Jeep Wrangler Forum banner

From The Basement to The Penthouse

64K views 523 replies 86 participants last post by  Justin-az 
#1 ·
Well when I first started my jeep was told it looked as though I raided a pepboys lol



Sent from my iPhone using Tapatalk Pro
 
See less See more
1
#3 ·
Hog Wild has 50" rigid bar, 20" rigid bar, four rigid pods, rigid rock lights, jw speaker taillights foglights and headlights. 20 fuel wheels, bushwacker pocket flares. Gibson exhaust. Spod with custom switches. Smitty built rack. Afe intake. Maxim 3 bullbar, teraflex tire holder . Cmm snubbers loop and brass knuckle grab handles front and rear etc.


Sent from my iPhone using Tapatalk Pro
 
#4 ·
Coming soon is sound system with polk audio speakers, kenwood navigation and probally sundown subs. Also katzkin leather w custom embroidered headrest and bushwacker rear amor with some red and grey pinstriping to tie it all together followed by a 2" mopar lift



Sent from my iPhone using Tapatalk Pro
 
#10 ·
I was going to post this in your "Need Opinions" thread, but decided against it, then today saw this. Unless you are a University of Arkansas fan you are going too far with the "Hog Wild" thing. Especially with that Razorback in your embroidery picture. If you are a fellow Razorback, Woo PIG!! If not, well, I dont fully understand the "Hog Wild".

Im all about personalization, but also making everything symmetrical the O in your HOG is a different "flavor" than the H and G. The "Wild" looks good though.
 
#6 ·
It's got a lot of lights. I'll say that for it.
 
#16 ·
Thank you, i like it also. Hes going to redo the passenger side large letters though because when he pulled the tape after spraying the candy the leafing lifted. It looks fine to me but he wants to redo it and put sone southwestern scroll work on the back sides over the rear armor.


Sent from my iPhone using Tapatalk Pro
 
#18 ·
More of that mall crawler flavor for project Hog Wild [emoji16] three polk audio 12s arrived today and 2 polk audio amps should be here in next few days. Ones 1200 watt rms for the subs and the orher is 800 watt rms for the mids and highs. The box will look kinda like the one in pic but made for three 12s and have a sloped amp rack that will have two sunk in amp slots [emoji41]





Sent from my iPhone using Tapatalk Pro
 
#24 ·
Oh dear lord... on the positive side, 1200w might crush some rocks if you can get the subs close enough to the ground, definitely Mall ready for sure, put more blue lightning and keep the shine, lol wtf... have fun with it dude.
 
  • Like
Reactions: awk34
#25 ·
Lol i have red lights, thats unstuck16 with the blue lights. I dont plan on crushing any rocks in my jeep. Maybe i should dent it up with a baseball bat and throw myd all over it wtf lol. Anyway, im having fun building my mall crawler and its almost done. Just custom sub box, a 2.5 lift and install my katzkin leather [emoji41]


Sent from my iPhone using Tapatalk Pro
 
#26 ·
Justin, can you turn it down? We're trying to get some sleep up here in Portland.

Lol.

Seriously, that's one cool ride. Enjoy.
 
  • Like
Reactions: awk34
#29 ·
New system, kenwood navigation unit, two sets of crossfire 6.5 components, crossfire 800.4 amp. Three crossfire 12 inch subwoofers, crossfire c5 1700 amp, custom built box . Is loud but going to get it louder [emoji445]



Sent from my iPhone using Tapatalk Pro
 
#54 ·
I see you have the same mounting problem with your kenwood I did, as with my pioneer as well when it was mounted). The dash kit is not level at the bottom. It pissed me off to no end and I screwed with it until I found out what the issue is. The cross bar at the back which the back of the head unit sits on is too high and you have to grind it down a little so the rear of the unit can drop down. Then you can add some shim washers at the lower end of the head unit where it screws to the dash.
 
#62 ·
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top