Search Results for ‘wire’

Greetings from VA Beach. I am working with the AUX lines in my 2021 JL Wrangler Willys 2 Door manual. In the process of looking for the Aux wires I found a separate green-white wire that was similarly capped with shrink tube. I am really curious what this is because if I can use it in some...

Hi, all! I have a big 3 kit that I'm looking to install in my TJ. Quality stuff, 1/0 gauge, oxygen free, etc etc. I started googling and, like every Jeep project I undertake, it's more complicated than I expected. It looks like one of these wires needs a fusible link. This is a bit annoying...

Good morning, I’m new here but need some help figuring out the wiring for the radio harness

I'm in need of some auto electrical advice for my JK, and I'm sure this is the right place to get it. A few years back I purchased a 2013 JK that the previous owner had modded with a windshield mounted light bar and four windshield pillar mounted work lights (or driving lights). The wiring...

Hey guys Question regarding my 15 jk Willys. Have had a hesitant crank for about 6 months now. Vehicle will randomly die on me also. Sometimes I'll get in the vehicle, key in, lights turn on, go to crank and just get a repetitive click. It will sit for a few hours then it will start up just...

I noticed this thing hanging loose, not connected to anything. Does anyone know what it is? What is it supposed to be connected to?

Subwoofer Amp Wire – How to get it to battery? I've got a 500w amp that will sit under the sub cabinet behind the backseat. How do you get the amp power wire up to the battery? Do I need to drill a hole in the firewall? Is there another way to connect it to power?

Ok, so this is my first time wiring LED lights in my 03 jeep wrangler TJ. I've gotten all of the steps pretty much done except for the last two. here are the last two steps: 1. connect the RED wire to the outer COPPER colored pin on the switch then route and connect it to a steady power...

I have an 87 4.2 that i got from a guy in trade, i've replaced the vacuum advance that i was warned not to connect to the carburetor, replaced the vacuum lines to my egr, got the timing done and when i connect the vacuum line to the egr it bucks and doesnt really accelerate and when i plug the...

Need some advice. ... Just installed two sets of Dually LED lights on my JK. Needed to extend the wires a little bit. Used 18 gauge speaker wire i had. Is this safe for this application ? The lines use a 15 AMP fuse. Thanks in advance for your help.

The parking break wire in my TJ is becoming incredibly lose. I'm hoping to avoid going to a repair shop 1) to save money 2) get some more experience working on the Jeep. Anybody know how I can fix this at home?

Just bought a 2001 Wrangler on Friday and have been doing some work on it over the weekend. Tonight I found a loose wire and connection point under the left dash -- I'm assuming they go together, but when I try to connect they don't seem to. I attached pictures. Am I doing something wrong or...

while washing my yj one of my wires burnt up. It is a Bl/YL wire that runs in a harness along the drivers side of the car, all the way to the back. It is grounded right to the left of where your knee would be if you were sitting in the car. Im not sure how this happened, a tiny bit of a pink...

I'm not all that knowledgeable when it comes to this stuff, but i thought i would give it a shot anyway. I have a 10 inch pioneer subwoofer and jl 500/1 amp that i would like to add in my wrangler. i have power going to the amp, but i cant get any sound from the sub. im fairly certain i have it...

Hey All, Mr. "Break-em, but can't begin to fix em" here, I seem to have a problem with my starter. I have to have someone crank it while i pull the wire back into place. It would seem the noted piece is broken and loose. I have ordered a new starter. But any ideas to hold it in place until it...

This wire has been unplugged as long as I have known. Any idea what it is for or where it should be plugged in? Its driving me nuts? It sort of sticks out from underneath my center console. It is two wires wrapped in black tape. It also looks like it might be coming from that yellow box...

How have you guys grounded your fog light wires on the Jeep? Just curious because I intend on hooking these up today