Jeep Wrangler Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 8 Results
  1. JK General Discussion
    I bought my Jeep with the lift already on it, and they put on a correctional bracket for the stock control arms. I just bought front upper and lower adjustable rock krawler control arms. When taking off the correctional bracket that means i'll need to remove both the upper and lower control...
  2. Indiana Jeep Forum
    The control arm mount on my 2004 TJ has rusted through and become detached (pics included). From what I gather, this is a pretty common point of failure due to rust and SafeTCap makes a part to replace it. I've brought it to a few shops nearby (including Church Brothers and 4 Wheel Parts), but...
  3. JK Technical Discussion
    I had my wheels aligned after my Mopar 2" lift kit was installed. We left the caster bolts off, because caster bolts suck. I do notice the difference in steering, though, so I'm going to install Rancho's control arm drop brackets. Will I need a front end alignment after install?
  4. Rancho Suspension
    Nice little overview of our one piece welded control arm correction brackets. Enjoy!! :beer:
  5. JK Technical Discussion
    So im buying a rancho 3' lift kit w/out control arms because it was a bit out of my price range. Ive heard that the CA drop brackets that AEV makes are a good cheap substitute to correct the caster angle and correct geometry that the adjustable CA would. Anyone have any experiences with drop...
  6. JK Technical Discussion
    Just installed RK 1.5 springs and fox 2.0 on my 2 jk rubi! Finally the budget boost is gone..look to have gotten maybe 2.5 out of the springs, didn't measure and hard to tell bc I was already lifted. But I digress..seeing alot of conflicting options on correction brackets vs LCAS. I like the...
  7. North Carolina Jeep Forum
    Hi, im in high school, and just got a 2004 Lj wrangler. I am looking to buy a 4 inch lift kit from rough country, but it says in the instructions that i will have to drill a hole in my control arm bracket to replace the control arms with the RC ones. Is there any way that i can avoid drilling a...
1-7 of 8 Results