Jeep Wrangler Forum - Search Results

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today



Showing results 1 to 25 of 156
Search took 0.18 seconds.
Search: Keyword(s): ; Posts Made By: mbaseel
Forum: YJ General Discussion Forum 07-29-2015, 03:24 PM
Replies: 10
Views: 628
Posted By mbaseel
I have 33's and usually shift around 3200 rpm....

I have 33's and usually shift around 3200 rpm. Average mpg is 13-14, usually run 4th at 2200 rpm at 65 mph. Swapped in an 8.8 with a 4.10 gear tag and it actually had 3.27 gears. I haven't seen 5th...
Forum: YJ General Discussion Forum 04-21-2015, 02:54 AM
Replies: 7
Views: 549
Posted By mbaseel
Thanks for the help everyone. It looks like it is...

Thanks for the help everyone. It looks like it is toast. Going to have it built now for towing. Monster sun shell, bigger valve body, bigger Pistons, shift kit, bigger clutch packs, etc. pretty much...
Forum: YJ General Discussion Forum 04-17-2015, 01:56 AM
Replies: 7
Views: 549
Posted By mbaseel
Thanks for the reply fanatic. I guess I will have...

Thanks for the reply fanatic. I guess I will have to call a couple of shops in the morning just to be sure. Do you have any idea if the 4l80e is directly swappable? I assume it's a little heavier...
Forum: YJ General Discussion Forum 04-17-2015, 12:55 AM
Replies: 7
Views: 549
Posted By mbaseel
4l60e problems

Hey guys I didn't know where else to go with this at the moment and figured that there may be someone that has some advice on a 4l60e trans. I have a k1500 2004 suburban as my other vehicle. I was...
Forum: YJ General Discussion Forum 02-25-2015, 08:18 PM
Replies: 10
Views: 759
Posted By mbaseel
Yes you have to gear both axles to run 4x4. I...

Yes you have to gear both axles to run 4x4. I don't plan on keeping my dana 30 for long so when I regeared I only did the rear and I just took the front drive shaft off. You can always run different...
Forum: YJ General Discussion Forum 02-25-2015, 08:07 PM
Replies: 10
Views: 759
Posted By mbaseel
The parts for regearing are pretty easy. Gears...

The parts for regearing are pretty easy. Gears and a master install kit. If you have never done gears I wouldn't recommend doing them. I have rebuilt my whole engine and transmission and am in the...
Forum: YJ General Discussion Forum 02-25-2015, 07:58 PM
Replies: 4
Views: 521
Posted By mbaseel
Are we talking about cutting the plastic fender...

Are we talking about cutting the plastic fender flare or the sheet metal of the fender itself?
Forum: YJ General Discussion Forum 02-25-2015, 07:56 PM
Replies: 10
Views: 759
Posted By mbaseel
Colin does your 2.5l have a dana 44 rear axle...

Colin does your 2.5l have a dana 44 rear axle swap done to it?
Forum: YJ General Discussion Forum 02-06-2015, 10:13 AM
Replies: 7
Views: 663
Posted By mbaseel
Frame.

Frame.
Forum: YJ General Discussion Forum 02-03-2015, 02:13 PM
Replies: 4
Views: 567
Posted By mbaseel
Thanks Reno92 I will look in to the Borla header.

Thanks Reno92 I will look in to the Borla header.
Forum: YJ General Discussion Forum 02-03-2015, 12:31 PM
Replies: 4
Views: 567
Posted By mbaseel
I guess I should have clarified... I have the...

I guess I should have clarified... I have the 2000 y pipe in the garage from a previous wrangler. It has a o2 bung in it just like the one I have pictured. I was more curious about the bolt pattern...
Forum: YJ General Discussion Forum 02-03-2015, 01:09 AM
Replies: 3
Views: 460
Posted By mbaseel
I was able to fit 33's with tj flares and...

I was able to fit 33's with tj flares and trimming. The 33's rubbed on my yj flares when going around corners.

First picture is trimmed yj flares. Second picture is with tj flares.
Forum: YJ General Discussion Forum 02-03-2015, 01:04 AM
Replies: 4
Views: 567
Posted By mbaseel
Curious if anyone knows the difference between...

Curious if anyone knows the difference between these headers. I am building a stroker and have seen that the new torque tubes flow better than the old revolver headers. Is the only difference the o2...
Forum: YJ General Discussion Forum 01-25-2015, 04:36 PM
Replies: 7
Views: 439
Posted By mbaseel
Any updates?

Any updates?
Forum: YJ General Discussion Forum 01-22-2015, 06:54 PM
Replies: 7
Views: 439
Posted By mbaseel
I believe it's like somewhere in the 40psi range...

I believe it's like somewhere in the 40psi range at idle. But if it's over like 50psi at idle then the regulator is bad.
Forum: YJ General Discussion Forum 01-21-2015, 07:52 PM
Replies: 7
Views: 439
Posted By mbaseel
Sounds like a fuel pump problem. Sometimes when...

Sounds like a fuel pump problem. Sometimes when the back flow is warmer in the fuel pump it releases back flow easier. It then takes a bit to regain the pressure of the fuel lines. Hence the...
Forum: YJ General Discussion Forum 01-14-2015, 08:10 PM
Replies: 5
Views: 513
Posted By mbaseel
If it's out of an explorer it's 31 spline. If...

If it's out of an explorer it's 31 spline. If it's out of a ranger it's 28 spline. Don't know about the rest.
Forum: YJ General Discussion Forum 12-13-2014, 09:28 AM
Replies: 11
Views: 826
Posted By mbaseel
As Tom95yj said they are also military wrap. They...

As Tom95yj said they are also military wrap. They also have boom shackles to prevent your leafs from inverting when flexing.

You can see the front droop and the flex of the rear. 33" tire in these...
Forum: YJ General Discussion Forum 12-13-2014, 09:18 AM
Replies: 11
Views: 826
Posted By mbaseel
If you're just looking for a better price go for...

If you're just looking for a better price go for the 4". If you are looking for ride quality and ease of operation then go with the 4.5". Also look at the website and price everything out. With the...
Forum: YJ General Discussion Forum 12-13-2014, 09:11 AM
Replies: 11
Views: 826
Posted By mbaseel
I have this kit also. The only complaint I would...

I have this kit also. The only complaint I would have is that the shocks aren't long enough. There is about 1" of shock up-travel left when flexing but when you need droop the springs out perform the...
Forum: YJ General Discussion Forum 11-17-2014, 04:09 PM
Replies: 6
Views: 638
Posted By mbaseel
Rough country dual stabilizer mounts to the...

Rough country dual stabilizer mounts to the steering linkage. Look it up. It's like $100
Forum: YJ General Discussion Forum 09-08-2014, 12:28 AM
Replies: 3
Views: 416
Posted By mbaseel
To do an over bore you would have to take the...

To do an over bore you would have to take the block out and have it cleaned, bored and finish honed. This requires complete disassembly and re assembly. You would have to get a kit with pistons/rings...
Forum: YJ General Discussion Forum 08-30-2014, 04:01 PM
Replies: 11
Views: 520
Posted By mbaseel
I have 4 1/2" lift with 1" t-case drop and 1" Mml...

I have 4 1/2" lift with 1" t-case drop and 1" Mml from brown dog. No vibes. 33x12.50 km2's run 4th gear at 2400 rpm at 65 mph. Most hills in 3rd.

No sye, stock driveshafts, ford 8.8 rear. Only 1"...
Forum: YJ General Discussion Forum 07-28-2014, 07:29 PM
Replies: 5
Views: 445
Posted By mbaseel
No it will not. The 4 cylinder uses the ax5...

No it will not.

The 4 cylinder uses the ax5 light duty transmission with a 21 spline output shaft to a 21 spline input shaft on a np231 transfer case.

The 6 cylinder uses the ax15 transmission...
Forum: YJ General Discussion Forum 07-15-2014, 10:21 PM
Replies: 12
Views: 1,131
Posted By mbaseel
After installing the rough country 4.5" military...

After installing the rough country 4.5" military wrap lift I have been very satisfied. You could get the 4.5" kit for $550 and only use the springs. This kit is a 3" lift spring with a 1.5" boomerang...
Showing results 1 to 25 of 156

 
Forum Jump

All times are GMT -5. The time now is 10:55 AM.


User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC