ahhhhhhhhhhh - Jeep Wrangler Forum
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ General Discussion Forum

Join Wrangler Forum Today


Reply
 
Thread Tools

Please support our sponsors and let them know you heard about them on WranglerForum.com
Old 05-22-2008, 06:31 PM
Thread Starter
  #1
Newb
 
Join Date: Mar 2008
Posts: 3
ahhhhhhhhhhh

Front drivers side inner axle seal leaking on my 90 yj. I have alredy cracked my diff open and removed both front axles. I am not sure how to get to the seal or what special tools will be needed if any. If anybody can give me a step by step I would appreciate it.
Thanks,
Bryce

bpowlison is offline   Quote
Old 05-22-2008, 07:55 PM   #2
Genius

WF Lifetime Member
WF Supporting Member
::WF Moderator::
 
Coyote_94YJ's Avatar
 
Join Date: Feb 2008
Location: Montana
Posts: 20,952
Send a message via ICQ to Coyote_94YJ Send a message via Yahoo to Coyote_94YJ
I've never done the driver side inner seal but I did do the passenger side inner seal and it was a PITA without the right tools.

All I can tell you is how I did the passenger side and you can see if it applies to the driver side.

The seal I did had to be driven from the outside in to the open area where the vacuum motor and shift fork and collar are. I used a really long screwdriver and a hammer to drive it out. I had to manufactured a tool to pull the new one in. I don't know if somebody makes one to put it in or not, I never bothered to look. I used the flat round part from a seal driver kit, the right size for the seal. Then I took a long piece of threaded rod and cut out a flat piece of steel with a hole for the threaded rod to go through. I put the seal driver part on the inside of vacuum motor shift area with the seal in place. Then I shoved the threaded rod through with the flat piece on it and a washer and nut on the outside of that. The flat piece will sit against the outside of the axle housing so you can use the nut and tighten it to pull the seal in place. Then I put the seal driver over the threaded rod and put a nut behind it, and lastly started tightening the outside nut to pull the seal in and that is it.

So thats what I did and you'll have to let me know if this will work on the driver side or not.
__________________
2000 TJ Sport
Coyote_94YJ is offline   Quote
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off






All times are GMT -5. The time now is 08:36 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.1
User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC