Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 249
Search took 0.31 seconds.
Search: Keyword(s): ; Posts Made By: CHL
Forum: YJ Tech Forum 08-19-2014, 01:34 AM
Replies: 8
Views: 174
Posted By CHL
Mine's the same way too.

Mine's the same way too.
Forum: YJ Tech Forum 08-17-2014, 09:29 PM
Replies: 16
Views: 210
Posted By CHL
Thanks shelby. Ok, no air. "if you plan on...

Thanks shelby. Ok, no air.

"if you plan on keeping the YJ for a long time, it might be worth keeping an eye open for an external slave setup from a 94+ YJ". That's good to know, I'll keep...
Forum: YJ Tech Forum 08-17-2014, 09:06 PM
Replies: 16
Views: 210
Posted By CHL
I just got back from picking up the new cmc and...

I just got back from picking up the new cmc and some Prestone synthetic brake and clutch dot 4 fluid. It says it can be used instead of dot 3 but has a higher boiling point.
I think I'll change it...
Forum: YJ Tech Forum 08-17-2014, 08:44 AM
Replies: 16
Views: 210
Posted By CHL
Should I try blowing air through the line while...

Should I try blowing air through the line while it's disconnected at both ends?
Forum: YJ Tech Forum 08-17-2014, 07:29 AM
Replies: 16
Views: 210
Posted By CHL
I'm not dropping the transmission first, I'm...

I'm not dropping the transmission first, I'm going to replace the clutch master cylinder first and see if that's the problem.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Hey Mr. White, my local...
Forum: YJ Tech Forum 08-17-2014, 07:13 AM
Replies: 16
Views: 210
Posted By CHL
Ok, the cheapest I found was around 40.00 but...

Ok, the cheapest I found was around 40.00 but I'll check autozone. Thanks for the bleeding tip and all the info you've helped me with.

Greg
Forum: YJ Tech Forum 08-17-2014, 06:23 AM
Replies: 16
Views: 210
Posted By CHL
Thanks again Mr. White. I've looked over...

Thanks again Mr. White.
I've looked over everything and been reading a lot of info on this subject. One thing I haven't seen is, can I leave the master cylinder cap off while I do the bleeding...
Forum: YJ Tech Forum 08-16-2014, 07:10 PM
Replies: 16
Views: 210
Posted By CHL
Thanks shelby, I'll get some help. I read today,...

Thanks shelby, I'll get some help. I read today, if bleeding doesn't help, then change out the master first and see if that fixes the problem. I read it can be bad even without any leaks. If that...
Forum: YJ Tech Forum 08-16-2014, 03:37 PM
Replies: 16
Views: 210
Posted By CHL
Thanks for the help Mr White. I didn't find any...

Thanks for the help Mr White. I didn't find any leaks and the fluid level looks fair. My master cylinder has already been replaced before and the replacement doesn't have a full line indicator inside...
Forum: YJ Tech Forum 08-16-2014, 07:35 AM
Replies: 16
Views: 210
Posted By CHL
Another possible clutch problem question

Sometimes when I start my YJ it starts to move, even with the clutch depressed all the way. It does this when started in reverse also.

This is a 91, 4.0, ax-15.
Forum: YJ Tech Forum 08-09-2014, 02:43 AM
Replies: 4
Views: 148
Posted By CHL
That's why I told you to scroll down to the parts...

That's why I told you to scroll down to the parts list, not stop at the diagram. Try my link again and keep scrolling down. Like the other posted stated, you're looking for 'tie rod ends'.
Forum: YJ Tech Forum 08-09-2014, 02:32 AM
Replies: 3
Views: 247
Posted By CHL
I did a fast search and spline count didn't...

I did a fast search and spline count didn't factor in, just the years.

Look here, Morris 4x4 Center - SearchMorris 4x4 Center - Results for drop pitman arm...
Forum: YJ Tech Forum 08-08-2014, 02:27 AM
Replies: 4
Views: 148
Posted By CHL
Try the following link and scroll down for the...

Try the following link and scroll down for the parts list and keep scrolling to #13, then you'll start seeing the tie rod ends.

Jeep Wrangler YJ Steering Parts & Accessories at Morris 4x4 Center...
Forum: YJ Tech Forum 07-20-2014, 04:32 PM
Replies: 12
Views: 608
Posted By CHL
Thanks CyndiB.

Thanks CyndiB.
Forum: YJ Tech Forum 07-18-2014, 09:55 AM
Replies: 4
Views: 136
Posted By CHL
My 91 fender flare lights work as turn signals...

My 91 fender flare lights work as turn signals too.
Forum: YJ Tech Forum 07-17-2014, 11:27 PM
Replies: 12
Views: 608
Posted By CHL
I like that link, cause it has pics too:). But...

I like that link, cause it has pics too:). But it's for Cjs or is most of it the same as a Yj?
Forum: YJ Tech Forum 07-13-2014, 01:02 PM
Replies: 4
Views: 146
Posted By CHL
Sounds like you have the right turn signal wire...

Sounds like you have the right turn signal wire and the brake light wires reversed. I'd try switching them.
Forum: YJ Tech Forum 07-11-2014, 07:09 PM
Replies: 19
Views: 561
Posted By CHL
Is this only for 95s or all yjs?

Is this only for 95s or all yjs?
Forum: YJ Tech Forum 07-09-2014, 06:07 AM
Replies: 1
Views: 207
Posted By CHL
Those are Mickey Thompson Classic Locks with red...

Those are Mickey Thompson Classic Locks with red beadlock rings.

http://i32.photobucket.com/albums/d3/CoolHandLucas/2011-06-28_17-36-11_298_zps22dc2985.jpg...
Forum: YJ Tech Forum 07-05-2014, 03:31 PM
Replies: 3
Views: 204
Posted By CHL
Just trying to be helpful here. Sorry, I...

Just trying to be helpful here.

Sorry, I don't know what the problem is, but I searched 'backfire' and there's a few threads. Here's the link for my search results....
Forum: YJ Tech Forum 07-05-2014, 03:16 PM
Replies: 5
Views: 190
Posted By CHL
Also there's a horn relay to check, that's why my...

Also there's a horn relay to check, that's why my horn didn't work. Mine was tucked way up under the dash, above the fuse panel.
Forum: YJ Tech Forum 06-26-2014, 01:32 PM
Replies: 4
Views: 198
Posted By CHL
The engine compartment 'light' should be mounted...

The engine compartment 'light' should be mounted on the bottom of the hood where the two holes are above your green arrow. That plug is probably for the light.
Forum: YJ Tech Forum 06-01-2014, 07:22 PM
Replies: 10
Views: 237
Posted By CHL
Cool, I'm not sure which fuse it is either.

Cool, I'm not sure which fuse it is either.
Forum: YJ Tech Forum 05-31-2014, 06:46 AM
Replies: 10
Views: 237
Posted By CHL
Above the fusebox, mine was just wrapped around...

Above the fusebox, mine was just wrapped around another group of wires. Try using a mirror to look up above the fuse box.
Forum: YJ Tech Forum 05-31-2014, 05:58 AM
Replies: 7
Views: 369
Posted By CHL
I have the same small rips on mine too. I was...

I have the same small rips on mine too. I was wondering if iron-on denim patches would work? I just haven't tried it yet.
Showing results 1 to 25 of 249

 
Forum Jump

All times are GMT -5. The time now is 02:22 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC