Mounting of full size CB (not on roll bar) - Jeep Wrangler Forum
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Jeep Discussions > Communications and Electronics

Join Wrangler Forum Today

Thread Tools

Please support our sponsors and let them know you heard about them on
Old 04-30-2012, 02:28 PM
Thread Starter
theCollector's Avatar
Join Date: May 2011
Posts: 96
Mounting of full size CB (not on roll bar)

I wanted to see if there are options to mount a full size CB in a location other than up on the roll bar or just bolted to the dash somewhere?

I have a center console with sub and after looking, I do not think it would work inside the console without messing around with or eliminating the sub.

I did see a mount that goes on the side of the console up near the 4wd shifter on Quadratec's site but it doesnt specifically say a full size will fit.

I have basically ruled out the Rugged Ridge mount that goes on the left side of the dash since it looks like mid size cb at most. I would have been ok with that since it didnt require drilling into dash.

This is on a 2006 Unlimited Rubicon with auto trans.

theCollector is offline   Quote

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

All times are GMT -5. The time now is 03:43 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.1
User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC