Jeep Wrangler Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,900 Posts
Discussion Starter #1
I want to increase the separation between my drag link and tie rod. Have slight rub between the two "the attenuator bellow to be exact". "yeti setup no lift" I'm about 1/4" low in front/rear due to added weight. I'm thinking 3/4" lift to 1" would make the difference. I'm a 2 door with 14 and 56 stock springs. I was thinking of increasing the springs to new mopar front 16-17 and rear 58-59 or just add some 3/4" synergy spacers. Trying not to screw up my geometry regarding off centering the axles and the changing the angle much on the lower control arms in the front. Would love some firmer springs, but I have a real good ride so, would just like to get rid of this rub mainly and a little more front travel couldn't hurt. What would be the best way to accomplish this?
 
1 - 3 of 3 Posts
Top