Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 5 of 5 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Air bleed line is just flopping around, cant build any pressure in the cylinder. Can that fitting be reached without pulling the tranny?
Thanks, Jim
 

·
Registered
Joined
·
1,272 Posts
simple answer, no , you can't reach it without removing the tranny but,
the line isn't a tight fit, just an o ring and a clip, it will move. is the slave cylinder leaking fluid?
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
Master cylinder was almost empty. No oil on the ground, just a little bit under the clutch pedal on the floor mat. Did a bleed and filled the Master 3 times with no change in pressure.
 

·
Registered
Joined
·
1,727 Posts
Sounds like a bad clutch master cylinder, you shouldnt have fluid inside the vehicle.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #5 ·
roadyrob...you saved me a big bunch of work. Pulled the line off of the Master, flushed it, plugged it, filled it. Built pressure. Hooked it all back up, bled it, so far so good. Thanks.
 
1 - 5 of 5 Posts
Top