Jeep Wrangler Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-18 of 51 Results
  1. YJ

    YJ Build Forum
    Starting a new build on this Jeep. You can look through my other posts to see the original build where I pulled this out from where it sat under a deck for 10 years. I put about another 10k miles on the motor and am just starting to have lots of issues with engine drive quality and rather than...
  2. TJ Technical Discussion
    Hey there folks I’m sad to say my 42rle in my 2004 TJ has seen some better days, last week it left me in limp mode about 2hrs from home. I’m getting a few different codes for 3rd gear ratio and 4 gear ratio and After doing some reading on various forums and Facebook group I believe a new...
  3. YJ Technical Discussion
    Hello, I’m in the middle of an aw4 swap, and I can’t figure out what is the difference between Winters Carr and Vx shifter from Radesign. Anyhelp please?
  4. YJ Technical Discussion
    The AX5 tranny is dust now, only have limp mode available so going to replace the tranny with something hardier but can't afford the AX15 swap. Are there any other tranny's that will work besides the AX15? I'm a good mechanic but I'm new to Jeep. Any help greatly appreciated.
  5. YJ Technical Discussion
    Hello, everyone! I recently purchased a project 89 YJ with the 4.2 and AX15 transmission. I installed a new clutch kit along with a throw out bearing. After installing the new throw out bearing and getting the transmission all bolted up, I got to thinking about the installation of the throw out...
  6. TJ Technical Discussion
    For the past couple of days ive been trying to change my trans fluid, im trying to loosen the fill bolt but the PO rounded the head pretty good. I tried with a normal 15/16 wrench combined with soaking the bolt with pb blaster for a couple of days but no luck. Ive tried with a pipe wrench but...
  7. YJ Technical Discussion
    Hello everyone, I recently bought an 87 4.2 yj and it has a Peugeot 5speed in it and I haven’t really seen any good things about them and I was in my local junkyard the other day and they have an ax15 out of a 93 yj but it has no shifter on it and they want $200 and so I’ve been trying to decide...
  8. YJ Technical Discussion
    I'm new to participating in the forum. Using this COVID-19 lock down as an opportunity to do some much needed Jeep work. I'm tackling the most ambitious Jeep project I've ever tried. I'm converting my 1994 Wrangler YJ from the stock AX5 transmission to the more robust AX15. Thought I...
  9. YJ Technical Discussion
    I have a 1988 YJ Sahara V6 Manual Trans. that I acquired a few months ago. Since then I've been having a heck of a time getting the transmission and clutch reliable. As far as I can tell it looks to be the AX15. I noticed a small leak coming from the clutch bell housing and and also noticed that...
  10. TJ Technical Discussion
    Working on my 2005 wrangler, 4.0 with 6 speed non rubicon. I’m planning on swapping the NSG370 6 speed to the AX15 5 speed. I was wondering if there are any wiring issue that I may come across with or should be aware of before the installation. Would greatly appreciate any feedback. Thanks !
  11. TJ Technical Discussion
    Hey guys (and gals), I'm in the process of doing an engine swap on my '97 TJ with the 2.5L, I think (extra emphasis on "think") I've decided on doing the TDi swap. With all of that I am wanting to do a transmission swap to the NV3550 while I'm at it. I know it's not completely necessary because...
  12. TJ Technical Discussion
    First, pretty sure I don't have SKIM as my only key is a copy and is actually a key from a dodge ram. Plus, gonna try to wing it with my original PCM (don't care about check engine light, it's already been on for 5 years). My 42rle is toast and I've wanted to swap to the AX15 for a while now...
  13. YJ Technical Discussion
    I've got a 94 YJ 2.4L (4 banger) and the AX5 transmission is failing. I no longer have 5th gear and 2nd grinds/pops out of gear....pretty bad. I think the oversized tires are killing the AX5 transmission. So, I'm planning to replace the AX5 with a heavier duty AX15 transmission. I'm not a...
  14. TJ Technical Discussion
    Hi folks! I'm looking at swapping my old BA10/5 out of the '88 to an AX-15. I'm swapping out my dead 4.2 motor this month and, although I haven't had issues with the BA10/5 up to this point (180,00 miles), I think it's the perfect time to put in a new transmission as well while I have the...
  15. YJ Technical Discussion
    I recently replaced my BA10 with an AX15 and the reverse light switches are a bit different. I wired in my AX15 reverse switch to the wiring harness that originally connected to my BA10 reverse switch. The switch plugs are different but both are a pretty simple two-wire setup. Anyhow, no...
  16. YJ Technical Discussion
    I have a 1987 YJ that I just recently performed a transmission swap on. BA10 to AX15. This required a new flywheel and hence a new starter to accommodate the new trans. Problem is that the 1987 YJ has an old style, 4 post solenoid mounted to the firewall and a no-solenoid (1 wire) starter...
  17. YJ Technical Discussion
    Okay, On thanksgiving I blew out my internal slave cylinder and was so disheartened by the negative reviews of the internal replacements (and the fact I need to drop everything to get to it) that I refused to replace it. Instead, I opted to do a full swap to a newer, EXTERNAL slave set up...
  18. YJ Technical Discussion
    Good afternoon all, I am swapping out the bad ba10 trans from my 88 yj 4.2l. I took out the old tranny out and got the new ax15 in but it looks like the front (stock) driveshaft is coming up short. is the ax15 longer then the Peugeot ba10/5? should I buy a new one or is it just something I'm...
1-18 of 51 Results
Top