Search Results for ‘wiring’

does anyone know if I can take the panel off of the lights to change the bulbs and clean this, also is there anyone in the Triad area of NC that anyone would recommend to help re wiring some of my lights? Thanks for any help

Hi y'all, I have a '95 YJ with the 2.5L 4cyl and I have a short somewhere. I've done quite a lot of isolating: Fuse #9 is the one with the short, but it's the left side where it splits off into wire G5. According to the FSM: G5 maps to pins B2 and C6 on the fuse block bulk head. However...

Hi, I bought an abandoned 2015 2dr JK Sport at auction and am trying to figure out what the wiring connector under the passenger seat carpet is for? The airbag light is on, so I took the seat off to investigate - I still haven't figured that out, but I found a grey connector and have no idea...

I'm trying to figure out when exactly the split was for early vs late build in regards to the park/turn lamp wiring on the 07 wrangler. Any ideas of a VIN split or perhaps a build month split? Included is a picture of the diagram I was able to find online that calls this out. Hopefully someone...

So I’ve had this intermittent problem where the car will shut off. I’ve replaced all the sensors and relays still same problem. Replaced fuel pump fuel pressure regulator and fuel injectors same problem (fuel pressure is high about 50 psi) when the car is shut off it’ll drop to 30 psi and hold...

Hello, I purchased a set of Xprite's RGB LED headlights, and had no problem installing them as just basic headlights, but I haven't hooked up the RGB controller yet. The power/ground wires, I believe, are supposed to go directly to the battery, but I would prefer to have them on a switch so that...

I have mounted but not connected a reverse camera, a front facing camera, and an underbody rear facing camera on my 2016 JKU. I see a reverse camera IN and cameras 2, 3, and 4 but only one power +/- connection. I've watched the Stinger install videos a hundred times and can't seem to figure out...

Hey im a 16 yo kid that was working on a clutch swap for our 2011 jeep wrangler and in the proccess I accidentally pulled out 3 wires on the transmission wiring harness on clip #5 on the left side of the transmission and I just need to know what order they go back in the clip. the colors of the...

Hey All, I was looking behind the steering wheel kick panel in plans of routing cables through the firewall, and I stumbled upon a random plug in the wiring harness that doesn't have anything connected to it. The plug only has about 2-3" of length before it is connected to the wiring harness...

I'm installing a CDE-170 radio I have never before done any wiring myself before so I need a little help. So right now I am fairly sure how to wire up everything except the red and the yellow wires here. The red splices into another red wire and connects into a slot on the fuse box that says...

Hi all. I have an export-spec JKU (RHD) that I want to hitch to my new trailer. The trailer has the EU-style round plug connector, and I have installed the Mopar 7-way trailer harness (82210214AB), with a converter adapter in the trailer that was supposed to convert all signals and separate the...

I know this particular subject has been hammered into the ground. What I have come up against is a previous owner who did not know how to wire an aftermarket radio. As the title states, I have a 2014 JKU. The jeep does not have a factory amplifier or sub but does have the small tweeter pods on...

Hi all, I have a 2022 JLUS with stock halogen bulbs. I’ve replaced every bulb with LED bulbs (front turn signal/DRL, fog lights, headlights, rear tail light/brake light/turn signal and reverse lights). All four turn signals have resistors installed (one end to ground and the other to the turn...

The E-Brake warning light in my 2001 Wrangler SE turns on when I honk the horn. This has happened on multiple occasions but I never thought anything of it because it still works. Nobody else that I’ve seen has had this problem so I figured I’d bring my issues here. Also the E-Brake light stays...

Hi all, I have a 2022 JLUS and I’m trying to do a clean install of a new dashcam (hide all cables and wires) and use the 12V DC outlet to power it. I can’t seem to find any videos or Info on how to remove the A pillar trim/cover to run the cable through it. It looks like I have to remove the...

Hey everyone, I'm having an issue with my break pedal switch wiring and I am out of simple solutions aside from taking it to a shop. When you press the break pedal, not only do the tail lights illuminate but so do both of the front turn signal lights! In addition, both of the blinker lights on...

My TJ Saga continues: I have thrown in the towel on trying to do the transmission wiring harness myself, there are too many ends/connectors missing, wires frayed, etc. etc. I was wondering if anyone knew of any shops in my area that would be able to help me. A TLDR on it, I traded for my TJ, and...

Hey all, My TJ saga continues......... So, in the process of trading to get this TJ, I found out after the trade was set in stone that the Jeep was an auto to manual swap. Now, This transmission is almost certainly going to need a new wiring harness, connectors missing, wires cut, etc. etc...

Hey y’all. I’ve got a ‘95 YJ that I’ve had for about 2 years now. Recently my right turn signal stopped working and I’m not sure why. Initially the right signal on the indicator panel would just stay solid when I turned it on, but none of the lights (front, rear, and side) would flash. I...

Got a 94 YJ 2.5L. I bought the Jeep without radio, just a hole in the dash. My winter project is to do some work under the dashboard. While I had it open, wanted to replace the radio and speakers. Bought some Polk Audio DB462 DB+ Series 4"x6" Coaxial Speakers with Marine Certification, Black...