Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 15 of 15
Search took 0.30 seconds.
Search: Keyword(s): ; Posts Made By: Tj1
Forum: TJ Tech Forum 07-06-2014, 11:30 AM
Replies: 1
Views: 116
Posted By Tj1
Need advice on electrical for 98 4.0L

OK, I would like to hear any ideas on how to prevent my 98 from chugged and coughing like its miss firing when riding the trails and go through a large water hole. Im not drowning it past the intake...
Forum: TJ Tech Forum 06-27-2014, 09:12 PM
Replies: 6
Views: 228
Posted By Tj1
Im going through the same problems on my 98. I...

Im going through the same problems on my 98. I left for work and it got about half mile down the road and started chugging and dropping power. Couldnt get above 40 mph. The motor was up to temp and...
Forum: TJ Tech Forum 05-31-2014, 03:01 AM
Replies: 5
Views: 210
Posted By Tj1
if its not the switch then you have a short...

if its not the switch then you have a short somewhere
Forum: TJ Tech Forum 05-31-2014, 02:59 AM
Replies: 19
Views: 980
Posted By Tj1
over the weekend I replaced dash speakers with...

over the weekend I replaced dash speakers with new 5.25" kickers with Nalin brackets, replaced the sound bar speakers, and installed a 4 channel amp to power them all. day and night difference even...
Forum: TJ Tech Forum 05-01-2014, 03:53 AM
Replies: 6
Views: 238
Posted By Tj1
with the 2" you shouldn't need a sye yet. hows...

with the 2" you shouldn't need a sye yet. hows your pinion angle?
Forum: TJ Tech Forum 04-15-2014, 01:34 AM
Replies: 33
Views: 908
Posted By Tj1
yeah I don't run her at much over 60 mph...

yeah I don't run her at much over 60 mph otherwise it vibrates more than it should. the 8.8 isn't really beneficial for a daily driver... great for offroading though!
Forum: TJ Tech Forum 04-14-2014, 04:17 AM
Replies: 33
Views: 908
Posted By Tj1
the pig on a 8.8 is offset to the passenger side...

the pig on a 8.8 is offset to the passenger side by about 4 inches. your drive shaft is under stress due to two angles to fight. I had to put in u-joints, o-rings, seals, flanges, and new cv style...
Forum: TJ Tech Forum 04-14-2014, 04:13 AM
Replies: 16
Views: 672
Posted By Tj1
the NP231's chains like to stretch after time and...

the NP231's chains like to stretch after time and miles. I also would recommend the Novak shifter
Forum: Michigan Jeep Forum 02-08-2014, 08:38 AM
Replies: 2
Views: 398
Posted By Tj1
There's a guy I met at the bleesing who has a...

There's a guy I met at the bleesing who has a shop in Coopersville. He knows his stuff, Jeff Lanting. He has a monster YJ, running 44 boggers...
Forum: TJ Tech Forum 11-24-2013, 08:08 AM
Replies: 7
Views: 730
Posted By Tj1
I've had bad bushings on both lower/upper in the...

I've had bad bushings on both lower/upper in the rear and front uppers. I had someone inside with the brake applied and shifting from Reverse to Drive (4.0 w/ Auto trans), you could see the whole...
Forum: TJ General Discussion Forum 05-22-2013, 12:21 PM
Replies: 4
Views: 351
Posted By Tj1
My pinion is set at 2║ below transfer case out...

My pinion is set at 2║ below transfer case out put. Recently installed a new set of adjustable control arms due to worn bushing at the axle.
Forum: TJ General Discussion Forum 05-22-2013, 11:21 AM
Replies: 4
Views: 351
Posted By Tj1
issues with 8.8

I've been fighting extra vibrations in my TJ for a while now and found an offroad specialty shop and they told me my rear drive shaft had two angles between tranfer case and rear yoke. Is the ford...
Forum: TJ General Discussion Forum 01-20-2013, 07:12 AM
Replies: 0
Views: 1,164
Posted By Tj1
TJ drop down tailgate conversion kit

Thinking for a early spring project I want to convert my swing out to a drop down and seen they have kits online from swag and poison spider but I dont want to pay that much. Any other places that...
Forum: TJ Tech Forum 10-16-2012, 05:07 AM
Replies: 0
Views: 216
Posted By Tj1
Help! problems with temp gage/shifting into 4th!

Running a 98 TJ with 4.0l and automatic tranny. Recently noticed it wasn't shifting into 4 gear on certain mornings. Also the temp gage on panel never moves. When the temp gage operates normal, it...
Forum: General Jeep Discussion 03-03-2012, 07:50 PM
Replies: 3
Views: 826
Posted By Tj1
Noise from rear end?

I have a 98 tj with 3 inch body, 4 inch suspension, running 35's and ford 8.8 axles. Having lots of heavy vibrations and a clunking noise from what I assume is the rear end. Clunking is more...
Showing results 1 to 15 of 15

 
Forum Jump

All times are GMT -5. The time now is 06:46 AM.



Jeep«, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC