Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 4 of 4 Posts

·
Registered
Joined
·
504 Posts
Discussion Starter · #1 ·
Hi everyone! Just purchased a 95 wrangler 2.5-4 speed, all stock. Messing around i installed a new 4 wheel drive indicator light switch(was always on), but still the light does not go out when in 2 wheel drive and the front driveshaft still turns.I took off both vacuum lines to the actuator on the front axle and the light went out and the front driveshaft stopped turning. Put everything back and still the same thing. All i want is the light to go out when in 2wheel drive and the front axle not to spin like it`s suppose to. The 4 wheel drive seems to work good. Any ideas would be helpful. Thanks.:banghead:
 

·
Registered
Joined
·
504 Posts
Discussion Starter · #4 ·
Thanks fellas!
 
1 - 4 of 4 Posts
Top