Jeep Wrangler Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-19 of 55 Results
  1. JL Technical Discussion
    Let me start off with saying I've been a senior master tech at a Ford dealer for 8 years and just wanted to get anyone else's opinion on this before i take it to a dodge dealer for warranty. 2020 jl sport. At 18,000 miles had rear axle replaced with new unit for clunk when hitting gas in...
  2. YJ Technical Discussion
    I have a 1989 jeep Wrangler which has a Dana 35 axle in the back. Long story short my rear Spyder gears and ring and pinion are damaged. I was wondering if I could pull a Dana 35 differential axle out of a 1994 jeep grand Cherokee I have for parts and put it in the wrangler. I just need the...
  3. YJ Technical Discussion
    while researching what axles to upgrade to for my 95’s Dana 35, I’m getting confused with the types, 1541H, 4140, 4340. I know that manufactures processes differ, and the quality thus differs. However, I would think 4340 would typically be strongest. Then, I came across this post...
  4. Classifieds Archive- move sold/expired ads here
    Brand new, unopened box, Alloy USA Dana Super 35 chromoly axles. 30 spline. Includes bearings, seals, lug studs If you want a locker in a Dana 35, you need these $280 Also, brand new, Alloy USA heavy duty aluminum Dana 30 cover, red. All hardware included $50 located in Chicagoland
  5. YJ Technical Discussion
    I just bought a 89 YJ with a 350 swap. It has factory Front Dana 30 and Factory Dana 35 rear with what i think is 3.40 gearing?. it had a locker in the rear which blew everything apart. I dont know what gearing to go with and what will fit in the Dana 35. I would like to stay with a rear...
  6. TJ Technical Discussion
    I need help figuring out what went wrong or what I did wrong, because I can't afford to mess this up twice! The backstory: after 178,000 miles, lots time in salt water areas and beach sand, and several road trips from TX to NJ, my rear passenger wheel seal finally blew out. Since repair...
  7. TJ General Discussion
    Hey guys how's it going not really sure how this works this would be my first post just wanna ask which axle route should I go A) I found dana 60 axles both front and rear from a 94 ram 2500 for $300 (some rebuild work may be needed) or B) should I just upgrade my current dana 30/35 axle (not...
  8. YJ Technical Discussion
    I searched the forums and found a post where the OP had the same problem as me but there was no resolution so I'm asking here. I have a 1993 YJ and the spider gears gave up the ghost. I am sure it is a 35 from the pumpkin shape and the fact that it has a rubber plug. I pulled the old gears...
  9. TJ Build Forum
    Hi folks! I just became the proud owner of a new-to-me 2005 Wrangler Willy's edition. It doesn't have the sticker package (I checked the option sheet, it was spec'd without it), but it does have the camo seats. Unfortunately, the green soft top was in disrepair, so that's gone on my list of...
  10. TJ Technical Discussion
    Hi, I've recently purchased a 97 2.5 Jeep and I'm going through it to ensure things are in good order. There's a small oil leak on the rear pinion seal, so I will change it in the very near future, but I wanted to check the oil level meanwhile to make sure I wont damage anything before I get to...
  11. YJ Technical Discussion
    Can anyone tell me if i identified my read differential on my Wrangler 1991 properly? I need to order new Spider Gear. Dana 35 Trac Lok 1.625 Carrier Bore Many thanks.
  12. TJ Technical Discussion
    Hi All, I have come to the realization that I just cannot afford to do crazy modifications to my Jeep. Financially it isn't feasible and I need something that is good on and off-road as my Jeep will be my daily driver. Here is my modest build plan: Currently have 31" tires. When they wear out...
  13. TJ General Discussion
    Since i finished paying my jeep, i wanna lift it 6 inches, i have dana 35 in my jeep, is there a way to beef it up? is it worth it?, should i do an upgrade? Thanks in advance!!!
  14. TJ Technical Discussion
    I am just trying to replace the rear passenger axle seal. Ive got a dana 35 with a detroit trutrac in the dif. The problem. When I try to push the passenger axle in to remove the c-clip. I cant push it in far enough. It seems to be hitting some gear? Am I not lining something up enough? I am...
  15. YJ Technical Discussion
    So there I was, driving along at a nice 30mph, minding my own business when all of a sudden I hear a loud pop and A LOT of grinding. I pull over, realize I have zero power going to my rear axle and limp to my favorite shop in 4WD (front wheel drive). As you probably guessed, my rear...
  16. TJ Technical Discussion
    Alright I need some help. My Dana 35 in the rear is going out, I want to swap it with a dana 44, is there any models that have the D44 that would bolt right up in my 97 tj sport?? :atomic:
  17. TJ General Discussion
    I'm unfortunately selling one of my projects. A 1997 Jeep Wrangler SE. 2.5L, 5 speed, 155,xxx miles, soft top, aluminum wheels, so so tires. My question is what would be a reasonable price to list it at. The body is a little beat up, paint is faded. The engine has thrown a rod. It took a very...
  18. TJ Technical Discussion
    CAN SOMEONE EXPLAIN TO ME why the heck this shop is trying to charge me over 3 grand to rebuild my rear D35? :banghead: the guy said that getting a whole new D35 would be $800 cheaper which doesn't seem right to me. Why the hell would some gears, bearings, seals, and a couple axle rods cost me...
  19. TJ Technical Discussion
    My d35 is shot. It sounds like a room full of toddlers trying to make music with the kitchen pans! Since I run larger tires, with the intention of going even bigger, and doing an engine and tranny swap in the more foreseeable future I refuse to slap another d35 in there. I found an XJ for sell...
1-19 of 55 Results
Top