Jeep Wrangler Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Okay so heres the deal

I installed my new front drive shaft the other day and the 4x4 worked i went and did a lil off roading with it and it worked fine.

so when i was done I took it out of 4 wheel drive, and when i tried to put it back in and it does not work anymore...??

my front wheels wont enguage/turn, but the drive shaft to the front diff is turning when I select 4 wheel drive with the transfer case ...

does any one know what the problem can be

thanks

mark
 

·
Registered
Joined
·
27 Posts
i dont know about your model but mine has a system the engages the front axels using a vac system so you might want to check that.
 

·
Registered
Joined
·
27 Posts
not a problem, you want to make sure that all lines and wires are connected and that you have power going to the switch and check for other vac leaks that could be cause you to lose pressure
 
1 - 8 of 8 Posts
Top