Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 249
Search took 0.31 seconds.
Search: Keyword(s): ; Posts Made By: MarkNog
Forum: TJ Tech Forum 06-05-2014, 04:53 PM
Replies: 12
Views: 395
Posted By MarkNog
I run 35's on my 4.0, 42rle, 8.8 & hp30 - 4.88...

I run 35's on my 4.0, 42rle, 8.8 & hp30 - 4.88 ratio and just have a zj tierod for now.

I haven't had any issues with it, but in the future there are plans for a new custom panhard ban and...
Forum: TJ Tech Forum 06-03-2014, 03:51 PM
Replies: 16
Views: 497
Posted By MarkNog
Not to criticize, this is strictly information...

Not to criticize, this is strictly information I've gathered over the course of setting up my 8.8 to run 4.88s, LSD, stock shafts, and 35s.

Driveline vibes only occur when setup improperly, mines...
Forum: TJ General Discussion Forum 01-16-2014, 07:36 PM
Replies: 3
Views: 246
Posted By MarkNog
Find them as cheap as you can online and give...

Find them as cheap as you can online and give Summit Racing a call, I got a set of 3" lift shocks for 300 to my door 3 days later through them last summer.

If not, I've never had a problem with...
Forum: New Jersey Jeep Forum 01-07-2014, 08:52 PM
Replies: 4
Views: 459
Posted By MarkNog
Yeah, jackson... the only reed I know of around...

Yeah, jackson... the only reed I know of around here.
Forum: TJ Tech Forum 01-03-2014, 03:59 PM
Replies: 25
Views: 937
Posted By MarkNog
Buy the rears, clean em up, and let em sit until...

Buy the rears, clean em up, and let em sit until you can afford to do the gears. It's much easier to do em on jackstands than in the dirt under the jeep. Once ya get the gears done, then slap em...
Forum: New Jersey Jeep Forum 12-29-2013, 11:40 PM
Replies: 4
Views: 459
Posted By MarkNog
Reed Road

Has anyone ever seen a ranger back there before? I'm just curios because I may set up a few camping trips back there this summer.
Forum: Builders Corner 12-22-2013, 10:19 PM
Replies: 3
Views: 383
Posted By MarkNog
37s are definitely doable on an 8.8 as long as...

37s are definitely doable on an 8.8 as long as your hammering the peddle when your in a pinch. (super88 for peace of mind) But if your on 37s already, I would be more worrier about building a heavier...
Forum: TJ General Discussion Forum 12-18-2013, 11:00 PM
Replies: 20
Views: 1,204
Posted By MarkNog
Old thread bump, but can someone post some close...

Old thread bump, but can someone post some close up pictures of the properly installed header from the outside, with or without the top on. Having a conversation over 50 is difficult because of the...
Forum: TJ Tech Forum 08-06-2013, 09:02 PM
Replies: 10
Views: 414
Posted By MarkNog
In case you need more... JKS just uses a 3/16s...

In case you need more... JKS just uses a 3/16s hitch pin to hold the bottom on their disconnect on the axle side, I got 2 extras (just incase) at tractor supply for $.99 each when I was in their one...
Forum: TJ General Discussion Forum 07-04-2013, 06:29 PM
Replies: 21
Views: 1,118
Posted By MarkNog
Buy spicer joints not the cheapo parts store...

Buy spicer joints not the cheapo parts store special.
Forum: TJ Tech Forum 06-30-2013, 09:44 PM
Replies: 37
Views: 1,316
Posted By MarkNog
Ford 8.8 and Cherokee high pinion dana 30 front...

Ford 8.8 and Cherokee high pinion dana 30 front with 4.10s right out of the boneyard. Not perfect for 35s, but stronger axles and lower gears for less than a grand if done cheap.
Forum: TJ Tech Forum 06-30-2013, 09:25 PM
Replies: 37
Views: 1,316
Posted By MarkNog
The most talked about thing on this forum is the...

The most talked about thing on this forum is the dana 35... If you take it in the woods at all, get a super 35 kit, a dana 44, or a ford 8.8 (weakest to strongest)
...
Forum: TJ General Discussion Forum 06-27-2013, 09:27 PM
Replies: 20
Views: 866
Posted By MarkNog
JB Conversions, Inc....

JB Conversions, Inc. (http://www.jbconversions.com/products/sye/np231j_short_sye.php)

Scroll down on the page, that should explain a lot of it. If you driveshaft hits the skid at full drool you...
Forum: New Jersey Jeep Forum 06-06-2013, 06:01 PM
Replies: 2
Views: 484
Posted By MarkNog
I'm not a fan of lockrites, but yes it will...

I'm not a fan of lockrites, but yes it will holdup. I'd go aussie...
Forum: General Jeep Discussion 06-06-2013, 05:56 PM
Replies: 3
Views: 194
Posted By MarkNog
Looks like he made a mess of the shorter one.......

Looks like he made a mess of the shorter one.... and just confirming, you know you need a Dana 35 30 spline carrier to run those.
Forum: General Jeep Discussion 06-06-2013, 05:53 PM
Replies: 4
Views: 484
Posted By MarkNog
Proper front/rear recovery points and gear if you...

Proper front/rear recovery points and gear if you plan on going in the woods. Then you can worry about the rest...
Forum: General Jeep Discussion 06-06-2013, 05:51 PM
Replies: 32
Views: 1,157
Posted By MarkNog
I know NJ law is that you need a 3rd break light...

I know NJ law is that you need a 3rd break light cause I've thought about removing mine. I'd look into it before takin out the tools.
Forum: JK General Discussion Forum 05-29-2013, 10:19 PM
Replies: 69
Views: 3,584
Posted By MarkNog
Watch this video, makes me want a new unlimited,...

Watch this video, makes me want a new unlimited, but I would get a unlimited sport andswap out the rears to something heavier than 44s with that size budget....

HEARTLAND : The 2012 JK-Experience...
Forum: TJ General Discussion Forum 05-15-2013, 09:16 PM
Replies: 72
Views: 2,968
Posted By MarkNog
My 31x10.50 duratracs are great, but ill be...

My 31x10.50 duratracs are great, but ill be getting something a little more aggressive when I upgrade.
Forum: TJ General Discussion Forum 04-28-2013, 04:15 PM
Replies: 119
Views: 5,337
Posted By MarkNog
This summer when I get back from college, my plan...

This summer when I get back from college, my plan for 35's entail...


Ford 8.8
- Full rebuild
- Trussed/bracketed
- Rebuilt limited slip
- 4.56 gearing
- New rotors, calipers, and pads...
Forum: TJ General Discussion Forum 04-11-2013, 07:46 PM
Replies: 22
Views: 1,080
Posted By MarkNog
I'd go with the jks 1.25 inch body lift and a...

I'd go with the jks 1.25 inch body lift and a brown dog 1" rubber motor mount lift.

NO TCASE DROP
NO DEATH WOBBLE

This will leave the stock suspension geometry and leave you with a good ride....
Forum: YJ Build Forum 03-17-2013, 10:58 PM
Replies: 10
Views: 584
Posted By MarkNog
8.8 rear with 4.10s from the boneyard $100-200 ...

8.8 rear with 4.10s from the boneyard $100-200
spring over axle with stock leafs - $100
15x8 (or 10) steel wheels - $250
35 inch tires - 900
SYE - $200 from advanced adapters
Cherokee front...
Forum: TJ General Discussion Forum 03-17-2013, 08:06 PM
Replies: 12
Views: 546
Posted By MarkNog
Woln't fit. Your rubicon has a dana 44 front...

Woln't fit. Your rubicon has a dana 44 front axle, these are for a dana 30.

Rubicon has 30 spline axles(1.31 inch), while other tjs have 27 spline (1.18 inch)
Forum: TJ General Discussion Forum 03-17-2013, 08:00 PM
Replies: 8
Views: 751
Posted By MarkNog
Something like this? Full Float Rear Axle...

Something like this?

Full Float Rear Axle Conversion Kit Dana 35 Warn W61750 (http://www.jeep4x4center.com/full-float-rear-axle-conversion-kit-dana-35-warn-w61750.html)

I'd never heard of a...
Forum: TJ General Discussion Forum 03-14-2013, 05:19 PM
Replies: 14
Views: 554
Posted By MarkNog
Take it out of the box and leave it out in the...

Take it out of the box and leave it out in the sun for awhile and the install will be much less tight
Showing results 1 to 25 of 249

 
Forum Jump

All times are GMT -5. The time now is 04:25 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC