Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 129
Search took 0.32 seconds.
Search: Keyword(s): ; Posts Made By: AdamLC
Forum: TJ Tech Forum Yesterday, 09:32 PM
Replies: 3
Views: 66
Posted By AdamLC
Refrigerant will usually come out when you...

Refrigerant will usually come out when you disconnect and will kinda boil off and dissipate after. Could you hear it leaking out afterward? You can replace the valve in there. It's like a tire valve...
Forum: TJ Tech Forum 06-29-2014, 06:14 PM
Replies: 4
Views: 112
Posted By AdamLC
The important pressure is when compressor is on....

The important pressure is when compressor is on. You were probably pretty low for it to not actuate the low press switch and just for reference it should use about 20oz of refrigerant. If completely...
Forum: TJ Tech Forum 06-29-2014, 11:38 AM
Replies: 4
Views: 112
Posted By AdamLC
I recently went through the gauntlet with my ac...

I recently went through the gauntlet with my ac and it started out the same. A/C switched on and fan blows but nothing cold. Compressor wouldn't come on. I jumpered the low side pressure switch...
Forum: TJ General Discussion Forum 06-27-2014, 09:41 PM
Replies: 8
Views: 429
Posted By AdamLC
I was getting 10 mpg out of my 03TJ with 35s,...

I was getting 10 mpg out of my 03TJ with 35s, 4.88s, and 4.0 among other things. I swapped out my two upstream O2 sensors and went to 12 :-/. Better than nothin.
Forum: TJ General Discussion Forum 06-09-2014, 05:07 PM
Replies: 2
Views: 164
Posted By AdamLC
I have a set of upper/lower rears. They are beefy...

I have a set of upper/lower rears. They are beefy as hell since they are solid bar stock drilled and threaded! I have only had them for a few month unfortunately but I'm happy thus far.
Forum: TJ General Discussion Forum 06-01-2014, 09:56 PM
Replies: 12
Views: 1,185
Posted By AdamLC
The NV3550 your jeep has doesn't have a vent hose...

The NV3550 your jeep has doesn't have a vent hose per-say. It's more like a vent wanna be check valve. My guess would be it works under the pretense when it gets warm in the trans it heats up a...
Forum: TJ Tech Forum 06-01-2014, 10:59 AM
Replies: 12
Views: 368
Posted By AdamLC
I guess it comes down to how much are you ready...

I guess it comes down to how much are you ready to invest? 200$ for SYE, and another 200$ for driveshaft unless you go with ZJ front driveshaft or equivalent and have it shortened. Couple hundred in...
Forum: TJ Tech Forum 05-31-2014, 11:58 PM
Replies: 12
Views: 368
Posted By AdamLC
What makes you think vibrations are from a bent...

What makes you think vibrations are from a bent main shaft. I assume you mean the rear output shaft for the TC. I've just never heard of it bending. Have you tried removing one or the other...
Forum: TJ Tech Forum 05-30-2014, 11:26 PM
Replies: 4
Views: 224
Posted By AdamLC
Sounds like what happens when the shifter is...

Sounds like what happens when the shifter is contacting the rear part of the center console on shifts. I would pull the shift boot and bezel and see if it's getting close. Then immediately throw your...
Forum: TJ Tech Forum 05-16-2014, 01:31 PM
Replies: 7
Views: 335
Posted By AdamLC
Two of these Fragola 900950 1 4 250 Padded Line...

Two of these Fragola 900950 1 4 250 Padded Line Hose Clamps Bag of 10 IMCA USRA | eBay (http://m.ebay.com/itm?itemId=390612527912). One big enough for the arm and other for the line. Bolt them to...
Forum: TJ Tech Forum 05-10-2014, 09:21 PM
Replies: 12
Views: 309
Posted By AdamLC
Big o easy out, replacement plug.

Big o easy out, replacement plug.
Forum: TJ General Discussion Forum 05-07-2014, 10:59 PM
Replies: 230
Views: 6,872
Posted By AdamLC
Knuckle knocker

Knuckle knocker
Forum: TJ Tech Forum 04-30-2014, 09:12 PM
Replies: 7
Views: 349
Posted By AdamLC
Damage to trac bar or brackets?

Damage to trac bar or brackets?
Forum: Oklahoma Jeep Forum 04-27-2014, 09:52 PM
Replies: 23
Views: 677
Posted By AdamLC
Cool, post a picture up when you get around to...

Cool, post a picture up when you get around to it! I did the swap over to fixed yoke on my transfer case last weekend and boy was that a task. But I took the case all the way out myself. Was a huge...
Forum: TJ Tech Forum 04-21-2014, 06:50 PM
Replies: 4
Views: 243
Posted By AdamLC
Whenever 1 goes it's always a good idea to...

Whenever 1 goes it's always a good idea to replace the other. One goes bad because of age the other is probably not far behind. Also if had a deteriorate brake hose be the culprit, breaking down from...
Forum: TJ Tech Forum 04-17-2014, 09:24 PM
Replies: 1
Views: 158
Posted By AdamLC
NP241 planetary, need some TC pros!

Planned on upgrading my np231 TC when I did my SYE so I got this used 241 planetary and the pictures weren't good enough to show this wear. Is this normal, will I be good to go. It looks like the...
Forum: TJ Tech Forum 03-30-2014, 10:33 PM
Replies: 20
Views: 750
Posted By AdamLC
I would be really curious to see what numbers you...

I would be really curious to see what numbers you get when you measure for lift and if you can find some part numbers on those springs or anything else. Only 6" skyjacker lift I can find comes with...
Forum: TJ Tech Forum 03-30-2014, 06:38 PM
Replies: 20
Views: 750
Posted By AdamLC
I'm sorry I was mistaken I got the incorrect...

I'm sorry I was mistaken I got the incorrect pitman arm from morris4x4. Pitman Arm, Power Steering (Left Hand Drive) - 52038337 (http://www.jeep4x4center.com/pitman-arm-52038337.html)
Forum: TJ Tech Forum 03-30-2014, 05:55 PM
Replies: 20
Views: 750
Posted By AdamLC
I would go back stock if I were you. I went back...

I would go back stock if I were you. I went back to a stock pitman arm after buying my jeep with a dropped one on it. I made the mistake of buying an OEM one from quadratech and got one that was...
Forum: TJ Tech Forum 03-29-2014, 09:43 PM
Replies: 30
Views: 1,176
Posted By AdamLC
Same problem here. Wonder how many more there are...

Same problem here. Wonder how many more there are out there.
Forum: TJ General Discussion Forum 03-28-2014, 09:34 PM
Replies: 16
Views: 438
Posted By AdamLC
I'm at 10 mpg :-(, thank god I live close to work.

I'm at 10 mpg :-(, thank god I live close to work.
Forum: Oklahoma Jeep Forum 03-23-2014, 12:15 AM
Replies: 23
Views: 677
Posted By AdamLC
P

I'm in Midwest city. I don't venture out to far since I have another vehicle that gets better than the 10 mpg the jeep does.
Forum: Oklahoma Jeep Forum 03-22-2014, 04:29 PM
Replies: 23
Views: 677
Posted By AdamLC
Well had a good day and got my C&C fab hood line...

Well had a good day and got my C&C fab hood line tube fenders on, if ya see me around wave.

http://i133.photobucket.com/albums/q49/ImplodedMindZ/2355171ba85d324e24d3a9f2cc9a7d3b_zps5effaa72.jpg
Forum: TJ General Discussion Forum 03-21-2014, 11:19 PM
Replies: 8
Views: 430
Posted By AdamLC
I just lifted up my seat 1.25" and solved my...

I just lifted up my seat 1.25" and solved my elbow placement issue and have a better view to boot.
Forum: TJ General Discussion Forum 03-18-2014, 09:22 PM
Replies: 28
Views: 1,817
Posted By AdamLC
My first thought as well. I kinda felt the same...

My first thought as well. I kinda felt the same way with my jeep that came w/ a 3.5" lift when I first got it. It had a dropped pitman arm, After a little reading and a stock pitman arm I was a much...
Showing results 1 to 25 of 129

 
Forum Jump

All times are GMT -5. The time now is 01:09 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC