can't really tell you what is reasonable cost...

I can't really tell you what is reasonable cost in your area, I am still too new to my LJ. I just spent just over $300 fort rear pads and rotor turn, new plugs and an inspection of the OPDA.

I...
Forum: TJ General Discussion Forum 03-20-2013, 12:08 PM
Replies: 27
Views: 1,211
Posted By svtotem
There is something to be said for having the...

There is something to be said for having the fluid changes and flushes just to set a baseline for your own maintenance schedule if you are a consciences maintainer. So, don't feel too bad about...
Forum: TJ Tech Forum 03-03-2013, 07:21 PM
Replies: 6
Views: 1,107
Posted By svtotem
It was the plastic bushing described in the above...

It was the plastic bushing described in the above link. I have it tied up with Zip ties and picked up the parts for the fix. Now to have time to drill out the lever.
Forum: TJ Tech Forum 03-02-2013, 09:18 PM
Replies: 6
Views: 1,107
Posted By svtotem
Thanks guys. I found a possible solution here. ...

Thanks guys. I found a possible solution here.


http://www.jeepforum.com/forum/f9/05-4spd-auto-linkage-failure-600665/

Bill
Forum: TJ Tech Forum 03-02-2013, 08:00 PM
Replies: 6
Views: 1,107
Posted By svtotem
05 LJ Auto stuck in neutral

2005 LJ with auto. Shifter works without resistance. Release button works in appropriate detents.

I backed up a few feet, returned trans to Park, and shut down engine. When I finished what I was...
Forum: Communications and Electronics 02-26-2013, 11:13 AM
Replies: 16
Views: 6,055
Posted By svtotem
Thanks Jerry, that is my plan. Where have you...

Thanks Jerry, that is my plan. Where have you come through the firewall? Did you pick up a ground to the tub, or run to the battery negative terminal?

Looks like I have the antenna routing sorted...
Forum: Communications and Electronics 02-25-2013, 07:45 AM
Replies: 16
Views: 6,055
Posted By svtotem
I have searched previous threads and not found...

I have searched previous threads and not found specific antenna routing methods for getting the antenna cable into the jeep.

I have an 05 LJ and will be using a SS driver side tail light mount....
Forum: TJ General Discussion Forum 01-19-2013, 09:50 PM
Replies: 38
Views: 4,076
Posted By svtotem
Thanks Jeff that is a great design and great...

Thanks Jeff that is a great design and great work.

Bill
Forum: TJ General Discussion Forum 01-19-2013, 04:59 PM
Replies: 38
Views: 4,076
Posted By svtotem
Jsherb, Interesting hardtop. Who makes it?

Jsherb,

Interesting hardtop. Who makes it?
Forum: TJ General Discussion Forum 01-18-2013, 08:24 AM
Replies: 16
Views: 2,000
Posted By svtotem
Sorry to be a downer, but don't forget that any...

Sorry to be a downer, but don't forget that any impact strong enough to deploy the air bag will likely kill or severely injure the dog. I would highly recommend keeping him in the back. This is why...
Forum: TJ Tech Forum 01-03-2013, 04:01 PM
Replies: 16
Views: 955
Posted By svtotem
http://www.jeepforum.com/forum/f9/what-cv-shaft-wh...

http://www.jeepforum.com/forum/f9/what-cv-shaft-why-do-i-want-one-854790/

Found it see if this copied link works.
Forum: TJ Tech Forum 01-03-2013, 09:44 AM
Replies: 16
Views: 955
Posted By svtotem
As used here it usually refers to a double cardon...

As used here it usually refers to a double cardon drive shaft. The essentially is a shaft with two 'U' joint at one end rather than one. This allows a greater angle from the transfer case to the...
Forum: TJ General Discussion Forum 01-01-2013, 01:09 PM
Replies: 2
Views: 452
Posted By svtotem
05 and 06 wranglers have a potential for problems...

05 and 06 wranglers have a potential for problems with Cam Position Sensor OPDA/CPS. Excessive wear at the cam gear causes a sound referred to as laughing monkeys.

There is an extensive write up...
Forum: TJ General Discussion Forum 01-01-2013, 01:04 PM
Replies: 18
Views: 1,526
Posted By svtotem
05 and 06 wranglers have a potential for problems...

05 and 06 wranglers have a potential for problems with Cam Position Sensor OPDA/CPS. Excessive wear at the cam gear causes a sound referred to as laughing monkeys.

There is an extensive write up...
Forum: Florida Jeep Forum 12-21-2012, 03:43 PM
Replies: 3
Views: 461
Posted By svtotem
Thanks tabber02, I will check out Jeepers Den. I...

Thanks tabber02, I will check out Jeepers Den. I am aware of 4WP. Does their shop have a good rep for installs?

I am also looking for recommendations for engine service work. I may need a RMS...
Forum: Florida Jeep Forum 12-20-2012, 09:54 PM
Replies: 3
Views: 461
Posted By svtotem
Orlando Service Recommendation?

Just acquired an 05 LJR and want to have it gone over. Can can anyone recommend a good jeep shop?
Showing results 1 to 17 of 17

 
Forum Jump

All times are GMT -5. The time now is 02:55 PM.


User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2015 DragonByte Technologies Ltd.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC