Jeep Wrangler Forum

Jeep Wrangler Forum (
-   YJ General Discussion Forum (
-   -   Trailer Wiring harness (

rushwal 12-13-2019 10:56 PM

Trailer Wiring harness
I'm wanting to put a trailer wiring harness on my YJ. Is there a plug and play kit, or just hard wire it in?

steves92 12-13-2019 11:05 PM

I believe mine was plug and play but was given to me from my bro in law. I put in years ago so not 100% sure but if I was a betting man Id say yes.

Sent from my iPhone using Tapatalk

Gottagofast 12-13-2019 11:12 PM

Need to work on ur google-fu...

rushwal 12-13-2019 11:17 PM

1 Attachment(s)

Originally Posted by Gottagofast (Post 34620193)
Need to work on ur google-fu...

I saw that one, but when I put my year in, all it came up with was the universal kits. Also, that connector isn't the same as mine. Mine has flat 3 wire connectors. I also found 4 wire T connectors that won't fit.

rushwal 12-13-2019 11:22 PM

91 is the first year with a custom fit harness on etrailer.

rushwal 12-13-2019 11:58 PM

I wonder if these fit my connectors. I could make my own harness...

Gottagofast 12-14-2019 12:07 AM

Hmmm my bad....
If you splice it, go upstream before it splits

Got it at last 12-14-2019 10:25 AM

I got into mine just after it dropped into the fender well from the roll bar brace. Pull the grommet, Pull it up, splice, seal, drop back in. all your wiring is there in one bundle, so watch out for the tank wires.

Got it at last 12-14-2019 10:34 AM

Used this kit, But don't mess with the little blue splice in connectors will inevitably mess with your brake lights function, PO went in above the grommet in the bed. I would have pulled the grommet, pulled the harness up a few inches, splice, solder, seal and drop back into the fender well if I was starting from scratch. All your wires are in the same bundle, so be mindful of the fuel lines and correctly identify the brake and signal wires before you make your splices, and find a secure ground for both the jeep and trailer sides of the harness.

Etrailer kit.

good luck.

Luckymac 12-14-2019 11:47 AM

Mine is an '87. I couldn't find a plug & play harness so I simply hard wired one into my factory harness.
I did mine with the plastic liner out from underneath, but I like how Got it at last suggests. Pull the harness up and solder-shrink wrap the connections. That sure makes the job a lot easier.

Good Luck, L.M.

Gottagofast 12-14-2019 01:55 PM

My trailer harness comed through that grommet and is stores wadded up between my roll bar and tub... when I need to use it I run it over the tailgate.... been that way since 2007 w no issues...

All times are GMT -5. The time now is 11:57 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.1
User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.