Jeep Wrangler Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 273 Results
  1. TJ Technical Discussion
    I purchased and installed this spare tire delete license plate relocation bracket recently and wired up the brake light no problem. My issue is that I don't know how to wire up the license plate light to come on with the head lights. As far as I can tell the only wiring available in that...
  2. JK Technical Discussion
    I hope I'm doing this correctly... this is my first post. Last year I purchased a 2012 JKU Rubicon in Chicago. The previous owner had a Viper security system installed. I don't know if that's relevant, but I think it might be why I'm running into unexpected wiring. I'm trying to replace my...
  3. JK Technical Discussion
    Just received an estimate from my mechanic to replace the engine wiring harness in my 2017 Jeep JK Rubicon Unlimited for $2200. $868 for part, and another $1174 in labor. Rats chewed through some of the wires. 1) Can you repair vs replace? Splicing the wires would be a temporary fix 2) Is...
  4. JK Technical Discussion
    Hey everyone, I've been installing a backup camera on a 2008 Wrangler JK and everything was going smoothly until I was figuring out what wire to connect the red "Reverse Power Anode Output" wire to. So far I've mounted the camera and wired the rear red wire to the white/grey reverse trigger...
  5. JK Technical Discussion
    Hello all, ✌. I just purchased a 2015 JKU. I noticed the drivers side door would not prompt the dome lights, the rest of the doors do without issue. After watching a few videos and reading a few posts I decided I must have a bent pin in the connector and set out today to repair that….Only to...
  6. JK Technical Discussion
    Wanna get y’all’s thoughts before I go to replacement few months ago, all the buttons, lights and horn stopped working on my steering wheel. Except for the cruise control. Those buttons did work. No lights though. I disconnected my battery for a few hours and reconnected. Same issue. however...
  7. YJ Technical Discussion
    My Jeep (1990) has been converted to HEI and Nuttered. Theoretically I should only need 5 wires correct? Can I simply cut the wires that lead to the computer and those plugs by the battery and remove them? By cut I mean grab the bundle cut them off at the plug, remove the plugs, trace them to...
  8. JK Technical Discussion
    Hello all, Ive had an issue with my original after market jw speaker clones where the headlight occasionally flickers out. I figured no problem ill just get a new one they're cheap. The problem is the old one had the standard harness plus a triangular shaped harness with 3 wires this seems...
  9. YJ Technical Discussion
    Hey guys, I was wondering how much of the wiring I can actually pull from the bay without causing issues. I have a Weber 36 installed by the previous owner and had dangling wires everywhere that I’m going to remove, but was wondering if the 02 sensor was still needed as it’s still plugged in...
  10. JK Technical Discussion
    I am trying to bypass my fuse panel for my HVAC system and use an in-line fuse instead and I want to know if anyone has any advice on where to tap into the wiring. 2011 2 door sport my HVAC system has no power to the blower motor or the blower motor resistor. While driving, if I turn the vent...
  11. TJ Technical Discussion
    Hi dudes. I would your help to solve my TPS trouble in my jeep. I have an YJ Jeep but with 4.0 TJ 2004 engine with his electronic, so this is an OBD2. I have the code P0121 First I buyed 2 MOPAR OEM TPS on Amazon, but I can´t read any voltaje variant when move the thorttle. I have the next...
  12. JK Technical Discussion
    Been having trouble with my Duracell batteries only lasting 3 years. They have been rated 750 CCA. It was suggested that the stock alternator (160A) doesn't have enough amps to recharge the battery completely, given all the accessories tied to it. Therefore, the battery dies early. See...
  13. JK How To Threads and Videos
    Own a second hand JK (2007). Eventually got around to upgrading headlights. Purchased Audexen JL looking LEDs with DRL. Got everything I should have needed ready. Removed bracket to discover H13 sockets with halogen headlights (I was expecting H4) and seperately wired low beam. Anyone know how...
  14. General Jeep Discussion
    does anyone know if I can take the panel off of the lights to change the bulbs and clean this, also is there anyone in the Triad area of NC that anyone would recommend to help re wiring some of my lights? Thanks for any help
  15. YJ Technical Discussion
    Hi y'all, I have a '95 YJ with the 2.5L 4cyl and I have a short somewhere. I've done quite a lot of isolating: Fuse #9 is the one with the short, but it's the left side where it splits off into wire G5. According to the FSM: G5 maps to pins B2 and C6 on the fuse block bulk head. However...
  16. JK Technical Discussion
    Hi, I bought an abandoned 2015 2dr JK Sport at auction and am trying to figure out what the wiring connector under the passenger seat carpet is for? The airbag light is on, so I took the seat off to investigate - I still haven't figured that out, but I found a grey connector and have no idea...
  17. JK Technical Discussion
    I'm trying to figure out when exactly the split was for early vs late build in regards to the park/turn lamp wiring on the 07 wrangler. Any ideas of a VIN split or perhaps a build month split? Included is a picture of the diagram I was able to find online that calls this out. Hopefully someone...
  18. YJ Technical Discussion
    So I’ve had this intermittent problem where the car will shut off. I’ve replaced all the sensors and relays still same problem. Replaced fuel pump fuel pressure regulator and fuel injectors same problem (fuel pressure is high about 50 psi) when the car is shut off it’ll drop to 30 psi and hold...
  19. JK General Discussion
    Hello, I purchased a set of Xprite's RGB LED headlights, and had no problem installing them as just basic headlights, but I haven't hooked up the RGB controller yet. The power/ground wires, I believe, are supposed to go directly to the battery, but I would prefer to have them on a switch so that...
  20. JK Technical Discussion
    I have mounted but not connected a reverse camera, a front facing camera, and an underbody rear facing camera on my 2016 JKU. I see a reverse camera IN and cameras 2, 3, and 4 but only one power +/- connection. I've watched the Stinger install videos a hundred times and can't seem to figure out...
1-20 of 273 Results
Top