Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of January's Ride of the Month Challenge!
vac lines
1-4 of 4 Results
  1. TJ General Discussion
    Hey Guys, I have been trying to figure out where this one vacuum line connects and just haven’t been able to figure anything out. Im pretty sure it connects somewhere on the manifold but just not sure if the exact location. When I rev it takes way too long for my jeep to return to idle and I...
  2. TJ Technical Discussion
    Recently, my tj body was separated from the frame and motor. TJ had a ton of rust and the frame needed lots of work. After the repairs, jeep was put back together in a rush and I'm finding that the lines that go to the intake and probably EVAP may have been hooked up incorrectly. Now I'm not...
  3. YJ Technical Discussion
    So two of my vac lines on the ported vacuum switch on top of my valve cover are not attached to anything. My motor is misfiring and I want to address the obvious issues first. I've been looking all over for a diagram for these vac lines and where to hook them up to but I cannot find anything...
  4. YJ Technical Discussion
    I have replaced all the lines after my dad removed them all. I probably dont have them in the correct locations. Need a diagram very bad. When it starts it will idle but very rough and smokes pretty bad white smoke. when you press the eccelerator it is very sluggish. Has new accel plug wires...
1-4 of 4 Results
Top