Search Results for ‘rear’

1998 Jeep Wrangler TJ, 4.0L Straight 6 Cylinder Engine, Manual Transmission. Rear main seal finally started to leak after 174,000 miles. Here are my hard earned experience comments regarding replacement of the seal. Regardless of commercial shop manual or youtube guidance, here are some do’s...

Hello Everyone, I have a 1995 Jeep Wrangler YJ with a hard top. The hard top I have was rolled backwards and the glass busted. The struts are still in place and do not look bent. I am about to order new glass but I noticed that there was a little channel that looks like it was curved to the top...

Hi Evey one new group but not jeeps .. can some help and some guidance 2015 jeep Wrangler Willy's jk 44000 miles ..45000.00 jeep. one cold start sitting over 3 days top end chatter .. why read alot on it . Saying just norm .. come on. ... Major complaint.Than rear differential has clutch pack ...

Looking to trade a set of Bestop TrailMax II seats in Spice for a set of good to excellent condition front OEM 1999-2002 Sahara seats. Seats are in good condition with no stains or rips. Front seats come with adapter brackets for 1999-2006 Wrangler sliders. Rear seat comes with all mounting...

After much searching, I am starting a thread to document the installed depth (distance from the sway bar) of sway bar links. Does anyone have measurements they would like to share for aftermarket links? OE Mopar rear link: 1.615 inch

I have seen posts about people wondering where to store the “Rear Fastener Knob” when they take off their Freedom Top - as did I. I have decided to put mine back in the screw hole on the Freedom Top while I am storing it.

When pulling the latch to fold the rear passenger-side seat forward, the latch is stuck. The latch on the rear driver-side seat works fine. I have gone under the seat to make sure nothing is stuck and looked through out the rear seat to ensure nothing is blocking / stuck. The issues seems to...

Brand New in box Rear Differential Skid plate for Jeep JK Dana 44. Retails for $169 Selling $ 140 obo Absolutely nothing wrong with it. https://metalcloak.com/jk-wrangler-rear-dana-44-differential-skid-plate-dsp.html

Wondering if anyone else has had this issue... 90 YJ with 2.5" lift, the tube of these shocks are too thick and contact the axle so as not to meet-up with the bottom mounting lug. I spoke with mfgr to confirm this model number is supposed to fit, and they say it should work with my setup. Sadly...

For sale is my Rampage Recovery Recovery Rear Bumper with Spare tire swing Part number 86606. This bumper is just over a year old. I have painted over the factory powdercoat to match my front bumper and rock sliders. No rust, no dings, no damage I paid over $900 and am ready to take a beating...

So I was having some wheel wobble on the passenger side, rear wheel of my new-to-me 2012 4Dr JKU Rubicon and when I noticed it, I assumed it was probably just a warped tire or warped wheel. It literally has brand new Fuel Battle Axe Aluminum wheels and brand new 285/70-17 Hankook Dynapro MT...

I just got a Rotopax Jeep Wrangler L-mount bracket that attaches to the rear gate hinges. But when I remove the bolts from the hinge plate, the back metal bracket inside the door falls down about 1/2 of an inch so that when I attempt to mount the new Rotopax hinge cover plate on, I can’t line...

I've got a full width ARB rear bumper for sale off my 2013 JKUR. Powdercoat in good shape overall with a couple aesthetic issues. Driver side has a little discoloration from fuel over spill, and right side has some discoloration from my Gobi brackets. Couple other small nicks but otherwise in...

So I have installed a rear camera to my mygig radio on my 2014 JK Wrangler...no big issues, but I do have a wiring question. The kit's lead from the camera to the radio does have a positive and negative wire...the instructions state that I should tap into the "reverse wire", which makes sense...

So we found the location of the vibration. I took it to the shop. They drove it, put it up on a lift, raised it up, put it in gear and low and behold the vibration is in the rear drive line. I have after market extended front and rear drive shafts to compensate for the 4" lift. A quick run down...

I've decided to undertake a project to build my own security enclosure/deck for the JKU. Inspired, of course, by the Tuffy product, and some of the other DIY decks that I have seen, I'm looking to basically combine the features of each. I'm going for the same functionality as the Tuffy (theft...

I have had a clunk in the rear (sounds like passenger side) that I have been chasing for months. I have replaced the end links and bushings on the sway bar, which did get rid of some noise, but not this particular one. If I stand on the passenger side of the rear bumper and shake it side to...

Does anyone run one of these? Can't really find too much about it besides what is on vendor sites. Can anyone post some pics? Any pros and cons?

When we bought our '14 Willys, I heard about the oil change deal thru Mopar, so we got it. Couldn't do it myself any cheaper. So toady, I bring it in for her appt and added a state inspection. As they are finishing up paperwork, I'm told she passed, but only has 2-3 weeks left on the rear...

Hi everyone, I'm new to this forum and I'm having trouble finding what I'm looking for. I'm looking to be able to move the rear headrests of my JKU, but when I search for keywords and phrases using the search bar on this forum, it keeps telling me there are no results. I know this has been...