Jeep Wrangler Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 9 Results
  1. TJ Technical Discussion
    I hear a grinding noise in my 04 Sport Wrangler 5spd manual. I read some forums and have confused thoughts. When I push my clutch in the grinding noise stops. I don't have enough to take it to a shop and want to do it myself. If I do it myself, what all should I replace? Edit : I know I need to...
  2. YJ Technical Discussion
    Hello, everyone! I recently purchased a project 89 YJ with the 4.2 and AX15 transmission. I installed a new clutch kit along with a throw out bearing. After installing the new throw out bearing and getting the transmission all bolted up, I got to thinking about the installation of the throw out...
  3. TJ Technical Discussion
    My 2004 4-cylinder 5-speed Wrangler X is giving me a scraping sound when I press down on the clutch pedal. My mechanic thinks it's the throw-out bearing. Was offering to just replace that but upon further research on my end, I'm learning it's cheaper in the long run to simply replace the...
  4. YJ Technical Discussion
    Just became a new Jeep YJ (2.5 liter 4 cylinder) owner recently and having an issue with a somewhat noisy ticking sound by which I thought was in the engine compartment. Doing extensive research here on this site I felt my odds were high I had a stuck lifter. Therefore, being the type A...
  5. JK General Discussion
    I've got a 2011 JKU Sahara manual tranny with 65k on the odometer. Just picked her up over a month ago and I just started noticing a grinding/chatter shaking noise while in neutral slightly taping the gas. I also hear the noise when I shift down into 2nd gear and accelerate from a Stop sign (I...
  6. TJ Technical Discussion
    I've started to get the creaking sound when i depress my clutch pedal. (https://www.youtube.com/watch?v=RXNtXLugQmU) This is what is happening to my Tj. When i first got the Jeep a year ago, it was making that sound. My dad and i did a whole new clutch job and a new throw out bearing. Used...
  7. TJ Technical Discussion
    Just finished swapping a 350 chevy gen1 into my '93 YJ fired it up and the transmission wont engage. Suspect that the throwout bearing is too short for the throw to the chevy clutch. Can I shim/space the throwout bearing or do I have to bite the bullet and go to an external slave with a...
  8. TJ Technical Discussion
    My clutch recently decided to stop working and my transmission will only go into gear occasionally. I believe this is signs of pilot bearing wear but am not sure...any suggestions? Jeep noise - YouTube
1-8 of 9 Results
Top