Jeep Wrangler Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. JK Technical Discussion
    Hey there! I'm about to purchase my first Jeep Wrangler. I test drove one last week that I heard a ticking coming from the enginer - mostly on the driver's side. I actually bought the Jeep - a 2014 Sahara w 65k miles - but the sale was contingent on the ticking noise. Turns out it is likely...
  2. TJ Technical Discussion
    Hey all, I’ve been scouring through endless P1391 threads and still can’t figure out what’s causing it. Maybe someone can shed some light or point me in a direction I may not be thinking of. It’s a 97 4.0l Manual. Here’s where I’m at: Checked grounds and wiring visually and physically, cleaned...
  3. YJ Technical Discussion
    Hi Folks, :pullinghair:I have been able to find several place to buy the cam, no where can I find the spring, pin and retainer that goes in the cam. Also looking for the turn signal metal arm that connects the arm to the switch. Any Ideas other than a junk yard? Thanks!
  4. YJ Technical Discussion
    I have an 88 YJ 4.2 automatic 2.5 inches of lift and 31 1050's that has a stuck lifter. I plan on replacing them in the next week or two. I figured since I'm going that far into the engine might as well replace cam and timing gears/chain. I'm on a budget so those parts will probably tap me out...
  5. JK General Discussion
    Hey All- I installed a TeraFlex 2.5 inch lift (Part: 1251000) and noticed shortly thereafter that the Jeep wanted to pull and drift a bit. As a result, I purchased these: Teraflex lowers (1252000) - they helped a bit but vehicle still drifted, pulled. Today I had an IFS alignment (not sure...
1-5 of 5 Results
Top