Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 250
Search took 0.22 seconds.
Search: Keyword(s): ; Posts Made By: Wattapunk
Forum: TJ Tech Forum Today, 01:31 PM
Replies: 12
Views: 343
Posted By Wattapunk
You can easily and cheaply fixed that by adding a...

You can easily and cheaply fixed that by adding a 1.25" body lift to your current 2.5" SL.
OP, your torque spec for the front track bar to axle is incorrect. The front track bar to axle should be...
Forum: TJ Tech Forum 05-22-2015, 04:36 PM
Replies: 12
Views: 343
Posted By Wattapunk
A 2.5" lift is not enough for 33's.Are you...

A 2.5" lift is not enough for 33's.Are you running sway bar disconnects or extended swaybar end links for the lift?
I would check swaybar bushings and sway bar end links. Both will cause popping...
Forum: TJ General Discussion Forum 05-22-2015, 07:23 AM
Replies: 21
Views: 733
Posted By Wattapunk
I would find it very hard to believe that 15"...

I would find it very hard to believe that 15" wheels are being phased out. Consider the vast amount of older street driven vehicles/trucks that run 15" wheels and the makes and models of vehicles...
Forum: TJ General Discussion Forum 05-22-2015, 06:33 AM
Replies: 8
Views: 358
Posted By Wattapunk
How high was the lift and any parts to compensate...

How high was the lift and any parts to compensate for the increase in driveline angle?
Forum: TJ General Discussion Forum 05-22-2015, 06:29 AM
Replies: 12
Views: 414
Posted By Wattapunk
x2. The plastic strip of the top clips into the...

x2. The plastic strip of the top clips into the groove of the windshield header channel. The channel clamps down on top of the Jeep's windshield rubber strip.
You need this:
Forum: TJ Tech Forum 05-21-2015, 03:54 PM
Replies: 7
Views: 422
Posted By Wattapunk
I do the tape measure route : Basic Jeep Front...

I do the tape measure route :
Basic Jeep Front End Alignment (http://www.4x4xplor.com/alignment.html)
Forum: TJ Tech Forum 05-21-2015, 11:03 AM
Replies: 9
Views: 389
Posted By Wattapunk
X3..I'm pretty sure Ravines are 15x8.

X3..I'm pretty sure Ravines are 15x8.
Forum: TJ Tech Forum 05-21-2015, 09:07 AM
Replies: 24
Views: 539
Posted By Wattapunk
The flap you are probably referring to is called...

The flap you are probably referring to is called a blend door but it's function is mainly tied to the temp controls, not vent selection. Vent selection is controlled by 3 vacuum actuators located...
Forum: TJ General Discussion Forum 05-21-2015, 08:16 AM
Replies: 14
Views: 736
Posted By Wattapunk
^^ This pretty much says it all.

^^ This pretty much says it all.
Forum: TJ Tech Forum 05-20-2015, 06:45 AM
Replies: 3
Views: 321
Posted By Wattapunk
x2.. ...

x2..

https://www.youtube.com/watch?v=DitvjtmnhPc
Forum: TJ Tech Forum 05-20-2015, 06:40 AM
Replies: 7
Views: 422
Posted By Wattapunk
Luckily checking and setting a TJ's alignment...

Luckily checking and setting a TJ's alignment takes less than 30mins using a tape measure and some basic hand tools. I try to check it every 6 mos to prevent uneven tire wear.
Forum: TJ Tech Forum 05-20-2015, 06:35 AM
Replies: 7
Views: 274
Posted By Wattapunk
FSM calls for oil pressure at idle to be around...

FSM calls for oil pressure at idle to be around 13psi for both 4cyl and 6cyl.
Forum: TJ Tech Forum 05-19-2015, 07:22 AM
Replies: 22
Views: 706
Posted By Wattapunk
Add a failing harmonic balancer to another item...

Add a failing harmonic balancer to another item to look for that can cause shakes at higher rpms.
Forum: TJ Tech Forum 05-19-2015, 07:04 AM
Replies: 14
Views: 401
Posted By Wattapunk
With the actuator motor disconnected but wiring...

With the actuator motor disconnected but wiring still connected, you should see it move while you change the temp knob. You might be able to reach up in there and manually turn the end of the blend...
Forum: TJ General Discussion Forum 05-19-2015, 06:33 AM
Replies: 21
Views: 690
Posted By Wattapunk
I initially bought my TJ as a weekend vehicle a...

I initially bought my TJ as a weekend vehicle a few yrs back but now it's my daily driver while the Tacoma sits in the garage. I say buy a stock TJ and build how you like it because you just don't...
Forum: TJ General Discussion Forum 05-19-2015, 06:22 AM
Replies: 6
Views: 322
Posted By Wattapunk
You gave several reasons financially to not buy...

You gave several reasons financially to not buy it. Go with your gut feeling and just keep your Jeep, have some savings as an emergency fund, and just use that money to build your Jeep? You don't...
Forum: TJ Tech Forum 05-17-2015, 09:03 AM
Replies: 22
Views: 706
Posted By Wattapunk
The first thing you need to do is get your tires...

The first thing you need to do is get your tires balanced , rotated, and check the alignment before looking into other causes.
Forum: TJ Tech Forum 05-17-2015, 08:59 AM
Replies: 4
Views: 345
Posted By Wattapunk
Your best bet sell your set and get new wheels....

Your best bet sell your set and get new wheels. You will be hard pressed to find smaller diameter tires that are wide. The next size down would be 32x11.5s. If you are currently geared for 33's, then...
Forum: TJ Tech Forum 05-14-2015, 11:38 AM
Replies: 8
Views: 612
Posted By Wattapunk
X2 along with getting out a tape measure and...

X2 along with getting out a tape measure and check the toe in alignment.
Forum: TJ General Discussion Forum 05-14-2015, 11:33 AM
Replies: 29
Views: 908
Posted By Wattapunk
In north TX, I usually see them on CL from...

In north TX, I usually see them on CL from $1k-$1200 but they tend to take awhile to sell. I think $800 would be a fair asking price and anything below that tends to sell pretty fast. People may...
Forum: TJ Tech Forum 05-14-2015, 08:59 AM
Replies: 6
Views: 276
Posted By Wattapunk
If you don't have one, go rent a compression...

If you don't have one, go rent a compression tester from an auto parts store and check the compression.
Forum: TJ Tech Forum 05-14-2015, 07:21 AM
Replies: 14
Views: 401
Posted By Wattapunk
It sounds like a blend door issue, which controls...

It sounds like a blend door issue, which controls the air temp. You can try backflushing the core first but my guess is either a broken blend door lever or hopefully in your case, a bad actuator. ...
Forum: TJ General Discussion Forum 05-13-2015, 12:17 PM
Replies: 3
Views: 210
Posted By Wattapunk
There are plenty of businesses that offer...

There are plenty of businesses that offer pre-purchase auto inspections for a fee. You may even try to call a local shop that deals with Jeeps and see how much they would charge to drive a Jeep over...
Forum: General Jeep Discussion 05-11-2015, 09:16 PM
Replies: 12
Views: 404
Posted By Wattapunk
Go online to Quadratec website and search " Skid...

Go online to Quadratec website and search " Skid row offroad top prop". A mod that stretches the top taut so it doesn't flap and pool water. For about $45, still cheaper than upgrading a new top....
Forum: TJ General Discussion Forum 05-11-2015, 08:55 AM
Replies: 13
Views: 798
Posted By Wattapunk
Is it wrong I spent more time salivating on the...

Is it wrong I spent more time salivating on the next pics with the burgers? Oh yeah, agree with others, surface rust.
Showing results 1 to 25 of 250

 
Forum Jump

All times are GMT -5. The time now is 05:48 PM.


User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2015 DragonByte Technologies Ltd.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC