Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 93
Search took 0.31 seconds.
Search: Keyword(s): ; Posts Made By: gcan
Forum: TJ General Discussion Forum 07-03-2014, 08:25 PM
Replies: 8
Views: 203
Posted By gcan
until I can get a replacement ..... how do I know...

until I can get a replacement ..... how do I know if I can tighten the adjuster nut more?
Forum: TJ General Discussion Forum 07-03-2014, 10:14 AM
Replies: 8
Views: 203
Posted By gcan
Which is why I was asking about just continuing...

Which is why I was asking about just continuing to adjust the box. Not sure how I know what is enough or when the box is bad
Forum: TJ General Discussion Forum 07-03-2014, 10:13 AM
Replies: 8
Views: 203
Posted By gcan
Where did you get the replacement? I checked...

Where did you get the replacement? I checked around this morning and only one supplier even said they could get one...and it would take a week.. The usual chain suppliers said they weren't available....
Forum: TJ General Discussion Forum 07-03-2014, 08:21 AM
Replies: 8
Views: 203
Posted By gcan
Should I continue to adjust the steering box? How...

Should I continue to adjust the steering box? How will I know when I've gone to far?
Forum: TJ General Discussion Forum 07-02-2014, 07:45 PM
Replies: 8
Views: 203
Posted By gcan
steering box

I have a 2004 TJ with the original steering box and have about an inch of dead space at the steering wheel. Meaning if I go back and forth for about an inch the tires don't move which can keep me...
Forum: TJ Tech Forum 06-21-2014, 06:14 AM
Replies: 41
Views: 776
Posted By gcan
yep - I wouldn't say I'm thrilled I found out...

yep - I wouldn't say I'm thrilled I found out it's bent but not sure the severity of it being out 1/4" on one side. I've driven it in the rain and snow and haven't had any concerns with the rear...
Forum: TJ Tech Forum 06-20-2014, 07:30 PM
Replies: 41
Views: 776
Posted By gcan
follow up - I ended up getting the caster...

follow up - I ended up getting the caster adjusting cam bolts and took it in for an alignment today. A world of difference the caster went from 3.8 to 6.2 he reset the toe and all's good with the...
Forum: TJ Tech Forum 06-12-2014, 04:56 PM
Replies: 41
Views: 776
Posted By gcan
I have a angle gauge, can I check my caster angle...

I have a angle gauge, can I check my caster angle at home?
Forum: TJ Tech Forum 06-12-2014, 04:23 PM
Replies: 41
Views: 776
Posted By gcan
I took 5 pictures with my cell phone for others...

I took 5 pictures with my cell phone for others to view to help me with this issue.....how do I post them?
or would it be easier to take them with my camera?
Forum: TJ Tech Forum 06-09-2014, 12:19 PM
Replies: 41
Views: 776
Posted By gcan
Unlimited - the reason I haven't posted a picture...

Unlimited - the reason I haven't posted a picture is I don't have the jeep with me......in an earlier post I said I needed to take a "3 hour road trip".....well I decided not to drive the jeep. I'll...
Forum: TJ Tech Forum 06-09-2014, 09:59 AM
Replies: 41
Views: 776
Posted By gcan
Jerry - can you explain the vibration your...

Jerry - can you explain the vibration your speaking of.....when would I feel it? at road speeds or just around town? That's a good recommendation and a big help in me trouble shooting this issue
...
Forum: TJ Tech Forum 06-09-2014, 07:32 AM
Replies: 41
Views: 776
Posted By gcan
question - the more I think about this maybe I...

question - the more I think about this maybe I should try the cam bolts and try to get the 1.5 or so and just live with it. (That would get me a total of around 5.3) If I get the adjustable control...
Forum: TJ Tech Forum 06-08-2014, 07:04 AM
Replies: 41
Views: 776
Posted By gcan
JKEEPER10 - yes the tech got everything else...

JKEEPER10 - yes the tech got everything else within spec's.

