Jeep Wrangler Forum banner

1 - 2 of 2 Posts

·
Premium Member
Joined
·
1,060 Posts
Discussion Starter #1
I don't like the idea of hanging a 7 way trailer connector under the bumper - it then becomes the first point of impact on departure angles. I do rock climb some, and that seems like an obvious vulnerability. I've seen where people with stock bumpers notch out the bumper and flush mount the connector right into the bumper.

Has anyone here tried that w/ the 10A/HR bumper? I'm not sure if there is space and/or access to be able to do that.

Thoughts?
 

·
Registered
Joined
·
10,180 Posts
I don't know if such would be too far off center, but the inserts on each side (the driver's side has the "Jeep") are made of plastic. It might be easier to install a 7pin trailer plug into one of those.
 
1 - 2 of 2 Posts
Top