Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!
1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hey guys! I have a 2000 wrangler 6 cylinder and I'm asking for help!! All of a sudden my jeep started to idle real rough and it starts to shake and studder mid drive and sometimes stalls.

It drives fine then it starts to lose power and start to shake and jump and after a little while it picks up power and runs fine for a couple minutes and then it loses power again

I changed the spark plug, crankshaft sensor and the tps. This is my last ditch effort before I take it to the shop, is there anyone that can help me figure this out so I can save some money and do it myself?!?!? ???????? Thanks guys!!
 

·
Registered
Joined
·
723 Posts
Come to think of I heard some rattling around there, you think that might be a sign I need to replace it?
If the rattling is from the inside the baffling may have become dislodged and is clogging it. Take it to a muffler shop and check with them. If it's high mileage it might be the issue.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #5 ·
Come to think of I heard some rattling around there, you think that might be a sign I need to replace it?
If the rattling is from the inside the baffling may have become dislodged and is clogging it. Take it to a muffler shop and check with them. If it's high mileage it might be the issue.
It's got 147k on it, yea I'm going to try and take it to get checked out I'm a first time wrangler owner and I'm still trying to learn more about it... thanks for the advice!
 

·
Registered
Joined
·
117 Posts
Before you do that, is it pulling any codes?
Could be a misfire still after you changed the plugs and sensors and it could be your coil pack.
 
1 - 6 of 6 Posts
Top