Jeep Wrangler Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-17 of 83 Results
  1. TJ Technical Discussion
    Hi guys, My Jeep is a very clean 2006 4.0L with 63k miles (104k kms) on it, everything is stock. I brought it to the garage for an automatic transmission flush, coolant flush and brake fluid flush. The mechanic told me they lifted the car by the frame, wheels were hanging...Detail that might...
  2. JL Technical Discussion
    First off, I love my Jeep and it's the 3rd I've owned, but I know nothing about mechanical things, so please be kind! I have looked through the forum discussions for other recommendations but am still a little lost and would love some help. 2020 Jeep Wrangler Unlimited (Willy's model) 3"...
  3. JK Technical Discussion
    So I took my 18' Wrangler JK to a tough truck challenge and long story short broke the rear driveshaft clean off of the front hub that bolts to the transfer case. I ordered a new rear shaft but am not sure if I need to get it balanced before install? Anyone have experience with this particular...
  4. TJ Technical Discussion
    So yesterday, I was driving near my home on the road and the rear driveshaft came out. Cause: loose u-joint strap. I've inspected underneath and everything looks clean. No damage to anything. New driveshaft has been ordered. While limping home in 4H, the ABS light came on, and while I had...
  5. YJ Technical Discussion
    Alright guys, what do I need to do to stop this? Slow leak, transfer case side of drive shaft
  6. JK Technical Discussion
    Hey ya'll, I'm working on rebuilding my driveshaft and I need some help figuring out which centering yoke works with the H-yoke with part number C2-26-309. Ball and spring in the double cardan is bad so I'm hoping to replace the whole centering yoke assembly. I'm looking for the spicer part...
  7. JK Technical Discussion
    I own a 2012 Jeep Wrangler Unlimited Sport automatic I've been having this issue where if I hit any kind of bump big or small when I'm driving it turns my traction control light and check engine light on and my jeep's acceleration is basically non-existent and if I don't hold the gas pedal down...
  8. JK Technical Discussion
    I've had this issue for a while and I figure it's about time I start to actually do something about it. I have a squeak coming from the base of my front driveshaft where it meets the front axle. Shooting WD40 around it keeps it quiet but I feel like I should finally fix it. The current...
  9. JL Technical Discussion
    Here’s a video of what my Jeep is doing , it does the little chirp noise when I hit the brakes, when the body of the car goes forward in anyway wether it be putting into gear from reverse to drive as I am in the video , Jeep dealer wasn’t worth a sh** to help, so I’m hoping maybe I can find the...
  10. YJ Technical Discussion
    Driving on back roads and my rear drive shaft broke off lol. The pinion yoke is slipped back and broken and I’m wondering if I can drive in 4Hi without my rear drive shaft until the new yoke and ujoint comes in? If I can, do I need to seal anything so the oil doesn’t leak out? YJ 93 to be specific
  11. JK Technical Discussion
    I got a jlur rear driveshaft for a 4x4 conversion that I’m doing on my 2010 jku sport. Is the flange on my transfer case compatible, and if not is there an adapter I can buy.
  12. TJ Technical Discussion
    I have done some deep diving on this forum as well as others and after reading a lot I decided to pull my front driveshaft to see if it was the cause of my vibration after 60 mph. I pulled it out completely and drove it and the vibration was completely gone. So therefore I replaced all three of...
  13. JL General Discussion
    I currently have a budget 2.5" inch spacer lift but am looking to move up to a full 3.5-4" suspension lift. I have heard many different things about having to replace and upgrade the stock driveshaft with larger lifts. I do hit trails but usually nothing with extreme articulation or flexing...
  14. JK Technical Discussion
    I have a 2015 JKUR with the Mopar Stage 3 lift kit and have been trying to improve my steering. After installing new ball joints, tie rod and drag link I got an alignment and found my caster was only 3.2 degrees. My lift kit doesn't have adjustable control arms, so I was considering replacing my...
  15. JK General Discussion
    Hello everyone, My birthday is coming up, so I am allowed about an $800 budget for Crawlers, the black JKUR. So last year I got Crawlers lifted with a Metalcloak 2.5" True Dual Sport, Fox Edition, lift. The problem is, I have not added any armor yet and am getting around 4" of lift. I don't...
  16. JK Technical Discussion
    Good morning, all. I realize I'm going about this in a less-than-ideal way, but I'm up against a time crunch. I'm currently building a 2016 JK (in signature) and will be installing a Metalcloak 3.5" gamechanger lift as well as a new Teraflex Tera44 front axle housing. I'll need a new...
  17. TJ Technical Discussion
    Backstory...skip to 4th paragraph for the actual issue: I've got an 04 Wrangler. A few years ago a ujoint broke in my front driveshaft. Being strapped for time, I just pulled the shaft and took it to a shop for them to replace them all. I dont remember for sure, but I dont think they...
1-17 of 83 Results
Top