Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 210
Search took 0.32 seconds.
Search: Keyword(s): ; Posts Made By: screwystewy
Forum: TJ Tech Forum Today, 02:29 PM
Replies: 22
Views: 810
Posted By screwystewy
I installed a powertrax locker in my rear 44 and...

I installed a powertrax locker in my rear 44 and for the first 100 miles or so i was LOUD. I though at any minute it was going to explode the whole axle housing. After the first 100 miles its to the...
Forum: TJ Tech Forum Yesterday, 12:41 PM
Replies: 19
Views: 405
Posted By screwystewy
Finally got the jeep going! Replaced with new...

Finally got the jeep going! Replaced with new injectors and still no fix. Found a broken wire in my harness and whenever i replaced the fuel pump i must not have made sure to line up the pickup hole...
Forum: TJ Tech Forum 08-22-2014, 12:33 AM
Replies: 3
Views: 178
Posted By screwystewy
Autozone carries the cam sensor. I just bought...

Autozone carries the cam sensor. I just bought one but they don't list it as a cam sensor. Its ignition pickup i believe. Its a flat plate in the distributor very easy to change.
Forum: TJ Tech Forum 08-22-2014, 12:24 AM
Replies: 13
Views: 505
Posted By screwystewy
Could one be for old style 30 and the other new...

Could one be for old style 30 and the other new style 30? The orange seal is for sure timken not sure about the other
Forum: TJ Tech Forum 08-16-2014, 12:05 PM
Replies: 19
Views: 405
Posted By screwystewy
Checked the coolant sensor on the snap on scanner...

Checked the coolant sensor on the snap on scanner and was steady reading at 195F
Forum: TJ Tech Forum 08-15-2014, 05:34 PM
Replies: 19
Views: 405
Posted By screwystewy
Been working doubles so haven't had much time to...

Been working doubles so haven't had much time to mess with the jeep. But today i check the injectors and they are 53030778 injectors. They are all reading 12.6 ohms and i did alittle research and it...
Forum: TJ Tech Forum 08-12-2014, 11:31 PM
Replies: 11
Views: 474
Posted By screwystewy
No the inner tube seals keep the fluid inside the...

No the inner tube seals keep the fluid inside the housing. And go with a spicer brand sold at Napa or online which is what came in your jeep from factory. As far as greaseable or non greaseable thats...
Forum: TJ Tech Forum 08-05-2014, 04:04 PM
Replies: 19
Views: 405
Posted By screwystewy
I went and bought a new cps and still no fix and...

I went and bought a new cps and still no fix and even put the old one back on and still nothing
Forum: TJ Tech Forum 08-05-2014, 12:28 PM
Replies: 19
Views: 405
Posted By screwystewy
And ive never heard of the adapter for the...

And ive never heard of the adapter for the pressure until last night..my buddy is bring that as well so we can check the pressure
Forum: TJ Tech Forum 08-05-2014, 12:27 PM
Replies: 19
Views: 405
Posted By screwystewy
My buddy has a big snap on scanner thats he's...

My buddy has a big snap on scanner thats he's bring up within the next day or two and ill post back what we find out. We tried rubbing ice on the ecu to cool it down and even swapped in his new ecu...
Forum: TJ Tech Forum 08-03-2014, 10:34 PM
Replies: 19
Views: 405
Posted By screwystewy
Anyone?

Anyone?
Forum: TJ Tech Forum 08-02-2014, 09:55 PM
Replies: 19
Views: 405
Posted By screwystewy
2.5 dies when hot

Over the past weekend ive been trying to figure out why my jeep suddenly dies when it gets to 210. When you first start when its cold it fires right up and runs fine but as soon as it gets to 210 the...
Forum: TJ Tech Forum 07-06-2014, 04:59 PM
Replies: 4
Views: 152
Posted By screwystewy
Another fuel o ring..all the other ones looked to...

Another fuel o ring..all the other ones looked to be in good shape and the plastic circle piece wasn't cracked
Forum: TJ Tech Forum 07-06-2014, 01:57 PM
Replies: 4
Views: 152
Posted By screwystewy
Another o ring

Another o ring
Forum: TJ Tech Forum 07-06-2014, 12:31 PM
Replies: 4
Views: 152
Posted By screwystewy
Fuel line

Hello all the stainless fuel line that runs to the top of my fuel pump has a steady drip at the plastic connector that connects to the top of the pump. I took the guts out and 1 of the o rings had a...
Forum: TJ Tech Forum 05-12-2014, 01:53 AM
Replies: 8
Views: 387
Posted By screwystewy
Got the jeep back from the exhaust shop and all...

Got the jeep back from the exhaust shop and all was good for about the first 50 miles then cel came on. Came back to a code 43 cyl misfire. So now i gotta check that out. It never ends haha
Forum: TJ Tech Forum 05-10-2014, 12:11 AM
Replies: 8
Views: 387
Posted By screwystewy
Thanks for the info! Motor ran fine before...

Thanks for the info! Motor ran fine before rebuild had a knock and turned out to be #4 cyl had a cracked piston and few other problems. Full rebuild of the engine and a brand new fuel pump and fuel...
Forum: TJ Tech Forum 05-09-2014, 11:27 AM
Replies: 8
Views: 387
Posted By screwystewy
Trail gearing its fine its more the around town...

Trail gearing its fine its more the around town gearing. I stay off the highway anymore so thats not a factor. Its the hills around here going up a hill its peg to the floor and struggling to keep...
Forum: TJ Tech Forum 05-09-2014, 12:57 AM
Replies: 8
Views: 387
Posted By screwystewy
Gear ratio

Currently have dana 44 rear and hp 30 front 4.56 gears with the 2.5l automatic on 33's. The motor was freshly built top to bottom and runs perfect but this thing is still slowwwww. Whats the best...
Forum: TJ Tech Forum 05-08-2014, 11:21 PM
Replies: 21
Views: 671
Posted By screwystewy
$1500 seems high..if you were to get them id buy...

$1500 seems high..if you were to get them id buy them yourself and install them yourself and save $500
Forum: TJ General Discussion Forum 04-20-2014, 12:03 PM
Replies: 7
Views: 474
Posted By screwystewy
Wow $450 is awesome! Looks like i found my next...

Wow $450 is awesome! Looks like i found my next purchase! Wish i had one of these yesterday a buddy of mine snapped his drag link end clean off the pittman arm..boy was that a fun time getting it off...
Forum: TJ General Discussion Forum 04-19-2014, 11:38 AM
Replies: 7
Views: 474
Posted By screwystewy
Ready welder it is! Thanks for the advice jerry...

Ready welder it is! Thanks for the advice jerry much appreciated!
Forum: TJ General Discussion Forum 04-19-2014, 12:47 AM
Replies: 7
Views: 474
Posted By screwystewy
Thanks for the quick response jerry. It looks...

Thanks for the quick response jerry. It looks like that model sells for around $600 is it really worth the extra $350 than the metal meander?
Forum: TJ General Discussion Forum 04-19-2014, 12:32 AM
Replies: 7
Views: 474
Posted By screwystewy
Trail welders

Been thinking about getting a trail welder for my tj. Ive looked at the ready welder, the premier, and the metal mender by anza products. The ready and premier look top notch but are pretty pricey....
Forum: TJ General Discussion Forum 04-05-2014, 12:42 AM
Replies: 13
Views: 425
Posted By screwystewy
I gave the one out of my tj away for free and...

I gave the one out of my tj away for free and ended up scraping the one out of my cherokee
Showing results 1 to 25 of 210

 
Forum Jump

All times are GMT -5. The time now is 06:33 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC