Jeep Wrangler Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
Installed my new to me 730n RHR in my 2014 jku today and have questions about a extra wire. I had a 130s res with uconnect I bought a 730n rhr and a uconnect by pass wiring kit. There was a 10 pin connector in the back of the 130 which I disconnected and I assume just lays in the dash not connected to anything? I connected the by pass kit large connector from the uconnect to the back of the 730n via the 10 connector. Is this correct? Pic below. Also for some reason the 730 doesn't come on when the jeep is started you have to manually turn the radio on each time as well as push the accept button. Is there a way to make it come on when the jeep is started?
 

Attachments

1 - 1 of 1 Posts
Top