Jeep Wrangler Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 12 Results
  1. YJ Technical Discussion
    I have a mostly stock (as far as i can know its only had a lift kit and 4 10 gears put in) 95 yj 4.0l manual trans. It was running great until last Thursday i went to turn left and it bucked and stalled, then proceeded to not start. It has fuel didn't have spark. Went to testing found that both...
  2. YJ Technical Discussion
    I've searched and searched to no avail, 88 YJ, 4.2 5-Spd, stock, new distributor, ign module, plugs, wires, cap, rotor, coil checked ok, 12v on ign on.. only spark is when stop cranking. Then quick sputter and nothing. Will having the factory ecm w/ out doing the nutter bypass cause this issue...
  3. YJ Technical Discussion
    The struggle is real! Was riding down the road and my 1989 YJ starting missing badly about a mile from home. By the time it got me home it would hardly run and finally just died - inside my shed thank goodness. Now it has no spark coming from the coil. I replaced the coil and condenser...
  4. YJ Technical Discussion
    This is going to be sort of a long post, but it's only because I want to be thorough and also because I have tried a LOT of things before resorting to asking for help on a forum. I know how to use google, I know how to use search function, I have finally hit a wall. So, 1989 Sahara 258. I'll...
  5. YJ Technical Discussion
    Hello everyone I have a few questions about my 94 YJ 4.0 automatic not starting. About 6 months ago the Jeep started and ran but I needed to fix the freeze plugs in the back so we pulled the motor to work on it. It has sort of been a project for a bit but finally got the motor back in and...
  6. YJ Technical Discussion
    Hey guys.... could really use some help right now. 1989 4.2l 6cyl YJ. Over the course of the past month or so my jeep has just flat out died while driving, luckily started back up a couple of times until now. so far i have replaced distributor, coil, and did a nutter bypass. still no spark...
  7. TJ General Discussion
    Ok so i just swapped out the 2.5l in my 1997 TJ for a 4.0l out of a 1998 TJ sahara, I swapped over the engine harness and ecm and my gauges didn't work and had no spark and no fuel cranks all day. I went back and got the gauge cluster from the guy i got the engine from and now its also says no...
  8. TJ General Discussion
    I have a 2002 jeep wrangler tj. I need help; it will not spark. I have replaced; plugs, wires, cap, rotor, modular (thing underneath cap), and coil; and it still will not create a spark. Just previosuly I had replaced the clutch in it and all that works well. However, i forgot to disconect the...
  9. YJ Technical Discussion
    I have a 2002 jeep wrangler yj. I need help; it will not spark. I have replaced; plugs, wires, cap, rotor, modular (thing underneath cap), and coil; and it still will not create a spark. Just previosuly I had replaced the clutch in it and all that works well. However, i forgot to disconect the...
  10. YJ Technical Discussion
    My 94 yj wrangler 2.5L 4 cyl wouldn't start. I pulled a plug and checked but had no spark. So far i have replaced the rotor, the dist. cap, ign coil, dist. pick up sensor, (CPS) crankshaft position sensor and I still dont have a spark. everything cranks fine and I also have the smell of gas out...
  11. TJ Technical Discussion
    I just changed the oil in my 1998 jeep wrangler. I decided to replace the spark plugs also. when i went to turn it on it ran fine. i parked it. i tried to start it up again and no electronics. i removed the battery wire and put it back on. started up then. but when started it ran rough. when i...
  12. YJ Technical Discussion
    I bought the Jeep with 90k miles on it and a motor with a bad rod and major engine noise. The engine ran and drove but very loudly and dangerously. The only reason I state that is that I know the computer and all components were fine because it would start right up, run, and drive...just made...
1-12 of 12 Results
Top