Jeep Wrangler Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
104 Posts
Discussion Starter #1
Im building the harness for a "no cut" installation of the KTP-4553u behind my factory HU. I've read, and searched for hours, perhaps I'm not searching correctly but other than knowing that I have to add 2 new wires to #2 and #13, I can't find any details. I haven't been able to find a pin out for the 70-6522, so I could use some help identifying where to add them. I also can't figure out which wires I need to connect them to out of the 71-6522. Any help would be greatly appreciated!
 

·
Registered
Joined
·
104 Posts
Discussion Starter #2
Figured out which pins were needed, and for anyone who sees this in the future... if you are working on a 2017, you actually need to add wires to #1 an #13.

I went to Best Buy to purchase a Metra harness (needed those extra wires and Amazon only shipped 1 of the 2 that I ordered). The guy there was very helpful, even printed out a diagram and list from All Data for me. Difficult to describe, so if anyone needs help, PM me and I'd be happy to help.

Chris
 
1 - 2 of 2 Posts
Top