Jeep Wrangler Forum - Search Results

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 250
Search took 0.23 seconds.
Search: Keyword(s): ; Posts Made By: Wheel2Work
Forum: TJ Tech Forum 05-29-2015, 11:37 AM
Replies: 2
Views: 266
Posted By Wheel2Work
I found that the problem was definitely the...

I found that the problem was definitely the Multifunction Switch. The FSM states that if any part of the switch fails continuity checks to replace the assembly.
The lesson learned for me was that I...
Forum: TJ Tech Forum 05-12-2015, 11:29 AM
Replies: 2
Views: 266
Posted By Wheel2Work
Intermittent hazards/turn signals

Need some help diagnosing a new to me 2002 wrangler X.

If conditions are dry everything works normally with the exception of the dash dimmer portion of the multifunction switch.

When it's...
Forum: TJ Tech Forum 09-06-2013, 06:37 PM
Replies: 17
Views: 871
Posted By Wheel2Work
http://66.147.244.94/~deltalig/instructions/Light_...

http://66.147.244.94/~deltalig/instructions/Light_Harness_Installation_Instructions.pdf

Try this wiring setup using the relay as shown. It should eliminate the blown fuses.
Forum: TJ General Discussion Forum 09-06-2013, 10:35 AM
Replies: 20
Views: 1,539
Posted By Wheel2Work
Tuffy Products makes a bolt locking cover that...

Tuffy Products makes a bolt locking cover that works on the winch plate.

318977
Forum: TJ Tech Forum 09-05-2013, 10:29 AM
Replies: 7
Views: 878
Posted By Wheel2Work
Turn the key to the ON position and check the...

Turn the key to the ON position and check the gauge. If it reads pressure without the engine running, it's definitely the sending unit.
Forum: TJ General Discussion Forum 08-10-2013, 07:30 PM
Replies: 9
Views: 720
Posted By Wheel2Work
You can use spray dye (Dupliciolor) to "fix" the...

You can use spray dye (Dupliciolor) to "fix" the carpet, but you have to use a darker shade for it to work. You'll never be able to match the color or cover stains unless you use the darker shade.
Forum: TJ General Discussion Forum 08-09-2013, 05:18 PM
Replies: 17
Views: 2,215
Posted By Wheel2Work
283882 This is one I built out of scraps....

283882

This is one I built out of scraps. The rise in the draw bar puts the bottom of the basket level with my spare.
Forum: TJ Tech Forum 08-09-2013, 05:06 PM
Replies: 4
Views: 407
Posted By Wheel2Work
Turn the key to the "on" position and watch the...

Turn the key to the "on" position and watch the gauge. If it reads more than zero with the engine off, you have a bad sending unit.
Forum: TJ Tech Forum 08-06-2013, 01:20 PM
Replies: 2
Views: 471
Posted By Wheel2Work
Check here - http://gearshade.com/

Check here - http://gearshade.com/
Forum: TJ Tech Forum 08-04-2013, 03:40 PM
Replies: 4
Views: 386
Posted By Wheel2Work
Has to be read with an OBD II code reader…...

Has to be read with an OBD II code reader… key trick won't work on your 99 and holding in the odometer reset only does an instrument cluster check.
Forum: TJ General Discussion Forum 08-03-2013, 09:18 AM
Replies: 2
Views: 493
Posted By Wheel2Work
Yes, that's the correct one.

Yes, that's the correct one.
Forum: TJ Tech Forum 08-03-2013, 09:15 AM
Replies: 14
Views: 1,381
Posted By Wheel2Work
Try this for the hardware...

Try this for the hardware http://www.quadratec.com/products/13122_01.htm

Lange has a couple of different quick connect kits for the hard tops.
Forum: TJ General Discussion Forum 07-31-2013, 11:08 AM
Replies: 3
Views: 398
Posted By Wheel2Work
5/8" dia shaft. You may have to go a little...

5/8" dia shaft. You may have to go a little bigger though, it's a tight fit!
Forum: TJ General Discussion Forum 07-29-2013, 05:08 PM
Replies: 7
Views: 533
Posted By Wheel2Work
Best thing to do is make sure the top is centered...

Best thing to do is make sure the top is centered and pliable. Then just stick it back on the channel I have the same problem with my bikini, but depending on which way it is off center that...
Forum: TJ Tech Forum 07-29-2013, 03:12 PM
Replies: 4
Views: 312
Posted By Wheel2Work
Try cleaning the throttle body, paying close...

Try cleaning the throttle body, paying close attention to the IAC, to help with the idle at startup.

Make sure the window to tailgate seal is in place and in good condition on the hardtop. The...
Forum: TJ Tech Forum 07-09-2013, 11:27 PM
Replies: 1
Views: 555
Posted By Wheel2Work
Mine will clunk like that when I need to grease...

Mine will clunk like that when I need to grease the upper track bar joint. Once it's properly lubed, the noise stops for several months/miles. It's an inconvenient reminder at times that I have...
Forum: TJ Tech Forum 06-24-2013, 09:06 PM
Replies: 6
Views: 385
Posted By Wheel2Work
I have those plastic pieces on the bottom of my...

I have those plastic pieces on the bottom of my Bestop Mirrors. You might try contacting them for replacement parts.
Forum: General Jeep Discussion 06-24-2013, 08:59 PM
Replies: 25
Views: 1,349
Posted By Wheel2Work
Not unless you leave it on all night without the...

Not unless you leave it on all night without the jeep running : D That's a sure way to kill the battery!
Forum: General Jeep Discussion 06-24-2013, 04:19 AM
Replies: 25
Views: 1,349
Posted By Wheel2Work
I have a 12V Electric Blanket instead… I...

I have a 12V Electric Blanket instead… I say let the passengers be as toasty as they want!
Forum: TJ General Discussion Forum 06-21-2013, 02:46 AM
Replies: 3
Views: 602
Posted By Wheel2Work
4.10's with the 3 speed auto and 33's

4.10's with the 3 speed auto and 33's
Forum: TJ General Discussion Forum 06-19-2013, 02:53 AM
Replies: 9
Views: 767
Posted By Wheel2Work
I used this one: MOPAR P/ N 5080861AA Fog Light...

I used this one: MOPAR P/ N 5080861AA Fog Light Switch
Forum: TJ Tech Forum 06-15-2013, 03:12 PM
Replies: 4
Views: 482
Posted By Wheel2Work
It's probably from the weep hole of the water...

It's probably from the weep hole of the water pump and running the length of the oil pan. That's where mine finally showed up, because of the engine and driveline angles.
Forum: TJ Tech Forum 06-15-2013, 02:22 PM
Replies: 12
Views: 3,385
Posted By Wheel2Work
I know it's an old thread, but I wanted to thank...

I know it's an old thread, but I wanted to thank all the contributors to it!

I didn't have a plug for my hose and it did draw all the fluid out of the reservoir while driving at highway speeds....
Forum: TJ General Discussion Forum 06-05-2013, 06:22 AM
Replies: 24
Views: 3,277
Posted By Wheel2Work
You can do it with the flares on the Jeep, but...

You can do it with the flares on the Jeep, but the applicator can be hard to control in tight areas. If it runs and you don't notice it right away, it will leave a black streak that's difficult to...
Forum: TJ General Discussion Forum 06-03-2013, 09:56 PM
Replies: 33
Views: 1,940
Posted By Wheel2Work
Bestop Element Doors w/o Bags, Satin Black Finish...

Bestop Element Doors w/o Bags, Satin Black Finish 51809-01 (http://www.jeep4x4center.com/element-doors-w-o-bags-black-51809-01.html)

They are a little more expensive, but they have built in...
Showing results 1 to 25 of 250

 
Forum Jump

All times are GMT -5. The time now is 08:46 AM.


User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2015 DragonByte Technologies Ltd.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC