Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 73
Search took 0.15 seconds.
Search: Keyword(s): ; Posts Made By: TJ-GTR
Forum: TJ Tech Forum 10-05-2014, 04:39 AM
Replies: 2
Views: 257
Posted By TJ-GTR
If it were me, I would take it to a frame shop to...

If it were me, I would take it to a frame shop to make sure it is still within specs. There's a good chance It may have been tweaked slightly given the damage you have mentioned.
Forum: TJ Pics Forum 09-22-2014, 07:26 AM
Replies: 86
Views: 5,869
Posted By TJ-GTR
Here's the best pic I got of the front. Yes, it...

Here's the best pic I got of the front. Yes, it is a Rampage bumper. Nice sturdy bumper all though a little pricey I like it.
Forum: TJ Pics Forum 09-19-2014, 06:40 AM
Replies: 86
Views: 5,869
Posted By TJ-GTR
2.5" OME lift.

2.5" OME lift.
Forum: Communications and Electronics 04-23-2014, 08:12 AM
Replies: 10
Views: 648
Posted By TJ-GTR
Have you tried a different microphone? I had...

Have you tried a different microphone? I had somerhing of a similar issue a few years back and it turned out a new mic resolved the problem.
Forum: METALCLOAK 02-18-2014, 06:17 AM
Replies: 2
Views: 377
Posted By TJ-GTR
Here is the other half. Sorry for the image...

Here is the other half. Sorry for the image quality but they should blow up enough to read. Good luck!
Forum: METALCLOAK 02-18-2014, 06:15 AM
Replies: 2
Views: 377
Posted By TJ-GTR
This should help

This should help
Forum: YJ General Discussion Forum 01-18-2014, 05:09 PM
Replies: 17
Views: 653
Posted By TJ-GTR
It really depends what you are planing on doing...

It really depends what you are planing on doing with it. They say,' buy the biggest welder you can afford.' I agree to a point. If you plan on fabricating frames from scratch all the time or...
Forum: JK Tech Forum 01-18-2014, 08:34 AM
Replies: 4
Views: 347
Posted By TJ-GTR
I have the same OME lift and had the same issue...

I have the same OME lift and had the same issue initially. I swaped the rear springs and it corrected the issue. (Left to Right) Not sure why OME doesn't document this or include with the springs.
Forum: General Jeep Discussion 12-10-2013, 05:36 PM
Replies: 2
Views: 275
Posted By TJ-GTR
When you flushed the cooling system, did you...

When you flushed the cooling system, did you replace the thermostat? It sounds like it might be stuck.
Forum: Military Jeep Build Forum 12-03-2013, 12:19 PM
Replies: 58
Views: 4,220
Posted By TJ-GTR
That looks great. Keep up the good work!

That looks great. Keep up the good work!
Forum: JK General Discussion Forum 09-19-2013, 03:41 PM
Replies: 2
Views: 301
Posted By TJ-GTR
Save your money and do it right. There is no such...

Save your money and do it right. There is no such thing as a "Cheap Lift".
Forum: TJ General Discussion Forum 08-20-2013, 06:38 PM
Replies: 11
Views: 767
Posted By TJ-GTR
The most important thing to check is for rust....

The most important thing to check is for rust. The frame and mounts to the body are prone to rust with high miles and/or age. The I6 is probably the more prefferable choice. Take your time and look...
Forum: YJ Tech Forum 08-03-2013, 05:58 PM
Replies: 6
Views: 442
Posted By TJ-GTR
Jeeprich is right. The switch is the likely...

Jeeprich is right. The switch is the likely suspect. If that checks out,check the taillight housings. Rust and moisture is the enemy and is likely the cause.
Forum: Off-Topic 07-13-2013, 06:48 AM
Replies: 26
Views: 505
Posted By TJ-GTR
Very sorry for your loss. Thoughts and prayers...

Very sorry for your loss. Thoughts and prayers are with you. Remember that she is now in a better place.
Forum: JK General Discussion Forum 06-20-2013, 08:25 AM
Replies: 12
Views: 661
Posted By TJ-GTR
I could see this being useful on the underneath...

I could see this being useful on the underneath side of a Jeep. I might consider this for a frame coating. I'm not to concerned about the color of it.
Forum: YJ Tech Forum 05-30-2013, 05:49 AM
Replies: 30
Views: 903
Posted By TJ-GTR
This is where even a cheap volt meter comes in...

This is where even a cheap volt meter comes in handy. If you have one or can grab one, check the voltage at the battery and then at the alternator when it is running and see if you are getting...
Forum: General Jeep Discussion 05-24-2013, 06:10 PM
Replies: 5
Views: 340
Posted By TJ-GTR
6 quarts

6 quarts
Forum: General Jeep Discussion 05-24-2013, 05:33 PM
Replies: 5
Views: 340
Posted By TJ-GTR
The temp is right, 210 is normal for a 4.0 liter....

The temp is right, 210 is normal for a 4.0 liter. Start with changing the oil sending unit followed by an oil change using 10w30 oil and filter. See if you still have the same results.

Just...
Forum: YJ Tech Forum 05-24-2013, 01:29 PM
Replies: 7
Views: 591
Posted By TJ-GTR
SquareLite & Dilligaf are right. The rust...

SquareLite & Dilligaf are right. The rust bubbling up on the surface is a result of what is happening on the backside of the metal. Cutting out the metal and either welding or glueing new metal in is...
Forum: JK General Discussion Forum 05-24-2013, 09:58 AM
Replies: 7
Views: 529
Posted By TJ-GTR
Kill it with fire.

Kill it with fire.
Forum: YJ Tech Forum 05-21-2013, 04:12 PM
Replies: 11
Views: 468
Posted By TJ-GTR
You have to look closely at the different types...

You have to look closely at the different types of lights available. A floodlight for example may be what you need but could cause glare on your hood unless its blacked out or painted with a...
Forum: TJ Tech Forum 05-08-2013, 02:29 PM
Replies: 22
Views: 740
Posted By TJ-GTR
Yes, it should work out with the caveat on your...

Yes, it should work out with the caveat on your rims measurements and tire width.

There are many who have successfully ran with wheel spacers to work out the back spacing issue and there are just...
Forum: TJ Tech Forum 05-08-2013, 02:17 PM
Replies: 22
Views: 740
Posted By TJ-GTR
You should be able to fit 33s easily with a total...

You should be able to fit 33s easily with a total of 3 inches of lift. I would stick with a 1 inch body lift. There can be some xfer case shifter issues that could end up costing more $$ if you do -...
Forum: TJ Tech Forum 05-03-2013, 01:39 PM
Replies: 35
Views: 1,289
Posted By TJ-GTR
Rust in that area comes from behind the panel....

Rust in that area comes from behind the panel. The rust on the surface is the result of what's happening underneath or on the backside of that panel. Sanding and repainting only delays the same...
Forum: TJ General Discussion Forum 05-03-2013, 12:44 PM
Replies: 87
Views: 5,139
Posted By TJ-GTR
Whatever you do. Under any circumstances, never...

Whatever you do. Under any circumstances, never press that button. We're all counting on you....
Showing results 1 to 25 of 73

 
Forum Jump

All times are GMT -5. The time now is 08:41 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC