Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 30
Search took 0.28 seconds.
Search: Keyword(s): ; Posts Made By: 87yjAR
Forum: YJ Tech Forum 07-09-2010, 10:19 PM
Replies: 3
Views: 434
Posted By 87yjAR
TJ Tank

Does anyone know if a TJ tank will fit under a YJ? I am swapping in an injected engine and will need the fuel pump assembly, etc. It seems like it would fit...
Forum: YJ Tech Forum 07-09-2010, 10:16 PM
Replies: 1
Views: 1,255
Posted By 87yjAR
Get yourself a good shop manual with skematics...

Get yourself a good shop manual with skematics for both vehicles. They will save you alot of frustration. I am currently swaping a small block Mopar into my 87. It takes some time and patience, but...
Forum: YJ Tech Forum 07-09-2010, 10:13 PM
Replies: 17
Views: 4,420
Posted By 87yjAR
I didn't notice in the thread. But make sure you...

I didn't notice in the thread. But make sure you get the 1.08 venturi Motorcraft 2100. They were found on small block(302/351W) engines. I found mine on ebay for $40. The adapter plate you need is...
Forum: YJ General Discussion Forum 07-06-2010, 06:03 PM
Replies: 2
Views: 2,434
Posted By 87yjAR
I'll check it out flatline. Thanks

I'll check it out flatline. Thanks
Forum: YJ General Discussion Forum 07-05-2010, 06:54 PM
Replies: 2
Views: 2,434
Posted By 87yjAR
5.2L and 46RH into a YJ

I am currently knee deep into an engine swap. The donor is a 5.2L and 46RH from a 95 Grand Cherokee. The recipient in my 87 YJ. The new engine and trans is hanging nicely between the framerails( 1/4...
Forum: YJ Tech Forum 12-31-2009, 08:11 PM
Replies: 14
Views: 6,359
Posted By 87yjAR
Motorcraft

I just pulled an EMPI that ran rich no matter what I di. Grabbed a motorcraft off ebay for about $40 including shipping. It is like a new Jeep. No more hesitation. I would highly recommend it, unless...
Forum: TJ Tech Forum 10-30-2008, 07:25 PM
Replies: 1
Views: 795
Posted By 87yjAR
TJ D 30 stock specs

I need to know what the stock unlifted specs for the TJ D30 are. Like the caster, camber, at what angle the upper and lower ball joints are from each other at ride height, etc. Thanks, guys.
Forum: YJ General Discussion Forum 10-26-2008, 07:17 PM
Replies: 19
Views: 870
Posted By 87yjAR
Spring over suspension is not stock equipment....

Spring over suspension is not stock equipment. They can be a bit squirrely. Your trackbar is gone. This should connect from the lower left of the front axle housing abd to the upper right on the...
Forum: YJ Tech Forum 10-26-2008, 07:08 PM
Replies: 7
Views: 3,058
Posted By 87yjAR
Also, torx bolts suck. Be sure to get several...

Also, torx bolts suck. Be sure to get several sockets because you will twist or break a few removing the cage bolts.
Forum: YJ Tech Forum 10-26-2008, 07:04 PM
Replies: 7
Views: 3,058
Posted By 87yjAR
Believe it or not...I bolted a TJ cage into my...

Believe it or not...I bolted a TJ cage into my 87. It tool a couple of drilled holes is all. When you say flat fenders do you mean tube style fenders?
Forum: TJ General Discussion Forum 10-21-2008, 10:03 PM
Replies: 2
Views: 1,299
Posted By 87yjAR
Thankx Monday

Thankx Monday
Forum: TJ General Discussion Forum 10-19-2008, 07:21 PM
Replies: 2
Views: 1,299
Posted By 87yjAR
Stock coil springs height

Does any one know what the length/height of the front coils springs are? I need the measurement from top mount to bottom mount when the vehicle is resting on its own weight. In other words how tall...
Forum: TJ General Discussion Forum 10-12-2008, 08:13 PM
Replies: 6
Views: 784
Posted By 87yjAR
The TJ has D30/D35, but lower gearing and I plan...

The TJ has D30/D35, but lower gearing and I plan on upgrading later. I just want the smoother more flexible coils underneath. I will be going from 3.07 to 3.73 gearing. I have a 258 ci and an ax-15....
Forum: TJ General Discussion Forum 10-11-2008, 10:37 PM
Replies: 6
Views: 784
Posted By 87yjAR
right... but with factory parts versus a 1500.00...

right... but with factory parts versus a 1500.00 kit
Forum: TJ General Discussion Forum 10-11-2008, 10:31 PM
Replies: 6
Views: 784
Posted By 87yjAR
TJ Dffs on a YJ frame

OK TJ guys...I have a question or two for you. I have a 87 YJ. I recently aquired a complete set front and rear DIffs from a 98 TJ(unlifted, trackbars, springs, control arms, etc.) I also have a 99...
Forum: YJ General Discussion Forum 10-10-2008, 07:01 PM
Replies: 4
Views: 704
Posted By 87yjAR
Cool ... Thanks for the thread. I am going out on...

Cool ... Thanks for the thread. I am going out on a limb, and am going to try to put the diffs under my YJ frame. Using the donor frame(it's bent anyway) for all the bracketry. I have taken many...
Forum: YJ General Discussion Forum 10-07-2008, 08:49 PM
Replies: 4
Views: 704
Posted By 87yjAR
I actually want to use the coils and mount...

I actually want to use the coils and mount lower/upper control arms.
Forum: YJ General Discussion Forum 10-06-2008, 10:33 PM
Replies: 4
Views: 704
Posted By 87yjAR
TJ diffs in a YJ

I have just acquired a set of complete TJ diffs. D 30 front and D 35 rear 4.10 gears....I want to install them in my 87 YJ. Where can I find the right brackets and measurements to do this? I may be...
Forum: YJ General Discussion Forum 06-12-2008, 08:24 PM
Replies: 1
Views: 1,211
Posted By 87yjAR
Early style bronco axles

I have an 87 JY. I also have access to a couple of early broncos. The little square ones. Each of which are equipped with ford nine inch rears and DANA 44 fronts. The major differences are that the...
Forum: YJ Tech Forum 05-06-2008, 10:07 PM
Replies: 2
Views: 422
Posted By 87yjAR
NP231 Replacement

Are there any good salvage yard replacements for the 231 transfer? Something with a lower low range or something that has a crawler kit that is less than $1000??? I would prefer a gear driven unit....
Forum: YJ General Discussion Forum 12-08-2007, 10:42 PM
Replies: 8
Views: 882
Posted By 87yjAR
92Jeep YJ is right. Advance Adapters is well...

92Jeep YJ is right. Advance Adapters is well worth a call. I also agree with others above. Chevy parts will hold up better and they will be cheaper for those of us on a budget. Simplicity and minimal...
Forum: YJ Tech Forum 12-08-2007, 10:34 PM
Replies: 4
Views: 1,148
Posted By 87yjAR
Does the pop sound like exhaust or is it more of...

Does the pop sound like exhaust or is it more of an engine noise?
Forum: YJ General Discussion Forum 12-08-2007, 10:31 PM
Replies: 4
Views: 683
Posted By 87yjAR
VIN Decoding

Where is the best online source for a service manual or VIN breakdown for an 87 YJ? I would like to know what I have to work with.
87 YJ
4.2L I-6
Auto Trans
NP 207 transfer
Gears?
:doh:
Forum: TJ General Discussion Forum 11-24-2007, 08:31 PM
Replies: 2
Views: 818
Posted By 87yjAR
2001 TJ underhood wiring

I've got a 2001 TJ four banger basket case. Does anyone have a decent wiring schematic for the under hood engine harness. I am not worried about the lighting just yet. Mainly the thrittle body plug ...
Forum: YJ General Discussion Forum 09-06-2007, 07:26 PM
Replies: 4
Views: 896
Posted By 87yjAR
Talking I can help with a few opinions.. quadratec.com...

I can help with a few opinions.. quadratec.com will havw about anything you need for the jeep...Hardtop, expect to pay 2 grand or better. Check you local papers and ebay for a used one. Winches can...
Showing results 1 to 25 of 30

 
Forum Jump

All times are GMT -5. The time now is 06:36 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC