Jeep Wrangler Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. TJ Build Forum
    Hello, I'm new to the jeep world and am planning to buy one within a few months. I currently drive a 1995 chevy suburban (gas) 5.7 RWD. I believe this is a 350 motor (correct me if I'm wrong) The car has no issues i just want something smaller that i can also take off road. Plus i like jeeps I...
  2. TJ Technical Discussion
    Just finished swapping a 350 chevy gen1 into my '93 YJ fired it up and the transmission wont engage. Suspect that the throwout bearing is too short for the throw to the chevy clutch. Can I shim/space the throwout bearing or do I have to bite the bullet and go to an external slave with a...
  3. TJ Technical Discussion
    Hey i pulled a TBI chevy 350 out of a 94 sierra and im planning on rebuilding it and swapping it into my 97 TJ. I want to do a few upgrades to the engine but im having trouble deciding what to do. So far I have chevy 882 heads, and i want to put new cams, springs rockers and lifters and I would...
  4. TJ Technical Discussion
    Well its finally time for me to ask for some help. My lovely 1998 jeep tj with 4 cylinder,5 speed manual is slowly breaking down. Just noticed a knock in my engine and I have been constantly doing research on doing a chevy 350 swap now for months. This is what I have in it right now for mods. 2"...
  5. CJ Technical Discussion
    I have a chevy 350 in my 82 cj5 and up until yesterday everything was fine messing around and hit a bump too hard and now the distributor rotor is hitting the cap. Pulled cap and confirmed that rotor is hitting backside of cap (side that is next to firewall). Any suggestions on how to fix? It...
  6. General Jeep Discussion
    so i installed a chevy 5.7 with a 4L60. we hooked up the wiring. needing some help now. We got it started , but it wouldnt shut off. after starting about 4 times, now its not shooting out full. its a tbi. we hear the fuel pump runing, but fuel isnt coming out of the injecters now. any help would...
  7. Classifieds Archive- move sold/expired ads here
    1993 Jeep Cherokee Laredo Engine is a Chevy 350 V8, 4 bolt main Novak motor mounts 700R4 transmission (needs installed) Dana 30 front pretty stock Ford 8.8 rear (limited slip, Richmond 4.56, diff cover) Rough Country 6.5" coils 35x12.5x15 BFG mud tires half tread New Cragar soft 8's Engine...
  8. Builder's Corner
    Here is a few pics of my current project. 305 Chevy in a 1998 TJ where a 2.5 used to be. A little back story, about 30 years ago I had put a 289 small block ford in a MB model Jeep (sacrilegious I know) the radiator was bailing wired in, the firewall was cut out and patched with sheet metal you...
1-8 of 8 Results
Top