Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 4 of 4 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
HI,
I have 2011 JKU.

I bought 2din gps navigation with built in canbus.

it has 3 wires for canbus for steering control:
black for ground
steering wheel 1 wire
steering wheel 2 wire

I have install this and everything works except controlling the steering wheel function because I dont know where to connect those 3 wires.
the stereo came with matching harness.

I have looked for the car harness diagram to find those canbus wires but cannot find any.
Please help....
 

·
Registered
Joined
·
761 Posts
HI,
I have 2011 JKU.

I bought 2din gps navigation with built in canbus.

it has 3 wires for canbus for steering control:
black for ground
steering wheel 1 wire
steering wheel 2 wire

I have install this and everything works except controlling the steering wheel function because I dont know where to connect those 3 wires.
the stereo came with matching harness.

I have looked for the car harness diagram to find those canbus wires but cannot find any.
Please help....
If your Nav unit is aftermarket, you need an adapter to make it work with the CanBus and steering wheel controls. PAC makes one.
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #3 ·
yes I know.
but I dont need that.
again this system comes with the harness and canbus controller.

the only thing I need to do is to find the car's canbus wires in the harness and attached those wires to it.

I just need the schematics for the car harness and the wire colors and etc...


Please anyone has the picture or the schematics?

thanks
 
1 - 4 of 4 Posts
Top