Search Results for ‘ignition’

Hello, I have a 2008 Jeep Wrangler V6 Unlimited Sahara and it won't start. I only got my Jeep about 2 months ago so I am new to the whole Jeep world. Last Tuesday morning I got in it to turn it on to go to work. And it wouldn't start. Even with a jump it wouldn't start or on a slow charge...

Like many of you, that stupid repeated beeping while the key is in the ignition is the most must be KILLED :atomic: ... Anyone have ANY insight on how to do this? Method 1, unplugging door sensor - Then lights don't work Method 2, latch door when open - inconvenient and I'm not going to flip...

Ok so I have 2003 Jeep wrangler rubicon and have replaced the starter 3 times. When I take the starter back the cycloid is testing as bad. Here is a list of the things I've replaced in a failed attempt to fix this issue. 3 starters, starter relay and the ignition switch. I am baffled and...

This is my first post here. I have done countless hours of research and I am unable to fix my problem. I have a 1987 YJ with the 4.2L I6 & Automatic Transmission. It has a Weber 32/36 carb, which was not installed by me, and I have installed a DUI distributor to completely eliminate the...

Replaced the Actuator Pin for the ignition and saw the cautions for the little spring that appears to have just been sitting in the housing. Problem is that I don't know where it fits back into it. This is not the smaller spring for the actuator unit, this is the one that is approximately 1"...

I'm tired of hearing the fan run when I have the key on ACC. After a lot of searching this Forum and the Web, I can't get an answer that is specific... so I am just going to ask... on a 1999 TJ, does anyone know of a power source that is dependent on the ignition being on under the hood...

I'm having trouble with my anti theft system I think. My key FOB isn't working at all even after replacing the battery. When I open the door manually the alarm initiates, and I am unable to start with the key. Anybody have experience with his one. Chris

Hi everyone, I have a strange issue and don't exactly know where to start, or how to optimize a google search to identify the issue. I've been away from my 1998 Wrangler for a few days, and she started up without issue this morning. I drove for 10-15 minutes and then stopped for coffee. When I...

Does anybody know what the resistance and voltage specs are for the coil pack that comes with the 3.8L engine models? (2007-2011)

:pullinghair:Hi All, I was installing a radio in my 2008 rubicon when a bare hot wire touched the radio case. It appears that I no longer have power from the battery. I've checked the two radio fuses in the fuse box (M10 and M12), but they look good. Any ideas hoe to fix this?

i have some lights that i added and as off right now i just have them on separate switches and relays all over my dash like a mess. i am making a switch panel for all of my lights and adding a weather proof box to store all my relays under the hood really neat. the problem i have run into is...

I need your help. The ignition actuator(?) broke. Turning my key does nothing ... except lock/unlock the steering wheel. I have to turn the ignition switch with a screwdriver. I could fix/replace the part. But I don't want to. I have heard this is fairly common. Im sure there are threads about...

Trying to trouble shoot a (non) starting issue, I took the actuator pin assembly out to inspect and it looks fine (although it could still be the culprit from other posts I've read). My issue is that when I try to put the key/lock cylinder back into the housing, the tang will not pop into the...

I'm planning to install two auxilary fuse boxes up under my dash to accommodate several electrical mods I want to make (heated seats, interior LEDs, exterior LEDs, etc.) My plan was to use one aux fuse box to be always hot and the other fuse box to be ignition switched. I've studied up on wiring...

Having an issue with my 2007 Jeep Wrangler Sahara (automatic). A couple days, I went to start it after work and it didn't turn on. There was no crank, just a click, and nothing turned on. I tried starting it another 2 times and it turned on on the 3rd try. I had some corrosion cleaned off the...

Hey Everyone, Thinking it's time for a tune-up this weekend. Plugs, wires, cap, rotor, oil (and filter). All the good stuff. I remember working at Kragen a few years ago, and Champion brand plugs were normally what were recommended. I was planning on putting those in (though I'm open to...

Good evening everyone, i just finished swapping engines in my 90 YJ 4.2 nuttered. it had a 258, so that's what I put back in. THe engine runs fine, but I am having trouble with the starter. The starter worked before the swap, and does now if i jump the terminals. The engine fires right up when...

Hi All, I'm going to install a powered sub (Sound Ordnance B-8PTD) in my 2013 Rubicon (with Alpine system). I'm going to splice into the speaker wiring for the factory sub, using a line converter to get RCA outputs. I know this won't give me major bass, but it'll work for my needs. The...

any electrical gurus out there???I got a problem..i removed my fasctory installed optional alarm system because it wouldn't shut off. had to disconnect horn to get it to quit beeping, but it kept killing my battery... so now I need to reconnect my ignition and starting system...I have a...

Hello, new to the forum. hope someone can help me. Just bought a 1994 jeep YJ with a 4.0 and a 5speed. at first this thing was running like a top after sitting in someones yard for a whole winter, no troubles starting or idling. after driving it 60km to bring it home i attempted to start it...