I had it aligned after putting in the new lower control arms on about a month ago but since I still had a floaty feeling I decided...
Forum: TJ Tech Forum 06-07-2014, 02:29 PM
Replies: 41
Views: 776
Posted By gcan
I did a car fax and it shows to have been in an...

I did a car fax and it shows to have been in an accident, side swiped, in 2008 so may have screwed up the front end.

the best option I know is A) have the reading verified B) if correct install...
Forum: TJ Tech Forum 06-07-2014, 06:00 AM
Replies: 41
Views: 776
Posted By gcan
I didn't measure the height before I replaced the...

I didn't measure the height before I replaced the shocks but don't think it made any difference in height. I replaced them trying to correct the drive/steering problem.

04 - I don't notice any...
Forum: TJ Tech Forum 06-06-2014, 11:24 PM
Replies: 41
Views: 776
Posted By gcan
Jerry - that was my thought and all day I've been...

Jerry - that was my thought and all day I've been researching this, once I get the caster reading verified, if it is low, I'll get adjustable arms for the lower and replace....the ones I just put on...
Forum: TJ Tech Forum 06-06-2014, 11:09 PM
Replies: 41
Views: 776
Posted By gcan
does this "lower" than desired caster make the...

does this "lower" than desired caster make the jeep unsafe?

I have a trip planned tomorrow, about 3 hours and all interstate?
Forum: TJ Tech Forum 06-06-2014, 10:53 PM
Replies: 41
Views: 776
Posted By gcan
upper and lowers are fixed....not sure how tis is...

upper and lowers are fixed....not sure how tis is possible unless it's been wrecked at some point.

as it stands how or what can I do to correct? can I get adjustable control arms and get it...
Forum: TJ Tech Forum 06-06-2014, 10:26 PM
Replies: 41
Views: 776
Posted By gcan
I have about a 3 hour road trip planned.....is it...

I have about a 3 hour road trip planned.....is it safe?
Forum: TJ Tech Forum 06-06-2014, 10:14 PM
Replies: 41
Views: 776
Posted By gcan
purchased from Morris 4x4 Item MOPAR Front...

purchased from Morris 4x4
Item MOPAR Front Lower Control Arm part #52088654AB-M

so now I know how bad this reading is....what does a low caster reading mean as far as driving and how can I...
Forum: TJ Tech Forum 06-06-2014, 09:01 PM
Replies: 41
Views: 776
Posted By gcan
caster question for swimmy steering

I had 04 TJ aligned today, the drivinghttp://images.intellitxt.com/ast/adTypes/icon1.png (http://www.wranglerforum.com/#) has been very swimmy.

The report he gave my wife shows the caster...
Forum: TJ Tech Forum 06-06-2014, 06:48 PM
Replies: 13
Views: 372
Posted By gcan
the jeep is stock with 31x9.50 tires.....just...

the jeep is stock with 31x9.50 tires.....just recently replaced the control arms with Mopar brand (the bushings were shot)
Forum: TJ Tech Forum 06-06-2014, 06:35 PM
Replies: 13
Views: 372
Posted By gcan
I had mine 04 TJ aligned today, the driving has...

I had mine 04 TJ aligned today, the driving has been very swimmy. the caster started out at 3.7" for both sides and ended up 3.8".
My wife took it so I haven't spoken to the tech....but the sheet he...
Forum: TJ General Discussion Forum 05-24-2014, 07:09 AM
Replies: 12
Views: 606
Posted By gcan
okay thanks - your sig reads 2003 so I hoped it...

okay thanks - your sig reads 2003 so I hoped it would work in my 04
Forum: TJ General Discussion Forum 05-23-2014, 09:47 PM
Replies: 12
Views: 606
Posted By gcan
NoBoat 0429 - do you have a picture of this sub...

NoBoat 0429 - do you have a picture of this sub in your jeep?

I have a 2004 X and my back bench seat has no room under....I checked the measurements and I do not have enough room to just slip...
Showing results 1 to 25 of 93

 
Forum Jump

All times are GMT -5. The time now is 09:10 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC